SKODA 763R Jump Starter Power Bank User Guide
- June 15, 2024
- SKODA
Table of Contents
SKODA 763R Jump Starter Power Bank
Jump Starter Powerbank
Kit contents
Parts list|
---|---
Part name| Quantity| Position
Powerbank| 1| A
Connecting cable| 1| B
USB cable| 1| C
Adapter| 8| D
Mains adapter| 1| E
Charging adapter 12 V| 1| F
Jump starter adapter with clamps| 1| G
User manual MINIBATT| 1|
User manual ŠKODA| 1|
Technical specifications
- Dimensions: 224x87x29mm
- Weight: 610g
- Battery capacity: 20 000mAh (74Wh)
- Output: 5V 1A; 5V 2A; 12V 10 A; 19V 3,5A
- Input: 15V 1A
- Total charging time: 8 hours (using the mains adapter)
- Starting current: 300A
- Maximum current: 600A
- Operating temperature: -20 ºC ~ 60 ºC
User manual Indicator
- Push the switch to check the battery charge level.
- Indicator 1 2 3 4
- Battery charge level 25% 50% 75% 100%
Powerbank charging instructions
Fig. 1
- Plug the mains adapter (E) into a 230V mains socket.
- Connect the mains adapter to the 15V / 1A input port.
Fig. 2
- Plug the 12V charging adapter (F) into the vehicle’s 12V socket.
- Connect the 12V charging adapter to the 15V / 1A input port.
- While the power bank is charging, the corresponding indicator flashes according to the battery status. After charging the power bank to 100%, all indicators go out.
Emergency starting of the vehicle
- Connect the jump starter adapter with clamps to the power bank. The device test is started and the LCD shows the power-bank voltage.
- Connect the red terminal to the positive (+) pole of the battery, and connect the black terminal to the ground point according to the vehicle user manual.
- The adapter tests the voltage and condition of the vehicle battery and shows the data on the display.
Follow the instructions on the LCD
- When JUMP START READY appears on the LCD, it means the connection is correct and the circuit is working. You can attempt to start the engine.
- When CLAMPS REVERSED appears on the LCD, an alarm sounds to indicate an incorrect connection. Connect the clamps correctly. The LCD shows JUMP START READY, then start the engine.
- When the PRESS BOOST BUTTON appears on the LCD, an alarm sounds, which means that the vehicle battery voltage is too low. Press the “BOOST” button until JUMP START READY appears on the LCD, then start the engine within 30 seconds.
- If no vehicle battery data is displayed on the LCD, the alarm does not sound, which means that the vehicle battery is discharged or removed; check that the terminals are connected correctly, press the “BOOST” button until “JUMP START READY” lights up and then start the engine within 30 seconds.
- After starting the vehicle, disconnect both clamps and let the engine run.
Charging mobile phones or tablets
- Connect the USB cable (C) to the USB 5V/2A or USB 5V/1A output port.
- Connect the other end of the USB cable to the mobile phone (Fig. 1) or the tablet (Fig. 2).
- Push the switch to start charging.
Charging 19V electronic equipment, e.g. laptops
- Connect the connecting cable (B) to the USB 19V / 3.5A output port.
- Select the appropriate adapter for the notebook and connect it to the cable (B) and the notebook.
- Push the switch to start charging.
Charging 12V electronic equipment
- Connect the 12V vehicle accessory cable to the 12V/10A output port.
- Push the switch to start charging.
LED light
- Press the switch for 3 seconds to turn on the LED light.
- When pressing the switch slightly, you can toggle between 4 modes of the LED light in the following order: normal, strobe, emergency, and off.
Caution
-
Only for vehicles with a voltage of 12V, there is a risk for others. It is forbidden to use for other machines, such as aircraft, ships, etc.
-
Do not connect the (-) terminal to the vehicle battery but to the ground point defined in your vehicle user manual.
-
Do not touch any metal parts of the jump starter adapter clamps.
-
Before an emergency starts using the power bank, check
that all battery connections are clean! Make sure the adapter clamps are connected correctly! If the battery contacts in the vehicle are dirty or corroded, the power bank performance may be reduced. -
Do not attempt to start the vehicle in an emergency mode more than 3 times in a row. Overheating could damage the powerbank and the vehicle. Take at least two minutes between attempts. The jump starter adapter may get overheated and disconnected for safety reasons. After disconnecting and cooling down, the power bank must be switched on again.
-
Make sure that the power bank is stable and securely stored in the engine compartment when starting the engine in an emergency.
-
Do not short-circuit the adapter clamps or connect them to the same place. Always follow the user manual.
-
Make sure that the blue connector of the jump starter adapter is fully connected to the powerbank Melting could occur to the blue connector.
-
Start only when 3 to 4 indicator lights are on.
-
Never leave the powerbank on the battery after a successful start of the vehicle; disconnect it from the battery within 30 seconds after starting. Otherwise, damage may occur to the powerbank.
-
Do not use instead of the vehicle battery.
-
Do not use it as a vehicle battery charger.
-
Do not use the powerbank to start the vehicle while charging the powerbank internal battery.
-
Use only the accessories supplied with this powerbank.
-
Do not use it as a toy.
-
Do not leave the powerbank wet or immerse it in water.
-
Do not use in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust.
-
Do not be exposed to extreme heat or fire.
-
Do not wear metal objects when using the powerbank.
-
Do not use the powerbank if it is damaged in any way. In this case, have it checked in a specialized workshop?
-
Do not use the powerbank if any cable clamp or cable is damaged.
-
The powerbank may be repaired only by a specialized workshop.
-
Only charge the powerbank at an ambient temperature between 0 °C to 60 °C.
-
Charge the powerbank only with the original charger supplied in the package.
-
Charge the powerbank regularly and keep it charged.
-
Do not charge the powerbank with the engine off, there is a risk of discharging the vehicle battery.
-
Do not store in a vehicle at high and/or low temperatures for a long time.
-
Always store in the original packaging.
- The information on the technical data, design, equipment, materials, guarantees, and outside appearance refers to the period when the mounting instructions are sent to print.
- The manufacturer reserves the right to changes (including the change in technical parameters about the individual model measures).
- Nr. 000 051 763R / 11.2021
- www.skoda-auto.com
- www.skoda-auto.cz
Documents / Resources
|
SKODA 763R Jump Starter Power
Bank
[pdf] User Guide
763R Jump Starter Power Bank, 763R, Jump Starter Power Bank, Starter Power
Bank, Power Bank, Bank
---|---