momentum T1 Bluetooth Beacon User Guide
- June 15, 2024
- momentum
Table of Contents
momentum T1 Bluetooth Beacon User Guide
Before adding your Too/ie, please ensure you have an active Eagle 1 device within 100 feet (note: Range can be impacted by Objects, weather, etc)
-
Open the Momentum lo T mobile app on your phone
-
Tap the “Equipment” icon located in the bottom bar.
-
Tap “Add Equipment”
-
The app will then switch to scan mode.
Find the QR code on your Toolie and view it in the scan area on your phone. -
Open the Momentum lot mobile app on your phone
-
Pick a name an initials to indicate the equipment you would like Toolie to track, then tap “Add”.
-
Toolie is now added to your account. It will show up in your account only after it is in range of your installed and active Eagle 1.
After a few minutes, the Toolie will appear in the “Equipment” section in your account. -
Once it shows up in the app, you can attach the Toolie to your tool or light-equipment.
Peel the red cover on the double-sided tape on the back of the Toolie. -
Use the included surface cleaning kit to ensure the surface where you will attach the Toolie is clean.
-
Stick the Toolie on your light-equipment. Press down firmly.
There are four Toolie statuses Online Blue, Active Green, Out of Range Grey and Offline Red. Here’s what each one means:
- Online- Toolie is writhing 100-foot radius of Eagle 1 GPS Tracker, but not in use or moving.
- Active- Toolie is within 100-foot radius of an Eagle 1GPS Tracker and is currently detecting movement.
- Out of Range- Toolie is out of 100-foot radius of the Eagle 1 GPS device for more than 5 minutes.
- Offline- Toolie is out of Range for more than 24 hours
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Questions?
Call or text us at 323-831-3475
or Send and email to:
CustomerSuccess@momentumiot.com
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
©Momentum IoT, Inc. All rights reserved
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>