Screeneo Innovation PPA1007 IR and Bluetooth Remote Control User Manual

: June 4, 2024
: Screeneo Innovation

Table of Contents

Specification
Keys and Functions
Matching of remote control
Battery
FCC Warning
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Screeneo Innovation PPA1007 IR and Bluetooth Remote Control User Manual

Specification

Product Specification Parameters

Keys and Functions

Matching of remote control

The remote controller for this projector bounded with IR and Bluetooth function together. To use remote controller in Bluetooth model, please follow the following guide to pair remote controller with projector at the first using.
Matching of remote control

Battery

| Battery
---|---
①| Do not mix old and new batteries or different brands of batteries
②| Please install the battery correctly according to the polarity mark when using
③| When the remote control is not used for a long time or the battery is exhausted, please remove the battery to prevent leakage
④| disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion
⑤| leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas
⑥| a battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas
⑦| Do not charge non-rechargeable batteries
⑧| Please place the spent battery in the designated disposal area

FCC Warning

FCC ID: 2ASRT-PPA1007

15.19 Labeling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.

15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Absorption Rate (SAR) information:
This device meets the government’s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.

FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. This device was tested for typical body-worn operations with the head 0mm and 10mm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain a appropriate separation distance between the user’s body and the back of the device. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided. Use only the supplied or an approved antenna.