OLIGHT Seeker 4 Mini UV Torch User Manual
- June 15, 2024
- OLIGHT
Table of Contents
OLIGHT Seeker 4 Mini UV Torch
BOX CONTENT
Multi-language dictionary
Refer to Table 1 and Table 2 for product parameters.
Operating instructions as below
Remove the insulating film, see Figure 1.
Reveal the type-c charging port, see Figure 2-1;
Charging, see Figure 2-2.
ON/OFF, see Figure 3
Single press the side switch to turn the light on/off. When the light is
turned on, it will return to the previous brightness level selected before the
light was turned off. (Only the moonlight, low, medium, and high mode can be
memorized when the light is switched off. The turbo mode is memorized as high
mode, the high mode will only be memorized for one minute before reverting to
medium mode. The strobe mode cannot be memorized).
Lockout / unlock, see Figure 4.
When the light is off, press and hold the side switch (for about 2 seconds to
access the lockout mode (the light will enter the moonlight mode first and
will then switch off to signal the lockout mode). The red indicator at the
center of the switch will be on for a short time to signal that the light is
still in lockout mode. To unlock it, keep holding the side switch for over one
second until the moonlight mode is on again.
Moonlight, see Figure 5.
When the flashlight is off, press and hold the side switch for over one second
to access the moonlight mode. When the flashlight is turned on again, it
returns to the moonlight mode due to its memory function.
Turbo, see Figure 6.
Quickly double press the side switch to enter into Turbo, double press again
to return. If the memorized mode were High or Medium, the output is Medium; if
the memorized mode were Low or Moonlight, the output is the memorized mode.
Change brightness level, see Figure 7.
When the flashlight is on, press and hold the side switch and it will,
starting from the present brightness level, automatically cycle through Low,
Medium, and High mode. The mode is selected when the side switch has been
released. (Please note: moonlight and turbo are not in the automatic cycle ).
Strobe, see Figure 8.
When the flashlight is on, triple-press the side switch to activate strobe
mode. To quit this mode, single press or press and hold the switch.
Set timer, see Figure 9.
The Flashlight has a long (9 minutes) and short (3 minutes) timer when the
light needs to be automatically turned off. When the flashlight is on, double
press and hold the side switch under the current brightness level to access
the timer settings. A single blink accesses the short timer while two blinks
accesses the long timer. The flashlight will automatically turn off when the
timer is up. After the timer is set, double press and hold the side switch to
shift the timer settings. After the first timer runs out and you enter the
timer setting again, the last setting will be used.
Battery Indicator：
Normal mode, see Figure 10-1.
Moonlight mode, see Figure 10-2.
WARRANTY
- Within 30 days of purchase: Contact the original seller for repair or replacement.
- Within 5 years of purchase: Contact Olight for repair or replacement.
- Battery warranty: Olight offers a one-year warranty for all rechargeable batteries.
- This warranty does not cover normal wear and tear, modifications, misuse, disintegrations, negligence, accidents, improper maintenance, or repair by anyone other than an Authorized retailer or Olight itself.
Customer Support
- USA Customer Supportcs@olightstore.com
- Global Customer Supportcontact@olightworld.com
- Visit www.olightworld.com to see our complete product line of portable illumination tools.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>