URBANEARS JUNO Wireless Earbuds User Manual
- June 9, 2024
- Urbanears
Table of Contents
JUNO Wireless Earbuds
User Manual
JUNO Wireless Earbuds
HOW TO PAIR
- Put both earbuds in the case and keep the lid open.
- Press and hold the button on the case for 2 seconds. Release it when the LED indicator blinks blue.
- Select Urban ears Juno from your device’s Bluetooth menu to pair. Done!
TOUCH CONTROL
The touch control surfaces are located on the left and right earbud.
- Tap once to play/pause or accept/end calls.
- Tap twice to skip forward or reject calls.
- Taps three times skip backwards.
- Hold to toggle between Active Noise Cancellation, Noise control turned off and Transparency.
The touch controls can be customized in the Urban ears app.
ACTIVE NOICE CONTROL MODES
Urban ears Juno has three Noice control modes for adjusting how much of the outside world you hear.
- Active Noice Cancellation uses the earbud microphones to detect unwanted surrounding noise to make the earbuds produce anti-noise to cancel it out.
- Noice control off
- Transparency mode uses the earbud microphones to let you hear your surroundings.
CHARGING
Place the earbuds in the charging case and close the lid to charge the earbuds
and turn them off.
Charge the case by placing it on a wireless charging plate or by connecting a
USB charger to the USB-C port on the case.
If left unused, the earbuds will go into standby in order to save power. Just
tap both earbuds to wake them up again.
IN-EAR TIPS
Take the time to find the in-ear tip size that best fit your ear. The tips should fit snugly in your ear but still feel comfortable.
LED INDICATOR
Blue light is ready for Bluetooth pairing. Red (low) to green (full) is for the case battery status.
CLEANING
Earbuds come in close contact with your skin often and sometimes for long
periods of time. This will over time cause build-up of dirt and grease that
can affect performance and may cause skin irritation. Clean your earbuds
regularly to keep them fresh and make them last longer.
Unplug any cables before cleaning the case. Make sure everything is completely
dry before using the earbuds, putting the earbuds back in the case, or
plugging in a USB charger.
Remove the silicone ear tips from the earbuds and clean them separately. Use a
disinfectant wipe or a lint-free cloth, slightly damp with 70% isopropyl
alcohol or 75% ethyl alcohol to gently clean the ear tips, the exterior
surfaces of the earbuds and the case. Avoid getting moisture in any openings
or in the speaker mesh.
Carefully clean those areas with a dry and soft brush, or a cotton swab.
- Do not use any sharp objects.
- Do not use compressed air.
- Do not use products containing bleach or hydrogen peroxide.
- Do not submerge the earbuds in any cleaning agents.
TROUBLESHOOTING
EARBUDS DOES NOT BEHAVE AS EXPECTED
If your earbuds behave erratic or are unresponsive, follow the instructions
below.
01. Put both earbuds in the case and close the lid to restart the earbuds.
If the problem persists, perform a factory reset.
Note: This will delete all user settings and the earbuds will need to be
paired again.
01. Put both earbuds in the case and keep the lid open.
02. Press the button on the case and release it when the LED turns purple.
03. Remove Urban ears Juno from your device’s Bluetooth menu before pairing
again.
LEFT OR RIGHT EARBUD DOES NOT PAIR
If you can only connect to either the left or the right earbud but not both,
follow the instructions below.
- Make sure that both earbuds are charged.
- Remove Urban ears Juno from your device’s Bluetooth menu.
- Put both earbuds in the case and keep the lid open.
- Triple press the button on the case and the LED indicator blinks green.
- The LED blinks blue when the earbuds are coupled and are ready for pairing.
PART IS LOST OR BROKEN
Don’t worry if you loos an earbud, ear tips or case. You can find spare-parts
at urbanears.com to make sure your Urbanears Juno lasts as long as possible.
LEGAL NOTICE
Design of device and packaging are intellectual properties of Zound Industries
International AB. © All Rights Reserved.
Urbanears and the product, packaging, logo and wordmark are intellectual
properties of Zound Industries International AB and may not be used without
permission.
The Bluetooth® wordmark and logos are registered trademarks owned by the
Bluetooth SIG, Inc. and any use of such marks by Zound Industries is under
license.
All other trademarks are the property of their respective owners and may not
be used without permission.
For more legal information related to this product and to its use in your
specific region, and for more detailed information about Zound Industries and
partner & license information, please visit the website:
www.urbanears.com. The user is recommended to
visit the website regularly for up-to-date information.
Zound Industries International AB, Central plan 15, 111 20 Stockholm, Sweden
FCC STATEMENT
FCC ID: 2AAGF-JUNO
WARNING: Any changes or modifications to this device not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. This equipment
complies with the FCC radiation exposure limits set forth for an uncontrolled
environment. This device must not be co-located or operated in conjunction
with any other antenna or transmitter.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning thee equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
U.S. responsible party, contact information: Zound Industries USA, Inc. 260 W 39th Street Suite 1101, New York, NY 10018, USA Telephone number: 646-214-1003
IC STATEMENT
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
This Class B digital device complies with Canadian ICES-003.
CAN ICES-003 (B)/NMB-003(B)
IC: 11153A-JUNO
Zound Industries International AB
True wireless headphones / Urbanears Juno
Zound Industries International AB / China
Refer to the date code sticker on the bottom of this product
XXXXXXXXX
Important safety instructions
Not suitable for children under age three. Contains small parts, which may be
a choking hazard.
Long-term exposure to loud music or sounds may cause hearing loss. To prevent
possible hearing damage, do not listen at high volume levels for long periods.
Electrical products, cables, batteries, packaging, and the manual, should not
be mixed with general household waste. For proper recycling, please take these
products to a designated collection point where they will be accepted free of
charge or return them to your local retailer. Correct product disposal saves
resources and prevents negative effects on human health and the environment.
To prevent possible harm to the environment or human health from uncontrolled
waste disposal, dispose of defective rechargeable battery at special
collection points or return them to your specialist dealer.
Warnings
- Set your sound source to low volume before using the headphones.
- Do not use these headphones when operating a motor vehicle, a bicycle, machinery or where your inability to hear outside sounds may present a danger to you or others.
- Using these headphones limits your ability to hear noises around you, regardless of listening volume.
- Keep away from fire, water, and high voltage equipment.
- Do not modify, disassemble, open, drop, crush, puncture, or shred these headphones.
- Do not heat above 113°F (45 °C).
- Do not short-circuit the internal battery or its cells.
- In the event of cell leakage, do not allow the liquid to come in contact with the skin or the eyes.
- The internal battery is not end-user replaceable.
- Only use the included charging case with the Urbanears Juno earbuds.
Disclaimer
Stated play time is calculated using a random selection of music, played at
medium volume.
Hereby, Zound Industries International AB, declares that this product is in
compliance with 2014/53/EU and the UK The Radio Equipment Regulations 2017
(SI2017/1206).
Maximum RF transmit power: Bluetooth (2402-2480 MHz) < 20 dBm
The full text of the EU and UKCA declaration of conformity is available at the
following website: urbanears.com/doc
UK Authorised Representative:
Zound Industries UK LTD, 24 Old Queen Street, London, SW1H 9HP, United Kingdom
Designed in Stockholm • Produced in China
References
- Headphones & Earbuds | Urbanears
- Declaration of Conformity | Urbanears
- Anatel — Agência Nacional de Telecomunicações
- Headphones & Earbuds | Urbanears
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>