ECOFLOW Rigid Solar Panel Mounting Feet User Manual
- June 4, 2024
- ECOFLOW
Table of Contents
Rigid Solar Panel Mounting Feet
User Manual
V1.0
\
Disclaimer
Please read this User Manual and ensure you understand it fully before using
the product. Please keep this User Manual properly for future reference. Any
incorrect usage may result in severe injury to the user or others, damage to
the product, or loss of property. By using this product, the user will be
deemed as having understood, recognized, and accepted all the terms and
contents of the User Manual, and will be responsible for any incorrect usage
and all consequences arising therefrom.
EcoFlow hereby disclaims any liability for any losses due to the user’s
failure to use the product in accordance with the User Manual.
In compliance with laws and regulations, EcoFlow shall have the final right to
interpret this document and all related documents for this product. Any
update, revision, or termination of the contents thereof, if necessary, shall
be made without prior notice, and users may visit the official website of
EcoFlow for the latest information on the product.
Safety Instructions
This system does not possess any compliance with residential structural codes
and should not be used in place of residential photovoltaic power generation
systems.
Please install the solar panel on a stable and firm flat surface to avoid
loosening or falling.
Modules can be mounted on top of a fixed outdoor object, and the system
designer and installer shall be responsible for the compliance of the design
of their supporting structure.
When installing systems on a vehicle or vessel, please observe relevant local
and national laws and regulations.
Place the solar panel on a soft material to avoid friction with the ground
during installation.
Check the connections of parts every three months to ensure that they are
intact.
Operation Requirements
Do not use third-party accessories, which may cause system instability and the
resulting risk is not covered by the warranty.
This product is suitable for EcoFlow rigid solar panel series, the models are
as follows: 100W rigid solar panel (EF-SG-M100), 400W rigid solar panel (EF-
SG-M400-04), it is not recommended to carry other solar panels for use.
This solar system is to be installed by a qualified solar installation company.
For more installation requirements, please refer to the solar panel user
manual.
Packing List
1. Z-shaped bracket
2. Hex Self-Drilling Screw
3. Hex Bolt (with Nut)| 4. M6 Large Washer
5. M6 Flat Washer
6. M6 Spring Washer
---|---
Recommended Tools
A 100W solar panel needs 1 set of support brackets, and a 400W solar panel
needs 2 sets of support brackets.
Be sure to wear protective gloves and safety goggles during installation to
avoid being scratched.
The tools required for installation are not included in the list, please
purchase them yourself.
Installation Steps for 100 W Rigid Solar Panel
Apply the structural adhesive to
the corresponding area (the surface contacting with the frame) of the z-shaped
bracket.
Fix the Z-shaped bracket on the solar panel mounting hole with hex bolts, and
make sure that the mounting feet are evenly and symmetrically distributed.
Apply structural adhesive to the
round mounting holes of the Z-shaped bracket and then secure the module to the
installation position with hex self-drilling screws.
Installation Steps for 400 W Rigid Solar Panel
Apply the structural adhesive to the corresponding area (the surface
contacting with the frame) of the z-shaped bracket.
Fix the Z-shaped bracket on the solar panel mounting hole with hex bolts, and
make sure that the mounting feet are evenly and symmetrically distributed.
Apply structural adhesive to the round mounting holes of the
Z-shaped bracket and then secure the module to the installation position with
hex self-drilling screws.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>