URBANEARS Boo Tip Wireless In-Ear Earbuds User Manual
- June 4, 2024
- Urbanears
Table of Contents
Boo Tip Wireless In-Ear Earbuds
User Manual
HOW TO PAIR
- Put both earbuds in the case and keep the lid open.
- Press and hold the button on the case for 2 seconds. Release it when the LED indicator blinks blue.
- Select Urbanears Boo Tip from your device’s Bluetooth menu to pair. Done!
TOUCH CONTROL
The touch control surfaces are located on the left and right earbuds.
- Tap once to play/pause or accept/end calls.
- Tap twice to skip forward or reject calls.
- Taps three times and skips backward.
CHARGING
Place the earbuds in the charging case and close the lid to charge the earbuds
and turn them off.
Charge the case by connecting a USB charger to the USB-C port on the case.
If left unused, the earbuds will go into standby in order to save power. Just
tap both earbuds to wake them up again.
IN-EAR TIPS
Take the time to find the in-ear tip size that best fits your ear. The tips
should fit snugly in your ear but still, feel comfortable.
LED INDICATOR
Blue light is ready for Bluetooth pairing. Red (low) to green (full) is for
the case battery status.
CLEANING
Regularly clean your earbuds to make them last longer and perform better.
Unplug the USB charger before cleaning the case. Make sure everything is
completely dry before putting the earbuds back in the case or plugging in a
USB charger.
Use a soft, slightly damp lint-free cloth and mild soap, and avoid getting
moist in any openings. Carefully clean sensitive areas such as speaker mesh
and openings with a dry brush or cotton swab.
Silicone tips can be removed and cleaned with water and mild soap. Dry them
with a towel before putting them back on the earbud.
- Do not use any sharp objects
- Do not rinse the product under running water or use compressed air
- Do not use cleaning detergents or wet wipes as they may contain strong chemicals, alcohol, or bleach that can affect the surface or performance
TROUBLESHOOTING
EARBUDS DO NOT BEHAVE AS EXPECTED
If your earbuds behave erratic or are unresponsive, follow the instructions
below.
- Put both earbuds in the case and close the lid to restart the earbuds.
If the problem persists, perform a factory reset.
Note: This will delete all user settings and the earbuds will need to be
paired again.
- Put both earbuds in the case and keep the lid open.
- Press the button on the case and release it when the LED turns purple.
- Remove Urbanears Boo Tip from your device’s Bluetooth menu before pairing again.
THE LEFT OR RIGHT EARBUD DOES NOT PAIR
If you can only connect to either the left or the right earbud but not both,
follow the instructions below.
- Make sure that both earbuds are charged.
- Remove Urbanears Boo Tip from your device’s Bluetooth menu.
- Put both earbuds in the case and keep the lid open.
- Triple press the button on the case and the LED indicator blinks green.
- The LED blinks blue when the earbuds are coupled and are ready for pairing.