CISCO LDK0615C2718 Collaboration Series Wireless LAN Instruction Manual

: June 15, 2024
: Cisco

Table of Contents

CISCO LDK0615C2718 Collaboration Series Wireless LAN
National Restrictions
For IC (Canada) Interference Statement
Scope
EMC Class A declaration
Safety Instructions – Warnings
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

CISCO LDK0615C2718 Collaboration Series Wireless LAN

National Restrictions

This section identifies countries that have additional requirements or restrictions.

For FCC (US)
Modification Statement (§15.21)Changes or modifications to the equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Compliance Statement (§15.19)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Class A Interference Statement (§15.105a)
This equipment has been tested and found to comply with the limits for a Class A digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used by the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

For IC (Canada) Interference Statement

(RSS-GEN, Section 8.4)
This Device complies with Industry Canada License-exempt RSS standard(s). Operation is subject to the following two conditions: (1) the device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device. 5150-5250MHz is limited to use indoors only.

Exposure statement (§2.1091) (US, Canada)
To comply with FCC/IC RF exposure limits for general population / uncontrolled exposure, the antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be
co-located or operating in conjunction with any other antenna or transmitter.

Directive 2014/53/EU
Compliance Information for the Cisco Collaboration series Wireless LAN products.

Scope

The information in this document applies to the Cisco Collaboration series wireless LAN products that currently include the DX series, Room series and Cisco Spark Board. These products are intended to be placed on the market within the European Union, Lichtenstein, Switzerland, Iceland, Norway, Turkey and other countries that have implemented the EU Directive 2014/53/EU.

Simplified EU Declaration of Conformity
This declaration is only valid for configurations (combinations of software, firmware and hardware) provided and/or supported by Cisco Systems for use within the EU or countries that have implemented the EU Directives and/ or spectrum regulation. The use of software or firmware not supported/provided by Cisco Systems may result that the equipment is no longer compliant with the regulatory requirements.

This equipment complies with the essential requirements and other relevant provisions of Directive 2014/53/ЕU.

Note: The full declaration of conformity for these products can be found:
Cisco Room Kit: https://www.cisco.com/web/dofc/11580633.pdf
Cisco Room Kit Mini: http://www.cisco.com/web/dofc/15708585.pdf
Cisco Codec Plus: https://www.cisco.com/web/dofc/11580590.pdf
Cisco Codec Pro: http://www.cisco.com/web/dofc/13510636.pdf
Cisco Codec EQ: http://www.cisco.com/web/dofc/EU90135.pdf
Cisco Room 55: https://www.cisco.com/web/dofc/11676060.pdf
Cisco Room 55 Dual: http://www.cisco.com/web/dofc/14982501.pdf
Cisco Room 70: http://www.cisco.com/web/dofc/11889510.pdf
Cisco Room 70 G2: http://www.cisco.com/web/dofc/15041520.pdf
Cisco Room 70 Panorama: http://www.cisco.com/web/dofc/15041520.pdf
Cisco Room Panorama: http://www.cisco.com/web/dofc/13510636.pdf
Cisco Board 55: https://www.cisco.com/web/dofc/11530677.pdf
Cisco Board 55S: http://www.cisco.com/web/dofc/15570334.pdf
Cisco Board 70: https://www.cisco.com/web/dofc/11653359.pdf
Cisco Board 70S: http://www.cisco.com/web/dofc/15570336.pdf
Cisco Board 85: http://www.cisco.com/web/dofc/15612170.pdf
Cisco Desk Pro: https://www.cisco.com/web/dofc/18745436.pdf
Cisco Room Bar: http://www.cisco.com/web/dofc/22921945.pdf
Contains FCC ID: LDK073002357
Contains IC ID: 2461N-073002357
Cisco Board Pro 55: http://www.cisco.com/web/dofc/22241423.pdf
WiFi/BT contains FCC ID: LDKNVTX21737and contains IC ID: 2461N-NVTX2173724GHz (radar)
FCC ID: LDK603102338 andIC ID: 2461N-603102338
Cisco Board Pro 75: http://www.cisco.com/web/dofc/22540558.pdf WiFi/BT contains
FCC ID: LDKNVTX21737and contains IC ID: 2461N-NVTX21737 24GHz (radar)
FCC ID: LDK603202337 and IC ID: 2461N-603202337
A Cisco.com login is required to access these documents. You can register for a Cisco.com account if you don’t have one

EMC Class A declaration

WARNING
This is a class-A product. In a domestic environment, this product may cause radio interference in which case the user may be required to take adequate measures.

Art. 5th – Resolution
This equipment is not entitled to protection from harmful interference and may not cause interference with duly authorized systems. Cisco and the Cisco logo are trademarks or registered On our website you will find an overview of the worldwide Cisco contacts.
Go to: https://www.cisco.com/web/siteassets/contacts
Corporate Headquarters
Cisco Systems, Inc.
170 West Tasman Dr.
San Jose, CA 95134 USA

Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL: www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company. (1110R)

Where to Find Product
Documentation

Product Information
https://help.webex.com
https://www.cisco.com/go/telepresence/docs

Warranty Information
https://www.cisco.com/go/warranty
Regulatory, Compliance, and Safety

Information
https://www.cisco.com/go/telepresence/docs
End User License Agreement and License

Information
https://www.cisco.com/go/eula
https://www.cisco.com/go/license

Antennas
The device has integrated antennas which
cannot be replaced.

Radio Channels
The phones use World Mode (802.11d) to determine operating channels and transmit powers.

Intended Use
This product is a collaboration endpoint for use primarily in an office environment. For indoor use only.

Installation
Minimum separation distance: 20cm/7.9in

Safety Instructions – Warnings

Read the installation instructions before using, installing or connecting the system to the power source. Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Ultimate disposal of this product should be handled according to all national laws and regulations. No user-serviceable parts inside. To avoid the risk of electric shock, do not open. Installation of the equipment must comply with local and national electrical codes.