ADLER EUROPE AD 7432 Cosy Foot Warmer Electric Foot Heater User Manual
- June 15, 2024
- ADLER EUROPE
Table of Contents
ADLER EUROPE AD 7432 Cosy Foot Warmer Electric Foot Heater User Manual
PLEASE READ CAREFULLY. IMPORTANT INSTRUCTIONS, KEEP FOR LATER USE.
-
Read the operating manual before using the device and follow the instructions contained in it. The manufacturer is not liable for damage caused by using the device against its intended use or improper handling.
-
The device is for home use only. Do not use for other purposes that are not in accordance with its intended use.
-
Connect the device only to a 220-240 V ~ 50 Hz. In order to increase the safety of use, do not switch on many electrical devices simultaneously to one circuit.
-
Be extra cautious when using the device when children are nearby. Do not allow children to play with the device, do not let children or persons not familiar with the device use it. The equipment should not be used by young children, unless the controllers have been pre-set by parents or guardians, or children have been thoroughly instructed how to safely handle the regulators.
Children under three years of age cannot use this device due to the lack of response to overheating. -
WARNING: This equipment may be used by children over 8 years of age and persons with limited physical, sensory or mental abilities, or persons who have no experience or knowledge of the equipment, ifthis is done under the supervision of a person responsible for their safety or given to them tips on the safe use of the device and are aware of the dangers associated with its use.
Children should not play with the equipment. Cleaning and maintenance of the device should not be performed by children unless they are over 8 years of age and are supervised. This device cannot be used by people who are not heat sensitive, and people who are very sensitive to heat, who are unable to respond to overheating and by people who require constant care. -
Always after use, remove the plug from the socket by holding the socket with your hand.
DO NOT pull on the power cord. -
Do not immerse the cable, plug and the entire device in water or other liquid. Do not expose the device to atmospheric conditions (rain, sun, etc.) or do not use in conditions of high humidity (bathrooms, damp camping houses).
-
Periodically check the condition of the power cord. If the power cord is damaged, it should be replaced by a specialist repair facility in order to avoid a hazard.
-
Do not use the device with a damaged power cord or the device is not working properly.
Do not repair the device yourself, as it may cause shock. Please return the defective device to the appropriate service centre for inspection or repair. All repairs may only be carried out by authorized service points. Incorrectly performed repair can cause serious danger to the user. -
Do not use the device near flammable materials.
-
Do not leave the device or the adapter connected to the outlet unattended.
-
To provide additional protection, it is advisable to install a residual current device (RCD) with a rated residual current not exceeding 30 mA in the electrical circuit. In this regard, please contact an electrician.
-
Do not allow the device or adapter to get wet. If the device falls into the water, immediately pull the plug or adapter from the power socket. Do not put your hands into water when the device is connected to the mains. Before re-use, it must be checked by a qualified electrician.
-
Do not handle the device or adapter with wet hands.
-
The device should be turned off every time you put it down.
-
Do not use the device near water, for example: in the shower, in the bathtub or above the basin with water.
-
If the device uses a power supply, do not cover it, as it could lead to a dangerous increase in temperature and damage to the device. Always, first insert the plug into the power socket in the device and then the power supply to the mains socket.
-
Do not use the device in folded condition. Do not put pins, needles and other metal objects in the sheet.
-
Do not use the device if it is wet or damp. Leave the device hung loosely in a ventilated area until it is completely dry.
-
Do not put the power cord on a warmed device. Do not fold the equipment when it is placed on top during storage. Check the equipment periodically for signs of wear or damage.
If such signs or equipment are used improperly, please contact your supplier before continuing to use it. -
Store in a dry place. Never put heavy objects on the device.
-
Never go to sleep with turned on device. Unplug the power plug from the outlet.
-
Never cover the controller.
-
Before switching on the device, make sure that it is evenly distributed, there are no kinks or folds.
-
Do not iron the device!
-
This equipment is not intended for medical use in hospitals.
-
The device should cool down before storage.
-
The device may be used only with the types of removable elements specified in the equipment marking.
-
The device is equipped with a fuse protecting against overheating, which should not work when used in accordance with the intended use of the equipment. If the fuse trips, the device will stop working, the equipment must be returned to the manufacturer or its representative for repair
SYMBOL EXPLANATION (picture 2)
- Read the instructions for use.
- Do not bleach.
- Do not tumble dry.
- Only parts of the product indicated in the instructions can be ironed at a temperature of up to 110°C.
- Do not dry clean
- Do not insert pins
- Do not wash foot warmer’s outside coating by immersing in water.
- Do not use folded or rucked.
- Product not to be used by very young children (0-3 years).
- ONLY the parts of the product listed in the manual can be hand washed in water. Recommended water temperature 40°C.
- Do not use the device near water, for example: in the shower, in the bathtub or above the basin with water.
SAFETY NOTES BEFORE FIRST USE
- Do not use with any other heating device.
- During use, make sure that the mains cables do not become trapped / tangled.
- Make sure you do not fall asleep while in use. If you get very tired during use, please select temperature level 1 for safety. The device will automatically turn off 90 minutes after it is turned on.
- The product may only be used with the controller specified in the device designation: RA-1 / K15.
- The device should not be used to heat animals.
- Shoes and slippers must be removed before use!
PRODUCT DESCRIPTION (photo 1)
- The outer shell of the foot warmer with heating elements.
- Inner removable synthetic wool lining.
- Driver
- LED display
- Power switch
- Temperature button
- Power cord socket sewn into the outer shell
- Detachable power cord plug
- Locking latch
USE
- Make sure there is a power source nearby and that the power cord is not in a position when in use where you might trip over it. After connecting to the power supply, the controller (3) must be easily accessible to the user.
- Move the power switch (5) from the OFF position to the ON position. Before use, set the heat to the highest level of 4 for 10 minutes.
- By pressing the temperature button (6) again, select the temperature level:
- the lowest level with a temperature of 40°C +/- 5°C
- the next level with a temperature of 50°C +/- 5°C
- the next level with a temperature of 64°C +/- 5°C
- the highest level with a temperature of 75°C +/- 5°C. When using the device, select the appropriate temperature level according to how the human body feels. If you intend to use it for a long time, set it to level 1 which is the lowest position to avoid overheating which may cause discomfort to the human body. The appliance has an auto-off feature that turns it off after 90 minutes.
- Slide the Power Switch (5) from ON – turned on to OFF – turned off to turn the device off when you stop using it. Remove the plug from the wall socket.
CLEANING AND MAINTENANCE
- When the device is not in use and before cleaning, disconnect the device from the mains and let it cool down.
- To clean, disconnect the power cord with the controller (3) from the outer shell of the foot warmer (1), proceeding as follows:
- slightly lift the locking latch (9) on the detachable plug (8) with your hand and pull it firmly with your other hand from the cord socket (7) with your other hand. Do not pull on the cord.
- Clean the cord surface with neutral detergent, if the cord is dirty, and dry it with a soft cloth.
- Do not dry-wash the foot warmer as this may damage the heating elements.
- The outer shell of the foot warmer with heating elements (1) and the removable inner lining made of synthetic wool (2) can be washed by hand or on a delicate program in the washing machine. The recommended water temperature is 40 ° C. Use a mild detergent. Do not use industrial solvents such as benzene, kerosene or similar solvents for cleaning.
- The insulation of the foot warmer will be damaged if the outer shell of the foot warmer with heating elements (1) is dried in the sun, ironed or mothproofing is used. Damage to the insulating material will cause a safety problem.
- Hang the foot warmer in a ventilated place to let it dry naturally. Make sure the device is completely dry before folding and packing or re-using it.
- ONLY the removable inner lining made of synthetic wool (2) can be ironed up to 110°C.
- If the power cord or controller is damaged, do not open or try to repair them as they must be serviced by a qualified person.
STORAGE
- When the device is not used for a long time, allow it to cool down before folding it.
- Store them in a cool and dry place.
- Make sure the device is dry before assembling and packing.
- Do not use mothballs on the foot warmer.
- Do not bend the device by placing other objects on it during storage.
TECHNICAL DATA
Nominal power consumption: 100W
Supply voltage: 220-240V ~50Hz
Dimensions: 31 x 29 x 25cm
To protect your environment: please separate carton boxes and plastic
bags and dispose them in corresponding waste bins.
Used appliance should be delivered to the dedicated collecting points due to
hazardous components, which may effect the environment. Do not dispose this
appliance in the common waste bin.
If you want to buy spare parts or make any complaints, please contact the seller who issued the receipt directly.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>