SOKPLY A Series LED Explosion Proof Light Installation Guide
- June 15, 2024
- Sokply
Table of Contents
SOKPLY A Series LED Explosion Proof Light Installation Guide
Installation Instructions
Important
READ INSTRUCTIONS CAREFULLY BEFORE INSTALLING. KEEP THIS INSTRUCTIONS FOR FUTURE REFERENCE.
Fixtures must be wired in accordance with the National electrical code and all applicable local codes. Proper grounding is required for safety.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A QUALIFIED ELECTRICIAN WHO IS FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Risk of fire or electric shock. High bay Light installation
requires knowledge of luminaires and electrical systems. If not qualified, DO
NOT try to install. Please contact an electrician.
WARNING : Risk of fire or electric shock. Suitable for wet locations.
Make sure the power is off permier to install.
WARNING : Risk of fire or electric shock. Suitable for non-insulated
surface and frame.DO NOT cover fixture with insulation liner or similar
material.
WARNING : DO NOT install in unstable, loose or breakable surfaces.
WARNING : DO NOT let objects impact or exert force on the surface of the
fixture.
Installation and Electrical Connection
WARNING
RISK OF FIRE,ELECTRIC SHOCK OR PERSONAL INJURY
Before installation, urn power off.
- Take the fixture and accessory out from cartoon box, 2 tighten 2x angle holder screw as **Fig.1.
**
-
Flexible metal conduit install and tighten with the fixture.
-
Drill 2x holeas Fig. 2, the distance can be 91-140mm, fixingØ10 expansion screws and bracket on ceiling.
-
Connect the AC cable to power supply, black to L, white to N, green to G, purple to Dim+, pink to Dim-
The specific steps of installation (Wall mounted)
- Take the fixture and accessory out from cartoon box, tighten 2x angle holder screw as **Fig. 1.
**
-
Flexible metal conduit install and tighten with the fixture.
-
Drill 2xhole as Fig. 2, the distance can be 91-140mm, fixing 10 expansion screws and bracket on wall.
-
Connect the AC cable to power supply, black to L. white to N, green to G, purple to Dim, pink to Dim-
The specific steps of installation (Pole mounted)
-
Take the fixture and pole accessory out from cartoon box, tighten pole as Fig. 1. (Linear pole)
-
Connect the AC cable to power supply, black to L white to N, green to G, purple to Dim, pink to Dim-
-
Install the installation box to the wall or celling as Fig.2. Tighten the pole to the box, and adjust the chain of balance.
-
Install the fixture to the pole after cable connecting.