NICOMOW 69586 Double Protection Safe Instruction Manual

NICOMOW 69586 Double Protection Safe Instruction Manual

25/35/45 SERIES SAFE DEPOSIT BOX INSTRUCTION GUIDE

Accessories

Warnings

1. ⚠ Do not lock the emergency key or external battery box into the cabinet.
2. ⚠ If the safe box will not used for a long time, please remove its battery.
3. ⚠ Purchase 4 AA batteries in advance, this safe does not contain batteries.

How to Use Your Safe Box?

Operating Instructions

1. The “⚙” flashes once every time an operation key is pressed.
2. The “#” key on the operation keypad is used to indicate start and confirmation.
3. After any key is pressed, if there is no subsequent key input for 1 O seconds, the lock will enter the sleep state.
4. Once it enters the sleep state, all operations will stop. Wake up the screen by press any keys.
5. During input, you can press “*” key to delete all the input and re-enter.

How to Set or Change the Password?

Personal password setting and changing

1. When the door is open, press the green setting button inside the door, and it will beep twice and “⚙” will light up, indicating that the personal password setting or changing has begun.
2. Enter any number between 1 to 8 digits and press”#” to confirm, it will beep twice, indicating that the personal password has been set successfully.

Management password setting and changing

1. When the door is open, press “00”, then press the green setting button inside the door, and it will beep twice, “⚙ ” will light up, indicating that the management password setting or changing has begun.
2. Enter any number between 1 to 8 digits and press”#” to confirm, it will beep twice, indicating that the management password has been set successfully.

Opening and locking the door

1. After entering the correct personal password or management password, press”#” key to confirm, it will beep twice and “OK”
   will light up, indicating that the password is correct. You can open the door within 5 seconds.

2. After about 5 seconds, “OK” will turn off and the door can’t be open.

3. If the password is incorrectly, it will beep four times after pressing”#”.

4. If the password is entered incorrectly three times consecutively, an automatic alarm will sound for one minute. Enter the correct password to relieve the alarm.

Vibration Alarm

1. To set the alarm, press”#”, it will beep once and the computer board will automatically enter alarm mode.
   If the safe box is vibrated, the built-in alarm will sound immediately.

2. To relieve the alarm, enter the correct password, and then press 11#11 to open the door and relieve the alarm.
   When the alarm is relieved, you need set the alarm again to start it.

Under voltage Indication

1. When the battery voltage is low, when the “OK” lights up, “ID” will light up. The lock can still work for a period of time, but it is rec om mended to replace the battery as soon as possible.
2. This model contains a memory chip, so the password protection will not be lost after a power failure.

Technical Parameters

1. Working power supply: four 5th AA alkaline batteries
2. Working voltage range: 4.0V ~ 6.8V
3. Working under voltage point: 4.60V±0.30V
4. Working current: ~380mA
5. Static current: <30uA
6. Working temperature: -10°C ~ +70°C
7. Working humidity: 10% ~ 90%RH

How to Use Emergency Battery Box?

When the safe box’s battery is too low to open the door, insert 4 AA 1.5 batteries in the emergency battery box, plug the emergency power cord into the emergency power jack on the bottom edge of the panel, then enter the correct password to open the door.

How to Install Foot Mat?

Remove the sticker of the foot mat and install it on the bottom.

How to Mount the Safe?

1. Place the safe on the installation location, find the installation holes from the inside of the safe, mark the drilling points from the inner installation holes, then remove the safe and drill two holes.
2. Take the expansion bolt out of the casing and put it into the drilled hole, then align the pre-drilled hole with the inner hole of the safe, and then insert the expansion bolt into the casing from the inside of the safe.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>