Schneider Electric TMD 250 A PowerPact J Instructions
- June 15, 2024
- Schneider Electric
Table of Contents
Schneider Electric TMD 250 A PowerPact J
Retain for future use.
Kit Contents
Kit Accesorio
| Part| H-frame| H-frame| J-frame| Qty.
---|---|---|---|---|---
Terminal Cover Kit
S37436 S37440
| Terminal Covers| | |
1
Screws
| |
2
| | ****
| ****
| ****
|
Lug Shield Kit
S37446 S37447 S37448
| Lug Shields| | | | ****
1
Wire Range| #14–#3 AWG
(2.5–27 mm2)
| #14–3/0 AWG (2.5–95 mm2)| #4 AWG–350 kcal
(20–185 mm2)
|
Screws
| |
3
| ****
Lense
| | | ****
1
Tool Required
Installation
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
- Apply appropriate personal protective equipment (PPE) and follow safe electrical work practices. See NFPA 70E, CSA Z462, NOM 029-STPS or local equivalent.
- This equipment must be installed and serviced only by qualified electrical personnel.
- Turn off all power supplying this equipment before working on or inside equipment.
- Always use a properly rated voltage sensing device to confirm power is off.
- Replace all devices, doors and covers before turning on the power to this equipment.
Failure to follow these instructions will result in death or serious injury.
- Turn off all power supplying this equipment.If a circuit breaker is installed, remove from installation.
- For lug shields (kits S37446, S37447, and S37448) used with control wires, remove tab (A) for control wire leads from terminal cover.
- Install terminal covers (A) or lug shields (B) onto the circuit breaker using screws (C) provided. Torque screws to 10.6 lb-in. (1.2 Nm).
- Reinstall the circuit breaker as outlined in circuit breaker instruction manual shipped with circuit breaker.
- For lug shields (kit numbers S37446, S37447 and S37448):
- Insert wires as instructed per the instruction bulletin provided with circuit breaker.
- Remove the protective coating from lense, if installed.
- Install lense (D) over wire binding screw access ports using screw (E) provided.
- Torque screws to 10.6 lb-in. (1.2 Nm).
Terminal Cover and Lug Shield Kits
Terminal Cover Installation
Lug Shield Installation
Electrical equipment must be installed, operated, serviced, and maintained only by qualified personnel. No responsibility is assumed by Schneider Electric for any consequences arising out of the use of this material. Schneider Electric, Square D, PowerPacT and TeSys are trademarks and the property of Schneider Electric SE, its subsidiaries, and affiliated companies. All other trademarks are the property of their respective owners.
Schneider Electric USA, Inc.
800 Federal Street
Andover, MA 01810 USA
888-778-2733
www.se.com/us
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>