DREO DR-HAF001 Tower Fan 42 Inch Plus Table Fan 9 Inch User Manual

: June 15, 2024
: DREO

DREO DR-HAF001 Tower Fan 42 Inch Plus Table Fan 9 Inch User Manual

IMPORTANT SAFETY INSTRUCTIONS

READ ALL CAUTIONARY MARKINGS ON THE APPLIANCE AND SAFETY INSTRUCTIONS IN THE USER MANUAL BEFORE USE.

Do not cover the air in let and outlet while in operation.

Do not use the fan near flammables and combustibles.

General Safety

Children shall not play with the appliance. Cleaning and maintenance shall not be performed by children without supervision.
Use the appliance as described in the user manual only. Any other use not recommended in the user manual may cause fire, electrical shock, or personal injury.
This appliance can be used by children aged above 8 years and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of this appliance in a safe way and understand the hazards involved.

Operation Safety

Place the appliance on a flat, dry surface before use.
Do not immerse in water and any other liquids.
Do not use the appliance until the base is installed.
Do not insert your fingers, pencil and any other objects into the grilles while in operation.
Do not dismantle, repair, or modify. All servicing should be performed by qualified personnel.

ASSEMBLING YOUR TOWER FAN

Assembly Instructions

When using the appliance for the first time, remove the wraps and attach the parts by following the steps below.
Press down on edges to click two base halves together.
Run the cord through the center hole.
Fit the base onto the bottom of the fan by aligning the arrows on the underside.
Rotate the base counterclockwise to lock in place.
Thread the cord through all REAR cord keepers and put the fan upright.

CAUTION

Do not operate the tower fan if the base has not been installed.
Make sure to thread the cord through all rear cord keepers.

Package Contents

KNOWING YOUR TOWER FAN

Control Panel

Power Button
- Turn power on/off
Mode Button
- Switch between Normal/Natural/Sleep/Auto Mode
Fan Speed Button
- Adjust airflow volume (1-6 levels)
Timer Button
- Select to set a timer (0-12h)
Oscillation Button
- Adjust airflow direction

LED Display

USING YOUR TOWER FAN

General Operations

Press to turn on, and to choose a working mode.
Press to adjust the airflow volume.
Press to change the airflow direction.
Press to set a timer.
Press to turn off the tower fan.

Working Modes

Working Modes Sleep Mode (Mute Auto On)

Fan speed decreases every 30 minutes.
Speed decreases by two levels at most and will remain constant if at level 1:

For level 6:6-5-4
For level 5: 5-4-3
For level 3:3-2-1
For level 2:2-1
For level 1:1

Auto Mode
Fan speed adapts to the ambient temperature.

Normal Mode
Fan runs at the constant speed.

Natural Mode
Fan runs at alternating speeds

Additional Features

Mute (remote control only) Press to turn on/off the button sounds.

Speed/Temp Switch (long press)

The display shows the fan speed by default. Long press the Mode button to switch speed to temperature,

Timer

When the fan is ON, press the Timer button repeatedly to set a timer (1-12h). When the timer ends, the fan will stop running automatically. To cancel set the timer to O
hour.

Note: Despite wig fretum zo fon speed/temperature after 10 seconds

Memory

If the fan stays connected to the electrical outlet after tuming OFF, the fan will operate under the previous settings (except timer setting) when turned ON again.

Display Auto Off

Display turns off after 1 minute (after 5 seconds in sleep mode).
Wake up the display with any button

Getting the Most out of Your Tower Fan

Remove any tall obstacles that might block the airflow from the fan.
Combine with your AC unit to get cooler air throughout the room.
Position the tower fan closer to you to get more direct airflow.
Place a bucket of ice in front of the fan for an extra cooling boost.

Remote Control

User Servicing Instructions (Fuse)

This appliance features a fused safety plug that protects against overload or short-cumuli situations. If the fuse blows, please cut off power and follow the below instructions or consult justified electrician.

Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord
Open fuse cover. Slide open fuse access cover on top of attachment plug towards blades.
Remove fuse carefully. Push the fuse from the other side to rοπονε the fuse
Risk of fire. Replace fuse only with 2.5 Amp, 125 Volt fuse
Close fuse cover, Slide closed the fuse access cover on top of attachment plug

WARNING

Risk of fire. Do not replace attachment plug. Contains a safety device fuse) that should not be removed. Discard product if the attachinent plug is damaged

My fan won’t turn on!

Make sure that the cord is connected to a powered outlet and the mains voltage corresponds with the voltage indicated on the fan.
Check if the fuse has blown. If the fuse has blown, please refer to page 13.

My fan is shaky and wobbling!

Place the fan on a flat, level surface.
Incorrect installation might also cause shakiness. Please refer to the assembly instructions in page 3-4. Note that the power cord must be run through all three keepers.

My fan is making vibration and noise!

Place the fan on a flat, level surface.
Be sure not to insert anything into the air inlet and outlet.

If your problem is not listed or still persists, please contact our Customer Support (see page 15).

DREO CUSTOMER CARE

Default 12-Month Warranty

This appliance is covered by Dreo warranty for 12 months from the date of Its original purchase.

Extend Your Warranty

Extend your warranty by registering your new appliance on our website https://dreo.com/warranty.

The warranty will not apply in cases of:

Accident, misuse, or repairs performed by unauthorized personnel.
Any unit that has been tampered with or used for commercial purposes.
Normal wear and tear of wearable parts.
Use of force, damage caused by external influences.
Damage caused by non-observance of the User Manual, e.g. connection to an unsuitable mains supply or noncompliance with the instructions.
Partially or completely dismantled appliances.
Defects caused by or resulting from damages from shipping or from repairs, service, or alteration to the product or any of its parts that have been perform ed by a repair person not authorized by Dreo.

We can only provide after-sales service for products that are sold by Drea or Dreo authorized retailers and distributors. If you have purchased the appliance from a different place, please contact your seller for return and warranty issues.

290-1688

support@dreo.com

www.dreo.com

Mon-Fri, 9:00 am-5:00 pm PST/PDT

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. This equipment has been tested and found to comply with the limits for a Consumer ISM equipment, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular instillation

Please note that changes or modifications of this product is not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.”

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help

www.dreo.com
Shenzhen Hesung Innovation Technology Co., LTD
26F, Bldg A7, Creative City, Shenzhen, China.