Danfoss Icon 2/ 24V RT Room Thermostat User Guide
- June 4, 2024
- Danfoss
Table of Contents
Danfoss Icon 2/ 24V RT Room Thermostat User Guide
Wake up the thermostat
Touch the screen – the actual room temperature is displayed (fig. A). The
Heating icon is displayed if the heat is on, and the Cooling icon is displayed
if the cooling is on. The screen turns of after 10 seconds.
Set the temperature
Wake up the thermostat. Touch or to set the temperature (temperature flashes to indicate setting in progress). Touch to conrm the new setting.
Open the Settings menu
Wake up the thermostat. Touch and hold to open the menu (fig. B). Toggle
the menu with or , conrm with . Touch to go backwards in the menu.
Menus
: Temperature limitation, i.e. allowed setting range for room temperature.
: Product ID – your product can be identified with this code.
: Perform Link Test, if the thermostat has been moved. Check the signal, a
result of 80 % or more equals ”strong connection”.
: Set min. and max. temperature of the floor surface (the menu is only
displayed, if your thermostat has a floor sensor).
Note! Menus 4, 6 and 7 are only available to the installer.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>