SLINGER DC6V Wireless Remote Control User Manual
- June 15, 2024
- Slinger
Table of Contents
DC6V Wireless Remote Control
User
instruction
The remote controller being tested is the modulation ASK working mode with a frequency of 433.92mhz; two buttons; the remote controller is powered by DC6V (CR2016*2), and the corresponding device is controlled by RF.
- Frequency: 433.92mhz
- Working voltage：6V
- Working current：4mA±1mA
- Static current：0uA
- Code：EV1527 Main IC:U1
- Coding Bandwidth：330us
- Oscillation resistance:R2
- Key value：Locked 0010、Unlocked 0001
- Distance：28m
- Model: JJ-RC-F8A-AD21
- Name: Remote control
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
WARNING: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
The device must not be co-located or operating in conjunction with any other
antenna or transmitter.
Industry Canada statement:
This device complies with ISED’s licence-exempt RSSs. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
– Instructions for use:
Press the corresponding button, the LED will light up, and the corresponding
RF code will be sent at the same time. Let go and the RF transmission will be
disconnected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>