Hazebase 51700100 PRO 1500 W Base Hazer with DMX Installed Own Case Instructions

Table of Contents

Hazebase-51700100-PRO-1500-W-Base-Hazer-with-DMX-Installed-Own-Case-
PRODUCT

Unboxing and Setup

When you receive your BaseHazerPro Hazer, follow these steps to set it up:

Open the packaging and remove the hazer and its case.
Inspect the hazer for any visible damage. If you notice any, contact customer support.
Place the hazer in a suitable location, ensuring proper ventilation.
Connect the power cable to the hazer and plug it into a power outlet.
If using DMX control, connect the DMX cable to the hazer and the DMX controller.

Operating the Hazer

Follow these steps to operate the BaseHazerPro Hazer:

Ensure that the hazer is powered on and ready for operation.
If using DMX control, set up your DMX controller according to its user manual.
Adjust the desired haze output using the control knobs or DMX controller.
Monitor the fluid level and refill when necessary. Refer to the user manual for fluid refilling instructions.
After use, turn off the hazer and disconnect it from the power source.

Maintenance and Cleaning

To ensure optimal performance and longevity of your BaseHazerPro Hazer, follow these maintenance guidelines:

Regularly clean the exterior of the hazer using a soft cloth and mild cleaning solution.
Check and clean the air filters to prevent clogging.
Inspect the hazer for any signs of wear or damage. Replace any faulty parts immediately.
Refer to the user manual for detailed maintenance instructions.

Q: Is the BaseHazerPro Hazer suitable for outdoor use?
- A: No, the BaseHazerPro Hazer is designed for indoor use only. Using it outdoors may cause damage to the unit and pose safety risks.
Q: Can I use third-party haze fluids with this hazer?
- A: While it is recommended to use the manufacturer-approved haze fluid, you can use compatible third-party haze fluids. However, using non-approved fluids may affect performance and could void your warranty.
Q: How often should I clean the air filters?
- A: It is advisable to clean the air filters every month or more frequently if you notice reduced haze output or increased noise levels.
Q: Can I control the haze output remotely?
- A: Yes, if you have a DMX controller connected, you can control the haze output remotely by adjusting the DMX settings on your controller.

The article is no longer in our assortment.

Even more quiet, even more precisely adjustable
DMX serial-production
1500 W / 230 V / 50 Hz
Also available as 110 V version (only within the US)
Integrated timer
Amptown flightcase serial-production
Low liquid consumption
Only 1 minute warm-up time
Small dimensions
5 liter container can be replaced without refilling
Only use original Hazebase fluid for flawless operation
Other fluids may damage the unit or cause malfunction
Short warm-up time
Big tank capacity
Control via wired remote control (optional); Analog 0-10 V; DMX
Made in Germany
For further information about this product, please refer to the Data Sheet under “Downloads”