FirsTime Co Bronze Big Time Wall Clock Instructions

FirsTime Co Bronze Big Time Wall Clock Instructions

TROUBLESHOOTING IMMOBILE, LOOSE AND DANGLING HANDS.

1. Use a new battery and NOT a used battery.
2. Be sure hour and minute hands are NOT crossing or touching each other. If they are, you can adjust the hands by slightly bending them apart.
3. Check that the center pin (or second hand) is firmly pushed in.
4. If hands are still not moving after checking the above, please reference the hands replacement instructions.

INSTRUCTIONS TO REPLACE DAMAGED HANDS

1. Remove the second hand or center pin by gently pulling up and away from the clock.
2. Repeat this with the minute and then the hour hand.
3. Have your new set of hands ready. First, place the hour (short) hand onto the shaft and gently push down. Point hand to the 12 position.
4. Second, place the minute (long) hand onto the shaft and gently push down. Point hand to the 12 position.
5. Next, place the second hand or the center pin on top of the shaft and gently push down. If using a second hand, it should point to the 12 position.
6. With all hands securely on the shaft and in the 12 position, set the time by moving the dial on the rear of the clock in either a clockwise or counterclockwise direction until the hands indicate the correct time.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>