Air Oasis iAdaptAir HEPA UV Air Purifier Instruction Manual

iAdaptAir®

For use with iAdaptAir® S, M, L Models
Due to continuous improvements, the picture
included within this owner’s manual may
differ slightly from the actual product.
For safety and to ensure proper use carefully
read the contents of this manual before
operating the purifier.
R2022.03.20

iAdaptAir HEPA UV Air Purifier

Thank You for Choosing the iAdaptAir®

Congratulations, you own the smartest, most effective, user-friendly air purifier.
Before operating the iAdaptAir®, please read this manual in its entirety. Doing so will give you important information to keep you safe from harm and ensure you get the most benefits from your purifier. For additional information please contact us:
Mail: Air Oasis, LLC
Attn: Customer Service
3401 Airway Blvd.
Amarillo, TX 79118
Web: www.ciroasis.com
Email: support@airoasis.com
Phone: 806-373-7788

Warranty Guaranteed

To view our warranty information, terms and conditions and privacy policy, go to: www.airoasis.com/policies/#warranty- policy

Important Safety Instructions

When operating any electrical appliance, basic precautions should always be followed for safety.
WARNING: To reduce risk of fire, electric shock or injury:

• Carefully read the entire contents of this manual.
• Do not use outdoors or on wet surfaces.
• Do not use the purifier in areas of extreme heat or in the presence of flamma- ble gas
• Do not handle the wires or appliance with wet hands.
• Do not use damaged or uninsulated wires. If appliance is not working proper- ly, call a customer service representative at 806-373-7788.

WARNING: RISK OF ELECTRICAL SHOCK. CAN CAUSE INJURY OR DEATH.
DISCONNECT PURIFIER FROM POWER SUPPLY BEFORE SERVICING.
Store and transport -4°F ~ 180°F, humidity 10% ~ 90% (Non-Condensing}.
Do not operate purifier in ambient temperatures above 150° F
KEEP OUT OF REACH OF CHILDREN.
Use the purifier on a flat surface and keep out of direct sunlight.
To prevent electrical shock, please remove the power plug before maintaining or moving the purifier.
Please do not clean the appliance with any type of acid-base solutions to prevent damage and electric shocks.
Do not block the air inlet & outlet.
Make sure the purifier is used within the voltage of 110~240V/50~60Hz.
Please do not use a wet hand to insert or remove the power plug to prevent electrical shock.
It is strictly prohibited to rinse the appliance with water. Do not use the appliance near water sources or volatile flammable items to prevent electrical shock.
The product is not a toy, hence it is prohibited for children to play with the appliance in order to prevent damage.
Do not sit or stand on the appliance. Do not use the appliance when it is shaking or tilting. It is prohibited to obstruct the air outlet to prevent reducing the purifying efficiency.
If purifier is operating abnormally, please unplug the power, and contact the manufacturer.
If the purifier is damaged, immediately disconnect the power and contact the manufacturer.
When cleaning, usa a soft, dry cloth to gently wipe the air purifier. Use a small brush to softly clean the air outlets.

Base Installation

Using the four included screws, attach the base. This will prevent injuries by ensuring the unit is stable and will not fall over.

Operation

Using the four included screws, attach the base. This will prevent injuries by ensuring the unit is stable and will not fall over

Control Panel

• Feather touch controls are operated with the light touch of a finger.
• The backlit controls allow for easy operation even in dark conditions.

After connecting the power supply, you will hear one beep and the control panel will illuminate for two seconds before entering standby mode.
Power Button:
1st press turns on the purifier, ionizer, UV light and low fan speed.
2nd press turns off the ionizer.
3rd press turns off the UV light.
4th press keeps the UV light off and turns the ionizer on.
5th press switches the purifier to standby mode.
Fan Speed: Cycles the fan speed to Low, Medium or High.
Timer: Sets an auto off timer for 2, 4 or 8 hours.

Child Lock/Sleep Mode: Press for three seconds until you hear a single beep, signifying Child Lock/Sleep Mode has been activated. Once activated, all settings will be locked and control panel lights will dim. Tap any button to temporarily illuminate status icons  to view locked settings. Pressing the Child Lock/Sleep Mode button for three more seconds will unlock the control panel.

Smart Mode: Press to activate Smart Mode. While in Smart Mode, the fan speed will automatically adjust according to your air quality. If the iAdaptAir® senses a reduction in air quality, the fan speed will automatically increase.
When the air quality improves, the fan speed will automatically decrease to extend filter life.

WiFi Functionalty Using the Control Panel

Viewing Wifi Stauts

1. Press the Smart Mode button once while the purifier is in standby (power cord plugged in to the purifier, but not powered on). The smiley faces will show the status of the WiFi connection:
   Green Flashing Happy Face = Not Connected
   Solid Green Happy Face = Connected
   Red Frowning Face = WiFi Turned Off

2. The status will show for one minute and then return to normal automatically.

3. Hold the Smart Mode button for more than three seconds and it will reset the WiFi network name and password.

IMPORTANT: Do not reset the purifier by step 2 if it is still registered in the app.
You will need to delete the purifier from the app before reseting.
Turn WiFi On/Off
Hold the Fan Speed button for more than three seconds while the purifier is in standby mode. The WiFi will turn off. Refer to the WiFi status above.
Unplugging the purifier automatically resets the WiFi status to be turned on.

Maintenance

Dust Guard Maintenance
Ensure the iAdaptAir® is unplugged from its power source before performing any maintenance.
Pivot the dust guard outwards and lift up to remove it from the purifier.

Use a vacuum to remove any debris. Wipe down the dust gaurd with a damp rag. Dry before replacing in the iAdaptAir®.

Clean the bi-polar brush heads periodically for optimal effectiveness.
Use a pipe cleaner or something similar to insert into the two holes in front of the brushes to knock off any debris buildup.

Use a soft cloth to clean the exterior surfaces (do not use chemicals or alcohol).

Filter Replacement

When to Change Your Filter

How to Change Your Filter

1. Remove the iAdaptAir® from power. Open the filter cover by sliding it to the right.

2. Take out the old filter and replace with a new filter.

3. Close the filter cover.
   

4. Power the iAdaptAir® back on. Press and hold the Filter Replacement Reminder for 3 seconds to reset it.
   

UV lamp Replacement

For optimal performance and maximum efficiency of your iAdaptAir® , ensure all UV lamps are replaced annually.
Ensure the iAdaptAir® is unplugged from its power source before performing any maintenance. UV lamp may be hot. Allow time for the lamp to cool before removing it.

1. Remove the filter cartridge and dust guard (See page 10).

2. Slightly rotate and move the UV lamp forward to remove it from the clips.
   

3. Squeeze the release lever on the back of the lamp connector while pulling the connector away.
   

4. Reverse the previous steps to install the new UVC lamp.
   Hg lamp contains mercury. Manage in accord with disposal laws. Contact local waste management for disposal sites and procedures.

Troubleshooting Guide

Purifier Not Turning On
Ensure the following:

• The power button has been pressed.
• The power cord is not loose or broken.
• The correct plug connector is in use. Your iAdaptAir® comes with international plugs. Ensure you are using the correct one for your country.

Odors From the Purifier
Ensure the following:

• There is no debris buildup. Your purifier requires regular filter replacements.
• The filter has more than 25% life remaining (see page 12).

Poor Performance
Ensure the following:

• The purifier is in a space with good air ventilation. Your purifier requires proper air flow to cycle through and clean your air.
• Neither the air inlet nor outlet are obstructed.

Something Else?

If you are experiencing an issue with your air purifier that is not listed here, please contact our Customer Excellence team.

Mail: Air Oasis, LLC
Attn: Customer Service
3401 Airway Blvd.
Amarillo, TX 79118
Web: www.airoasis.com
Email: support@airoasis.com
Phone: 806-373-7788

Specifications

37in
Weight| 7 lbs.| 15.5 lbs.| 20 lbs.
Fan Speed| Low 700rpm, Medium 1000rpm, High 1200rpm| Low 700rpm, Medium 1000rpm, High 1200rpm| Low 700rpm, Medium 1000rpm, High 1200rpm
Timer Settings| 2hr, 4hr, 8hr| 2hr, 4hr, 8hr| 2hr, 4hr, 8hr
Ozone| 0.00 PPM| 0.00 PPM| 0.00 PPM

Replacement Filter Cartridge

| Model #: AOIA-SF
HEPA, carbon and AHPCO®| Model #: AOIA-MF
HEPA, carbon and AHPCO®| Model #: AOIA-LF
HEPA, carbon and AHPCO®
Ion Output| 20,000,000      positive and negative| 20,000,000      positive and negative| 40,000,000      positive and negative
Noise Level| 25dB low speed to 52dB high speed| 25dB low speed to 52dB high speed| 25dB low speed to 52dB high speed

References

• Policies | Air Oasis

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>