MWS 100-240V Electric Shaver User Manual

100-240V Electric Shaver

User Manual

1. Protective cover
2. Head cover
3. Head cover release button
4. Switch button
5. LED display
6. Fixed frame| 7. Knife net
8. Temple knife
9. Sideburn push button
10. Power adapter
11. Cleaning brush
12. Instruction for use
---|---

Precautions

Warning: After separating the Handel part from the power cord, the Handel part can be cleaned in water.
Note

1. Keep the power adapter dry. It is forbidden to pull or plug the power adapter plug with wet hands to prevent electric shock.
2. Please make sure that the voltage marked on the power adapter matches the local power voltage.
3. If the electric shaver is damaged, please use it in a hurry.Please deal with the fault according to the type of fault, and hand it over to the maintenance department of our company for repair if necessary.
4. People (including children) who are physically unsound men tall disabled,and lack relevant experience and knowledge (including children) must use it under the supervision and guidance of their guardians.
5. When using the power adapter, please grasp the shell of the power adapter tightly, and it is forbidden to pull the power adapter cord forcefully.
6. This product can only be charged with the matching power adapter. Do not use any accessories not provided by our company with this product.
7. The power adapter cord cannot be replaced. If the cord is damaged, the power adapter should be discarded.
8.  Please check whether the knife net is damaged or deformed before use, so as not to damage your skin.
9. Please wash the electric shaver with clean water, but do not soak in water for a long time.
10. Do not use salt water, hot water above 60°C, thinner, gasoline, alcohol or other chemicals to clean the electric shaver.
11. When traveling, make sure to cover the protective cover on the electric shaver to protect the electric shaver blade net.
12. During use and charging, the electric shaver will slightly heat up. This is a normal phenomenon, please rest assured to use it.
13. Please do not charge the electric shaver for a long time.
14. It is recommended to charge, use and store the electric shaver at a temperature between 5°C and 35°C. Do not expose it to direct sunlight or other heat sources Place to store electric shavers.

Instructions

Recharge

1. When the voltage input of the charger is too high, the exclamation mark on the LED display of the electric shaver will keep flashing to indicate that the input voltage of the shaver is too high and the shaver is not charging (Picture 1)
2. Insert the tail plug of the power adapter into the electric shaver and keep it connected, then insert the plug of the power adapter into the power socket (Picture 2)
3. When the power is turned on, the display will light up, and the digital stream will be on and off to indicate that it is charging.
4. When the corresponding power is reached, the corresponding power number will be always on (image 3) it can be fully charged after 1 hour of Continuous charging. When fully charged, the numbers 90 and Already full are always on, which means that the shaver has been charged(Figure 4).

Endurance
The LED display of this product can display the remaining power. A fully charged electric shaver can provide up to about 90 minutes of shaving time, but the shaving time may be shorter than, expected due to differences in shaving habits, cleaning habits and beard types.
** The electric shaver can only be charged with the matching power adapter;
The electric shaving power can directly shave when connected to the power adapter for charging. Shaving**

1. Press the switch button to turn on the electric shaver (Picture 5)
2. Let the electric razor blade net move on the skin against the growth direction of the beard and make a straight and round movement (Figure 6).
3. The hair on the neck can also be shaved (Picture 7)
4. Push the push button of the temple knife upwards to make the knife pop out, and can trim corners, moustache or beards (Figure 8).

Shave fished
Press the switch button again to turn off the electric shaver, and then close the protective cover to prevent damage to the blade net.
** Please don’t shave when the knife net is damaged,so as not to damage your skin.
Travel lock**

1. Long press the on/off button of the electric shaver for 3 seconds, and the LED display of the electric shaver indicates that the safety lock is locked (Figure 9).
2. To unlock, you need to press and hold the switch for 3 seconds while the lock symbol flashes 3 times to unlock and turn on the shaver (Figure 10).

Smart display content

1. When the load of the electric knife is too large, the electric shaver will automatically shut down, and the LED display of the electric shaver prompts that the electric shaver is locked and protected (Figure 11)
2. When the electric shaver needs to be cleaned, the LED display of the electric shaver prompts “please clean” (Figure 12).

Water rinse clean

1. Before cleaning, you must separate the electric shaver from the power adapter and press the switch button to the off state(Figure 13).
2. Press the head cover release button to open the head cover (Figure 14).
3. The knife net can be washed directly under the faucet (Figure 15). The effect of washing with warm water is better. Do not use hot water over 60C for washing.
4. After rinsing, drain the excess water, so let it dry naturally.

Store
It is recommended to dry the electric shaver first and cover it with a protective cover to prevent damage to the blade net and avoid accumulation of dust in it.
Replace the cutter head
In order to obtain the best shaving effect, the construction of the blade net is replaced every two years, please be sure to use the original Hailang electric shaver blade net.

Care and maintenance

Deep cleaning

1. In the open head cover, turn the release button of the fixed frame counterclockwise to take out the fixed frame(Figure 16).
2. Take out the knife net
3. Separate the force net and clean the knife net with a cleaning brush(P icture 18)
4. After cleaning, install the knife net and fixing frame into the head cover in reverse order.

Maintenance

1. It is recommended to clean the knife net every two months.After cleaning, drip lubricating oil into the knife net and the front edge of the temple for lubrication and maintenance(Figure 19).
2. Regular cleaning of the electric shaver can ensure better shaving results.

**** Do not use towels or paper towels to wipe the electric razor blade net, as this may damage the blade net

Environmental protection : The built-in rechargeable battery contains substances that may pollute the environment. Before discarding the electric shaver, be sure to remove the battery or send the electric shaver to an officially designated recycling station to dispose of the battery. you can also send used electric shavers to the company The designated maintenance department will disassemble and recycle the battery.Remove the battery: Cut off the power and let the electric shaver run until the power is exhausted. Unscrew all the screws on the electric shaver. disassembled, the battery is released.

Product Specifications
Product Model:
Product Size :1606060mm
Rated voltage:100-240V~
Rate Frequency :50/60Hz
Rate input power :8W

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>