SNICLO JUST AIR Micro RC Car Instruction Manual

June 4, 2024
SNICLO

SNICLO JUST AIR Micro RC Car

SNICLO-JUST-AIR-Micro -RC-Car-PRODUCT

This product is not intended for use by anyone under the age of 14. Please read the manual carefully before using this product and keep it properly.

We provide outstanding service since 2012

CONTACTS

  • ADDRESS: Manufacturer: Zhihe Industrial Design (DongguanCo, Ltd.
  • Email: service.support@diatone.hk
  • Tel: (+86) 0769-8210 O057
  • Web: www.diatone.us
  • Address: Baljiayi Technalogy Park A-3, Yantian Fenggang Dangguan. Guangdong, China

For more information, please refer to the Diataneofficial website.

MADE IN CHINA

If you are operating a 1:100 scale remote control car for the first time, please take a few minutes to familiarize yourself with the functions and uses of the product. After reading this manual, you can understand the various characteristics of the system before starting to use the product.

Safety Notice

  • This product contains small parts which are a choking hazard and should not be used by children aged 14 years and under to avoid accidents.
  • Children over the age of 14 must be used in the presence of a guardian and must not leave the sight of the guardian. Please keep out of reach of children when charging and storing the product
  • Moveable parts are dangerous to some extent. It is forbidden to put fingers, hair, clothes, etc. into the gap between the tire and the car body, so as not to be caught by the rotating parts
  • Please operate in strict accordance with the following usage scenarios
    1. Do not operate in the place where the car is driving or near children, so as to avoid dangers such as collision;
    2. Do not drive on sand, water, or dusty places to avoid malfunctions,
    3. Do not drive toward people or animals to old accidents,
  • Because of functional requirements, this product contains sharp parts, please follow the correct steps and use methods, especially pay attention to eye safety.
  • Do not bend, throw this product, or use it in other rough ways to avoid damage to this product accident.
  • This product has a built-in lithium polymer battery, please do not put it into water or fire (such as a stove, gas stove, etc.) to avoid explosion.

Package contains

SNICLO-JUST-AIR-Micro -RC-Car-fig-1

The product list is based on the actual type of products purchased

  1. Just Air contains: JustAir x 1/ Type-c charging cables 1/ manual x1
  2. AIR 5 remote control contains: AIR 5 remote controls 1/ manual x 1

Function Description

SNICLO-JUST-AIR-Micro -RC-Car-fig-2

Preparation before running

Charge

SNICLO-JUST-AIR-Micro -RC-Car-fig-3

Take out the remote control car and accessories from the box, and use the included charging cable to insert the car’s charging port and USB port to charge when it is turned off (Due to long-term storage, please charge the remote control car for the first time). Theredlighton the tail flashes to indicate that it is charging, and the red light on the tail goes out, indicating that the charging is complete.

Tip: The ower-on state, plug in the charging power supply, and the product will not be able to be used. In the charging state, the car switch must be turned off.

Notice

  1. Before charging the product, make sure the charging plug is dry.
  2. When charging the product, please keep the product away from the flammable area.
  3. Please use USB to TYPE-C (5V) for charging.
  • Light flashing: Normalcharging
  • Lights off: Charging complete
Turn on and off the car power

SNICLO-JUST-AIR-Micro -RC-Car-fig-4

  • Power on: In the off state, turn on the switch and the headlights will turn on, and the car will be turned on.
  • Shutdown: In the power-an state, turn off the switch, all lights go off, and the car shuts down.

Product parameters

SNICLO-JUST-AIR-Micro -RC-Car-fig-5

MAINTENANCE

  1. Before each use of the product, check and clean the foreign matter in the gap between the wheel and the chassis, and ensure that all parts are not loose
  2. When the Car is stored for a long time, more than 70% of the power should be kept for storage to prolong the battery life. and every3 months.
  3. One charge to avoid battery damage. (It is recommended to fully charge it and use it for 20 minutes before saving it).

Remote control function description

Driving and Steering

SNICLO-JUST-AIR-Micro -RC-Car-fig-6

Wheel offset adjustment button

SNICLO-JUST-AIR-Micro -RC-Car-fig-7

Switch and power-operated button functions

SNICLO-JUST-AIR-Micro -RC-Car-fig-8

Personalized function keys

SNICLO-JUST-AIR-Micro -RC-Car-fig-9

Start remote

Remote control battery installation and replacement

Use AAA batteries x 3 or 18650 x 1 ithium batteries to drive the remote control installation steps:

  1. Open the battery cover from the bottom of the remote control.
  2. Insert the AAA battery into the battery card slot and then into the battery slot. Or put the 18650 lithium battery directly into the battery slot
  3. After the battery is installed well, close the battery cover
  4. When the remote control lights up, it can be used

Precautions

  1. The positive pole of the battery needs to face outward (As shown in the right picture)
  2. If the remote control is not used for a long time, please remove the battery to avoid damage to the battery
  3. Please do not try to charge the remote control battery through the Type-C power output interface.

Car Connection Pairing

SNICLO-JUST-AIR-Micro -RC-Car-fig-11

Remote control pairing method

  1. Turn on the power of the car, wait for 8 seconds, the yellow light at the rear flashes, and enter the pairing made,
  2. Turn on the power of the remote control, long press the “multi-function button” for 2 seconds, the LOGO light flashes, and the automatic pairing starts
  3. The LOG0 light of the remote control stops flashing, the pairing is successful, and the product is started to be used.

About parameter adjustment

  1. Steering offset fine-tuning: when the steering wheel is at the center point, if the front wheel is not straiçht, use the steering fine-tuning adjustment.
  2. Power mode: Set the maximum power value
  3. Steering mode: Set the turning radius to make the Car reach the best turning radius.

Note: If the turning radius is too small, it may cause the Carto drift when driving at high speed. Please adjust the turning radius reasonably.

AIR 5 remote controller parameters

SNICLO-JUST-AIR-Micro -RC-Car-fig-12

Troubleshooting

SNICLO-JUST-AIR-Micro -RC-Car-fig-13

SNICLO-JUST-AIR-Micro -RC-Car-fig-14

Light status indication

SNICLO-JUST-AIR-Micro -RC-Car-fig-15

Non-Warranty Regulations

  • Unauthorized maintenance, misuse, collision, neglect, abuse, liquid ingress, accident, the alteration, improper use of nan-product accessaries, tearing or altering of security markings
  • The validity period of three packs has exceeded;
  • Damage caused by force majeure
  • Not in line with the performance failures listed in the “JuST AIR Remote Control Car Product Performance Failure Table”
  • The product and its accessories have performance failures listed in the JuST AIR Remote
  • Control Car Product Performance Failure Table” due to human reasons.

MAINTENANCE

  • Thisproductcontainss mall parts, which pose choking hazàard and are not suitable for children under the age of 14.
  • This product is strictly prohibited for children under the age of 14 to avoid accidents,
  • Children over the age of 14 must use it in the presence of a guardian, and must not leave the guardian’s line of sight When charging and storing the product, please keep it out of the reach of children,
  • Moveable parts are dangerous to some extent. It is forbidden to put fingers, hair, clothes, etc. into the gap between the tire and the Car body, so as not to be caught by the rotating parts.
  • Please operate in strict accordance with the following usage scenarios:
    1. Do not operate in the place where the car is driving or near children, so as to avoid dangers Such as collision,
    2. Do not drive on sand, water, or dusty places to avoid malfunctions
    3. Do not drive toward people or animals to avoid accidents
  • Because of functional requirements, this product contains sharp parts, please follow the correct steps and use methods, especially pay attention to eye safety.
  • Do not bend, throw this product, or use it in other rough ways to avoid damage to this product or an accident
  • This product has a built-in lithium polymer battery, please do not put it into water or fire (such as a stove, gas stove, etc.) to avoid explosion.

Configuration information is required to use the return service

When the user applies for a return or replacement, he needs to confirm with the customer service according to the warranty instructions of the car whether it meets the after-sales conditions and makes relevant after-sales arrangements.

Hint

  1. The products, accessories, and remote control in theinstruction manual are schematics for reference only.
  2. Due to products update and upgrades, the actual products may differ slightly from the schematic, please refer to the actual product.

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference.
  2. this device must accept any interference received, including interference that may cause undesired operation. 15.21 Information to the user.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 15.105 Information to the user.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. The equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

FCC RF Radiation Exposure Statement

  1. This Transmitter must not be located or operating in conjunction with any other antenna or transmitter.
  2. This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with a minimum distance of 5mm between the radiator and your body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals