HEANTLE 123456 Front Door Lock Set User Manual

HEANTLE 123456 Front Door Lock Set

PACKAGE INCLUDED

INSTALL THE DEADBOLT LOCK

Step 1: Install the deadbolt
You may have to adjust your bolt length. Make sure the slot in the bolt is centered in the hole.
Note: Keep the deadbolt in unlock status during install­ation.

Step 2: Install the touchscreen
Route the cable through the door BELOW the bolt. Align the spindle as shown and push the touchscreen onto the door.

Step 3: Install the backplate
Route the cable under the bolt and through the hole on the bottom of the backplate. Secure the backplate with screws. Make sure the outside touchscreen is straight before tight­ening screws all the way.

Step 4: Connect the cable
Tuck the cable and connect to the connector on the main­board.

Step 5: Facing to the keypad, check the door opening direction and set the switch button.

Step 6: Set knob direction and secure the lock to the door.

Step 7: Install batteries and slide the cover on.

That wasn’t so bod, was it?
Your lock is now installed! Let’s do a final test!

1. Close your door.
2. Extend and retract the bolt using the inside knob.
3. Make sure the bolt retracts smoothly.
4. 0pen your door.
5. Hit the # sign to extend the bolt for one-touch locking.
6. Now enter a manager user code 123456 # for unlocking.

QUICK SET UP

The default admin code is 123456. It’s required that you set up a New admin code before programming.

Note:

1. All codes you set must be 4-9 digits.
2. Before setting a new admin password, all fin­gerprints can be unlocked.

Note: Up to 50 Fingerprints can be entered continuously. After succeed green light flash, you can keep entering other fingerprints by five times pressed.

Note: All user codes will be deleted except the ad min code.

Note: All stored fingerprints will be deleted.

Note:

1. Rotate the thumb turn to lock and unlock the door once after setting it to activate auto lock function.
2. Time (00) is for turning off the auto lock.

Note: This function is only used when auto lock is ac­tivated. Lock and unlock once for release.

Note: In vacation mode, only the admin code or physi­cal key can be used to unlock.

Note:

1. The lock will only be unlocked by admin code or physi­cal key from outside, all of user codes and fingerprints will useless.
2. Turn the thumb turn or press reset button again to relase.

TWO WAYS FOR RESET

Method 1

1. Slip the battery cover off.
2. Rotate the thumbturn to lock and unlock the door once.
3. Take down one battery and wait for 3 seconds.
4. Put the battery back.
5. After keypad turns blue, press the reset button which is under the door knob for 5 seconds (keypad turns red during reset progressing).
6. After you hear the beep twice, Enter 000# and the keypad will flash green means reset successfully.

Method 2

1. Take down the back panel, make sure batteries are installed, keep the IC wire (cable) connected.
2. Press the inside reset button around 2-3 seconds, the ke­ypad will flash red > Release the reset button until you hear the beep twice > The keypad flashes green twice, reset su­ccessfully.

Frequently Asked Questions

How to fix the backward issue? (one-touch# sign for locking, but it’s unlocking.)

CUSTOMER SERVICE
Questions about your new Fingerprint Deadbolt? Let us help you!
Toll Free(US): 1-888-971-6866
customerservice-lk@hotmail.com

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>