make it real 2562 Color Fusion Lip Gloss Maker User Manual
- June 15, 2024
- make it real
Table of Contents
make it real 2562 Color Fusion Lip Gloss Maker User Manual
SETTING UP THE LIP GLOSS MAKER
-
Make sure to properly protect the work surface before setup.
-
Stick each foam pad onto the bottom of the lip gloss maker as shown.
-
Snap the crank into the lip gloss maker. DO NOT TRY TO TURN IT.
-
Unlock the left plunger by turning it counterclockwise until the wing is pointing toward you.
-
Pull the plunger up until it stops and rotate it clockwise to lock it in the upper position.
-
Repeat steps 4 to 5 with the right plunger, turning it in the opposite directions.
FILLING A LIP GLOSS TUBE
-
Pick a tube and screw it onto the lip gloss maker.
-
Open both doors of the lip gloss maker to reveal the inside.
-
Select a color combination from the chart. Pick the first lip gloss cartridge required for the recipe. Turn and release the fop and bottom caps. Keep both caps nearby.
-
Using the holding tab, insert the lip gloss cartridge into the left side of the lip gloss maker.
-
The lip gloss cartridge should be in the upright position and the tab should rest in the inner groove.
If not positioned correctly,
lift the lip gloss cartridge with the tab and reposition it until it’s fully
upright. -
Pick the second lip gloss cartridge for the recipe and repeat steps 3 to 3.
-
Unlock the left plunger and lower it until you feel it touching the lip gloss cartridge inside. Do not apply any pressure.
-
Rotate the plunger clockwise until a small amount of lip gloss is poured into the tube.
If no lip gloss comes out,
apply a bit more pressure down on the plunger. Relock it afterwards. -
Repeat steps 7 to 8 with the right plunger.
-
Close both doors of the lip gloss maker.
Each lip gloss cartridge can be
used 4 times! The height of the plungers will vary depending on how many times
the lip gloss cartridge has been used before.
-
Holding the lip gloss maker with your left hand, VERY SLOWLY turn the crank COUNTERCLOCKWISE with your right hand. A lip gloss swirl will be created.
-
When the tube is almost full, the crank will stop turning. DO NOT FORCE IT and wait 5 seconds for the pressure to be released.
-
Unscrew the tube from the lip gloss maker.
-
Insert an applicator scraper into the tube.
-
Screw on an applicator wand. Your lip gloss is now ready to use!
RESETTING THE LIP GLOSS MAKER FOR THE NEXT USE
- Rotate the crank clockwise until the lip gloss maker is at its lowest position and stops. **DO NOT FORCE IT.
**
-
Unlock both plungers and lift them up. Lock them back inthe upper position (refer to steps 1 to 3 of the §9tUP section).
-
Open both doors of the lip gloss maker and gently remove both lip gloss cartridges.
-
Clean the nozzles of the lip gloss cartridges using a tissue. Push and turn both the top and bottom caps back onto each cartridge.
-
The lip gloss maker is now ready to fill another lip gloss tube!
USING THE CARRYING CASE
-
Choose the lip gloss tube that you want to carry with you and insert the tube into the crystal case.
-
Insert the top of the wand applicator into the carry-case cap firmly.
-
You can now turn the carry case cap to open the crystal case and apply lip gloss to your lips!
COLOR AND SCENT COMBINATIONS
WARNING!’!
CHOKING HAZARD – small parts. Not suitable for children under 3 years. Do
not eat or drink. In case of contact with eyes, rinse immediately with plenty
of water. In case of allergic reaction, stop using immediately, seek medical
advice. This product may stain certain fabrics and surfaces. Keep away from
clothing and protect your work surface.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>