bewello BW1018 Milk Frother User Manual
- June 15, 2024
- bewello
Table of Contents
bewello BW1018 Milk Frother User Manual
The product has safety solutions, however, please read the safety regulations
carefully and, in order to avoid possible injuries and damage, only operate
the kitchen appliance as described in the user manual. Disabling the security
solutions, modifying or disassembling the product is strictly prohibited!
If you sell or lend the device, please include this user manual with the
device so that the user can study its contents.
Signs used in in the user manual:
This symbol warns of the risk of injury.
This sign warns of the risk of injury from the use of electricity.
Words used in the user manual
DANGER: pictograph warning of imminent danger of serious injury or death.
CAUTION: word warns of serious injury and danger to life.
ATTENTION: The word warns of minor injuries.
NEED TO KNOW: Warns of possible material damage.
The milk frother is only suitable for heating milk or cocoa or frothing milk.
Do not use the device with other liquids or solid foods.
The device is designed for residential use! The device cannot be used in
industrial conditions because it may be damaged and its service life may be
shortened. The device may only be operated indoors, in a room with IP20
protection.
Safety regulations
CHOKING HAZARD! Please keep the packaging of the device away from
children, as it may lead to suffocation.
The storage location must be chosen in such a way that children cannot
accidentally access it. Children must not play with the packaging of the
device.
DANGER! Never operate the device with wet hands! Touching the device,
including its mains plug and cable, with wet hands is strictly prohibited! The
device must only be connected to alternating current with the correct
voltage.
Do not fill the device with milk if it is already switched on. Do not use the
device near tubs, dishes or sinks containing water or liquids.
DANGER! Make sure of the environmental regulations before use! It is
forbidden to use the device in an explosive environment! In case of use in
special places (e.g.: filling stations, baths, etc.), local safety regulations
must be followed!
DANGER! The device may only be used for its intended purpose! During use, take care of the health and safety of those around you (especially children). The device may only be used by persons who have read and understood this user manual and are able to operate the device accordingly!
Persons with reduced mental, physical or sensory abilities may not use the device! Children must not use the device!
DANGER! Only connect the device to a mains socket which safe operation you
are convinced of, or which was installed by a specialist according to the IEC
60364-1 standard.
In the vicinity of water blocks (e.g. near the kitchen sink), it must only be
connected to a socket with an RCD! Before each use, make sure that the device
and the network cable and connector are undamaged! Only undamaged devices may
be operated! If you experience any damage, do not use the device, contact a
specialist service During use, take care of the integrity of the network
cable, avoid edges and objects that could cause damage to the surface of the
cable. Avoid the use of extension cables and distributors, because they are a
source of danger during operation. Only use splash-proof extension cables with
a cross-section of at least 3 x 1 mm2 . Always disconnect the device from the
mains when you are not using the device or if there is a storm nearby.
Maintenance and cleaning work may only be carried out with the mains plug
unplugged. Always disconnect the device’s network cable from the network by
the plug, never hold the cable.
DANGER! To operate the device, you must choose a place with sufficient
ventilation, never use it directly next to a wall, in a corner or near a
curtain. The device must be protected from direct sunlight and heat sources!
Place the device on a horizontal, flat surface so that it cannot accidentally
tip over during operation.
DANGER! BURN INJURY! Some parts of the device may get hot during milk
heating! Never touch hot surfaces! When heating milk, handle the device only
by the handleNever reach into the working machine with your hands or any
objects, or leave any objects inside the machine! During use, make sure that
no part of your body, e.g. hair, hangs in the container! Start frothing and
heating the milk only when the lid fits properly on the container.
CAUTION! Do not use the device if it has previously been dropped or bumped
against something and it is visibly damaged! Do not use the device if you
experience leaks. The safety equipment must be used as intended, it is
strictly forbidden to modify or eliminate them!
Attention! Do not fill the tank with cleaning agents! Only use the device
above freezing point, 0 °C, to avoid condensation and electric shock. Never
leave the device unattended when it is connected to the mains power source!
Do not use the device for heating or steaming! Protect the device from
moisture and water! Do not store the device outside, exposed to large
temperature fluctuations or weather conditions.
Activities that damage the device: Do not pour solvents, solvent-containing
cleaning agents, acid, gasoline, thinner, acetone, or other liquids into the
device! It is only safe to operate with the right amount of milk.
Operating regulations
NEED TO KNOW! Always operate the device with the correct amount of milk.
The marking on the side of the container helps with this. If you use the
device with too little milk, the milk frother may overheat and be damaged,
while using it with too much milk, the milk may froth and run out. The amount
and quality of the milk foam can depend on many factors: the milk fat content,
temperature, the selected brand, and whether you use preserved or fresh milk.
Tip: If you don’t know how a given milk will behave, try using less milk
to avoid spilling the milk.
Always stop the operation of the device before removing the pot from the base!
The manufacturer and distributor shall take no responsibility for damages and
personal injuries resulting from improper use!
Parts of the device
- Tank lid
- Foam blender
- Glass cup
- Handle
- Heating disc
- Housing
- On-off switch
- LED indicator
- Power cable
- Spare blender
Use
Place the appropriate mixing head in the bottom of the container. Use the
ribbed head for foaming, and the smooth one for heating.
Pour the indicated amount of milk into the container and place it on the base,
then close it with the lid.
Tip: Use cold, fresh, semi-skimmed or full-fat milk for frothing.
Modes
- Making warm milk foam: Briefly press the power button, the LED indicator lights up red and the production of the desired milk foam begins. Preparation time: ~150 seconds, temperature: 60-65 °C. When the milk has reached the desired temperature, mixing and heating will stop automatically. If necessary, you can interrupt the heating and mixing process by pressing the button again. You can then remove the pot from the base. The hum of the device’s fan can still be heard for a while.(max. 250 ml)
- Making cold milk foam: Press the power button twice until the LED indicator lights up in blue and the desired milk foam begins to be produced. Preparation time:: ~150 mp. (max. 250 ml)
- Cocoa / milk heating Press the power button three times until the LED indicator lights up purple and the desired drink begins to be produced. Preparation time: ~180-250 sec. (max. 400 ml)
NEED TO KNOW! How to clean: Clean the device after every use! This
prevents the milk from drying in the container! Unplug the device before
cleaning! Do not use strong, caustic chemicals or abrasives to clean the
device. The measuring cup part also contains electrical parts, so make sure
that it does not come into contact with liquid during cleaning. Clean the
bottom part and the outside of the housing only with a soft, dry microfiber
cloth. Never submerge the device in water!
Waste management: The product and packaging are made from valuable,
recyclable materials. Recycling materials reduces the amount of waste and
protects the environment. (Valid in the European Union and all other European
states that participate in selective collection) According to directives
2012/19/EU, electrical waste and appliances cannot be thrown away as household
waste. Old appliances must be collected in order to maximize the recycling of
raw materials, thus reducing their impact on people’s health and the
environment. The crossed-out bin symbol is on all products for which separate
collection is mandatory. Consumers should check with their local authorities
for more information.
Technical details
Supply voltage: AC 220 – 240 V – 50/60 Hz
Current: 2.4 A
Power: 550 W
Capacity: 400 ml
Color: white
Modes: cold and warm milk frothing
Protection: IP20
Material: plastic, borosilicate glass
Size: 165 x 115 x 210 mm
Weight: 0.84 kg
Symbols
Documents / Resources
|
bewello BW1018 Milk
Frother
[pdf] User Manual
BW1018 Milk Frother, BW1018, Milk Frother, Frother
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>