LETEUKE NSF 2 Tier Utility Cart with Wheels User Manual
- June 15, 2024
- LETEUKE
Table of Contents
USER MANUAL
NSF UTILITY CART 452539 INCH
IMPORTANT NOTICE
Dear customer:
If you receive a product with missing or damaged parts, or if you have any
questions about the product, please contact Leteuke’s customer service mailbox
for feedback, and we will give you a satisfactory solution.
We are very sorry for the possible inconvenience and thank you for your
understanding and support.
You can contact us in any of the following ways:
- Leteuke official website email: support@ileteuke.com
- Leteuke customer service mailbox: shmr_cs@showmorr.com
Contact us on Amazon: From your Amazon order details page, select “Order” >>
“Sold by” >> “Contact seller”.
Leteuke wishes you a happy life.
ASSEMBLY INSTRUCTIONS
HEAVY DUTY UTILITY CART – 2-TIER
Parts Table
- Please inspect the box contents to ensure you have received all components.
- For best results, assemble on flat ground.
- Keep small parts such as clip pieces and screws out of the reach of children.
REQUIRE 2 PERSONS TO ASSEMBLY
Note: The black circular plastic tops in-between the shelves are used only for packaging purposes. They are NOT NEEDED. Please discard.
Children are NOT ALLOWED to climb!
Important Notes
The arrows on the clip sleeves should be pointed UPWARD. 
Align the flange to the groove. 
Warm Tips:
As shown in the figure, when fixed to the pole, the multiple gaps between the
two clip sleeves are a normal phenomenon, NOT a quality problem.
This is aimed to fit the shelf firmly into the pole.
Recommend:
You can use a rubber mallet (NOT included) to hit hard along the edges of the
shelf. Please make sure it is completely fixed onto the pole.
6. Load Bearing Range:
Static (With Leveling Feet):
650 LBS (Total); 250 LBS (Solid Steel Shelf), 400 LBS (Wire Shelf)
Static & Dynamic (With Wheels):
650 LBS (Total); 250 LBS (Solid Steel Shelf), 400 LBS (Wire Shelf)
**** Recommended to use the utility cart in sunny weather, not in wet and rainy weather for a long time. Wipe clean after use. (For Outdoor Use)
Installation Steps
-
Screw each stem of Wheel (A, B) into the bottom of each Pole (C), and turn each wheel clock-wise until in the desired location.
Needs to be tightened with a wrench finally. Repeat for all Pole (C).
-
Snap the Clip Sleeves (D) to the lowest groove on Poles (C) with the arrow pointing up. Make sure that the heights are identical for each Pole (C).
-
Assemble the Wire Shelf (E) through the top of the 4 poles and Clip Sleeves (D).
NOTICE:
The 2 poles with brake wheels must be on the same narrow side of the shelf.
-
Assemble 2 Clip Sleeves (D) on the Poles (C) at the narrow side of the cart (the same side as wheels with brake). And then slide the handle (F) onto the Clip Sleeves (D). Leave space at the top of the Poles (C) for the Solid Steel Shelf (G).
-
Repeat steps 2-3 to assemble the Solid Steel Shelf (G).
The position of the Solid Steel Shelf (G) / Wire Shelf (E) can be adjusted at will.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>