hama 00201695 MagPower4 Wireless Power Pack Instruction Manual

hama 00201695 MagPower4 Wireless Power Pack

Specifications

• USB-C input: 5 V 2 A, 9 V 1.5 A

• USB-C output: 5 V 2 A, 9 V 1.5 A, 12 V 1.1 A

• Induction output: 10 W (max.)

• Total output: 5V 2A

• Battery type: 3.7 V / Li-Po

• Min. capacity: 4995 mAh / 18.48 Wh

• Typ. capacity: 5000 mAh / 18.5 Wh

• Usable capacity*: 3266 mAh @ 5 V 2 A

• The usable capacity is the capacity that can be drawn from the output sockets, measured at 5V output voltage and a draw current of 2A.

Product Usage Instructions

Explanation of warning symbols and notes

Warning: This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.

Note: This symbol is used to indicate additional information or important notes.

Switching on / off

Note: The Power button (3) is used to switch on or off the power pack.

Charging the power pack

Warning: Ensure that the power pack is charged using a compatible USB-C charger. Do not use any other chargers as it may cause damage to the power pack.

Note: It is recommended to fully charge the power pack before initial use.

Charging devices

Note: The power pack can be charged and the inductive charging function used simultaneously. The Power button (3) is inactive in this situation. The wireless charging function starts automatically when the smartphone is placed in position.

Warning: Do not connect devices that require a higher power input than the power pack can provide. Doing so may in certain circumstances overload the power pack.

Care and maintenance

Note: Only clean this product using a lint-free, slightly damp cloth and do not use any harsh cleaners.

Warranty disclaimer

Note: Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product, or from failure to observe the operating instructions and/or safety notes.

Frequently Asked Questions (FAQ)

Q: Can I charge the power pack and use the wireless charging function at the same time?

A: Yes, you can charge the power pack and use the wireless charging function simultaneously. The wireless charging function starts automatically when the smartphone is placed in position.

Q: Can I use any charger to charge the power pack?

A: It is recommended to use a compatible USB-C charger to charge the power pack. Using other chargers may cause damage to the power pack.

Q: What should I do if there are metal parts on the back of my device?

A: Ensure that there are no metal parts (e.g. metal plate for magnetic holders) on the back of your device. Metal heats up significantly in the field of an induction charger and can damage your device and/or the power pack.

PRODUCT OVERVIEW

Thank you for choosing aHama product.
Take your time and read the following instructions andinformation completely.Please keep these instructions in asafe place for futurereference. If you sellthe device, please pass these operating instructions on to the new owner.

Explanation of warning symbols and notes

Warning
This symbol is used to indicate safety instructions or to draw your attention to specifichazards and risks.

Note
This symbol is used to indicate additional information or important notes.

Package contents

• “MagPower 5” power pack
• USB-C charging cable
• These operating instructions

Safety instructions

• Protect the product from dirt, moisture and overheating and use it in dry environments only.
• As with all electrical products, this device should be kept out of the reach of children.
• Do not drop the product and do not expose it to any major shocks.
• Do not operate the product outside the power limits given in the specifications.
• Do not open the device or continue to operate it if it becomes damaged.
• Dispose of packaging material immediately in accordance with the locally applicable regulations.
• The battery is permanently installed and cannot be removed;dispose of the product as awholein accordance with the statutory regulations.
• Do not modify the product in any way.Doing so voids the warranty.
• Do not incinerate the battery or the product.
• Do not tamper with or damage/heat/disassemble the batteries/rechargeable batteries.
• Do not use the product in the immediate vicinity of heaters, other heat sources or in direct sunlight.
• Do not use the product in areas in which electronic products arenot permitted.
• Donot attempt to service or repair the product yourself. Leave any and all service work to qualified experts.

Warning -magnets

• People with pacemakers should keep away from the magnets. The magnets can negatively affect the function of the pacemaker.
• Do not place any bank or similar cards with magnetic strips or magnetically sensitive objects on the product. The data on the cards could be damaged or completely deleted.

Warning
Ensurethat there are no metal parts (e.g. metal plate for magnetic holders) on the back of your device. Metal heats up significantly in the field of an induction charger and can damage your device and/or the power pack.

Operation

Note -Switching on /off

• Press the button on the power pack to switch this on, to determine the power pack’s capacity and to start the wireless function.
• The power pack switches itself off after around 40 seconds of non-use. Press the Power button twice to switch the power pack off manually. When the power pack switches off, the LED display also goes out.

Charging the MagPower 5

• Start the power pack charging process by connecting the enclosed USB-C cable to the USB-C input on the power Pack (IN 5V /2Aor 9V/1.5A)and to a suitable USB-C charger.To do this, consult the operating instructions for the USB charger you are using.
• The charging process begins and ends automatically.
• Fully charge the power pack once before using it for the first time.

Note – capacity

• During the power pack charging process, the capacity is displayed constantly.
• Each LED (4) corresponds to 25% of the capacity. The permanent illumination of an LED indicates that the capacity has already been reached. If three LEDs light up and the fourth one flashes, the power pack is at least 75% charged.
• If all four LEDs (4) light up, the full capacity is available.

Warning – rechargeable battery

• Do not charge the power pack via your PC or notebook. The charging currents can damage the USB port on the PC or notebook.
• Only use suitable charging devices or USB ports to charge the product.
• Do not use defective chargers or USB ports and do not attempt to repair them.
• Do not overcharge the product or allow the battery to completely discharge.
• Avoid storing, charging and using in extreme temperatures and at extremely low atmospheric pressures (such as at high altitudes).
• When stored over a long period of time, batteries should be charged regularly (at least every three months).

Charging devices

Wireless charging with the induction charging zone:

• first switch the power pack on using the Power button (3).
• The blue function LED (2) briefly signals that the power pack is ready and then switches off
• Place your device with its back on the inductive charging zone (B).
• The “MagPower 5” power pack is compatible with Apple MagSafe technology. The correct alignment and fixation of the device takes place automatically thanks to the magnets integrated into the power pack and the iPhone.
• All other smartphones that support the inductive charging function should also be placed on the induction charging zone (B). In this case, however, the automatic central fixing of the device does not take place.
• The charging process begins as soon as an effective induction field has been established. The status LED (2) lights up blue. The current charge status is displayed on your device.
• If no induction connection can be established, change the position of your device if necessary (B). (For all smartphones that do not feature MagSafe technology)
• If your device’s battery is fully charged, the status LED (2) goes out once when you remove the device.
• Remove your device from the power pack’s induction charging zone and switch it off by pressing the Power button twice in quick succession. The LEDs (4) go out.

Note
The power pack can be charged and the inductive charging function used simultaneously. The Power button (3) is inactive in this situation. The wireless charging function starts automatically when the smartphone is placed in position.

Charging via the power pack’s USB-C output:

• connect the enclosed USB-C charging cable to the USB-C port on the power pack (OUT 5V/ 2A, 9V/1.5 A, 12 V/1.1 A) and with the USB-C port on your device (mobile phone, smartphone, etc.).
• In certain circumstances, the enclosed charging / connecting cable may not match the USB port on your device. In this case, use the USB cable that came with your device.
• The charging process begins automatically. During the charging process, the LEDs (4) the power pack’s remaining available capacity.
• The current battery charge status of your device is indicated on this.
• Terminate the charging process and switch the power pack off by pressing the power button twice in quick succession. The status LEDs go out.
• In the event that no device is connected, the power pack switches itself off automatically.

Warning – connecting devices

• Before connecting a device, check whether it can be adequately supplied with the power pack’s current delivery.
• Ensure that the total current consumption of the connected device does not exceed 2000 mA.
• Note the instructions in your device’s operating manual.
• You must obey the instructions and safety notes contained therein regarding the supply of power to your devices.
• Please do not charge simultaneously using the wireless charging and USB-C charging options.
  Doing so may in certain circumstances overload the power pack.

Note – optimised charging
Optimised charging means that the power pack recognises the connected device, supplies it with the ideal current strength and therefore reduces the charging time to a minimum. Note that the power pack’s maximum current delivery is 2000 mA.

Care and maintenance

Only clean this product using a lint-free, slightly damp cloth and do not use any harsh cleaners.

Warranty disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.

Technical data

• The usable capacity is the capacity that can be drawn from the output sockets, measured at 5V output voltage and a draw current of 2A.

Declaration of conformity

Hama GmbH & Co KG hereby declares that the radio equipment type [00201585, 00201695 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following Internet address: www.hama.com -> 00201585, 00201695 -> Downloads.

Hama GmbH & Co KG 86652 Monheim/ Germany

Service & Support

• www.hama.com
• +49 9091 502-0

All listed brands are trademarks of the corresponding companies. Errors and omissions excepted, and subject to technical changes. Our general terms of delivery and payment are applied.

References

• hama.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>