M L ML Battery Charger Instructions

ML Battery Charger
Instructions

Setting the MūL Batery Charger input voltage.

Please be sure to verify that the input voltage on your MūL batery charger is set to the correct input voltage for your region. The switch can be moved using a small screwdriver or similar device.
Please note that not all MūL batery charger models have the input voltage selection switch.

| No power to charger, no batery connected.
---|---
| Batery atached, but no power to the charger.
| Power to charger, batery atached and charging.
| Power to charger, batery fully charged -or- charger is plugged in but there is no batery connected -or- issue with fuse holder or blown fuse.

PLEASE NOTE:
If LED 1 is red and LED 2 is green, but your bateries are not charging, please note the following:

1. Verify the input voltage is correctly set per above diagrams.
2. Verify the batery is correctly connected. Both LEDs will illuminate when the charger has power but there is no batery connected.
3. An open fuse circuit will cause both LEDs to illuminate any time the charger is connected to a power and a batery, regardless of the state of the batery.
   o Verify the fuse is installed and not blown.
   o The fuse cover is fully engaged and the fuse is seated and connected properly.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>