3StyleScooters TS360 Stunt Trick Scooter User Guide
- June 15, 2024
- 3StyleScooters
Table of Contents
Ages 8+
TS360 Shadow
Stunt Scooter Instructions & Care Guide
TS360 Stunt Trick Scooter
Important
This document must be read by Parent and Rider prior to use of the scooter.
Note: Illustrations are for demonstration purposes only and may not
reflect exact appearance of product.
Note: Illustrations are for demonstration purposes only and may not
reflect exact appearance of product.
Please read these instructions before first using your scooter!
Scooting is a great activity but must be done safely. Read the below safety
and maintenance tips and ensure that your child is alert and aware when
scooting outdoors and that your scooter is in good condition.
ADULT SUPERVISION IS RECOMMENDED AT ALL TIMES
Important!
Adult setup required
Each time the scooter is used the scooter should be set up correctly.
Ensure adjustments clamps, buttons and fasteners are sufficiently tightened
and secured. Failure to do so could result in injury!
Warning – Protective Equipment MUST Be Worn
Protective equipment should be worn at all times e.g. a helmet, gloves, knee-
pads, and elbow-pads.
|
---|---
Avoid roads
Not to used on roads or places with active motor vehicles| Store Indoors
Damage from exposure to extreme weather is not covered under warranty
Practice makes perfect
Riders should develop riding ability in a small private area first prior to
scooting in a public place. This will help to ensure they do not endanger
themselves or others whilst in motion
Safety First
Protective equipment should be worn at all times e.g. a helmet, gloves, knee- pads, and elbow-pads.
Know Your Scooter
Building Your Scooter
RISK OF TRAPPING OR INJURY
Step 1
Insert the handlebar stem base into the clamp.
Step 2
Insert the handlebar stem base and clamp onto the front fork.
Step 3
Align the grips of the handlebar perpendicular to the front wheel ready to
fasten into place.
Step 4
To fasten your clamp, first tighten one bolt a small amount.
Step 5
Now move to the second bolt on the opposite side and tighten a similar small
amount.
Step 6
Return to the first bolt and continue to alternate until securely fastened.
Important!
Check clamp tightness regularly to ensure bolts are securely fastened.
Setting up your Scooter
Change your Spin Speed
To change your Stunt Scooter deck spin speed, adjust the deck bolts as shown
in the steps below:
Tighten for a Slow Spin
Turn bottom rotator disc clockwise to tighten deck rotation and then same for
top rotator to lock into position.
Release for a Fast aSpin
Turn bottom rotator disc anti-clockwise to un-tighten deck rotation and then
same for top rotator to lock into position.
Scooting Guidance
| Environment
Do not scoot on dangerous paths such as oily, wet, sandy, frozen or very
uneven surfaces
---|---
| Speed
We recommend that you should not go any faster than 5km per hour in order to
prevent accidents
| Inclines & Declines
Stunt scooters are intended to be used on steep inclines and declines. Please
be aware however that brake effectiveness will be reduced on these
|
Rain
Do not ride in the rain as this could cause the scooter to slip / loose
traction and will decrease brake effectiveness
| Low Light
Do not allow your child to ride the scooter in low light conditions
unsupervised and without high-vis attire
Scooter Maintenance
| Modifications
Do not make any changes or modifications to the scooter, doing so will
invalidate the scooter’s warranty.
---|---
| Deck, Handles &
Clamp Cleaning
It is suggested to disassemble and clean this area of the scooter every 6
months, being sure to remove any dirt or grime that has built up from use.
| Handlebar Alignment
Always check the handles are firmly tightened to the deck via the clamp. If the
front steering bar is not fixed tightly, you can use an Allen Key and Wrench to
tighten the bolt. Use firm pressure but avoid overtightening.
| Wheels, Bearings and Brake
The wheels, wheel bearings and brakes may become worn out after regular use
but can be purchased from our website and easily changed.
Simply remove the axle bolts with two Allen Keys and slide the wheel off its
fork, replace with a new wheel or replace wheel bearings, then reattach the
wheel.
| Cleaning
If you wish to clean your scooter, wipe with a damp cloth to remove dirt and
dust. Do not use alcohol or ammonia based cleaners or solvents as they may
damage the surfaces, dissolve some components or soften the decals / adhesive.
Using Your Scooter
| Maximum Rider Weight
100kg Max.
---|---
| Recommended Height
Min. 1.35m – Max. 1.8m
Stunt To Try
The Bunnyhop
The bunny hop or bunnyhop, is a trick that allows the rider to launch their
scooter into the air.
Step 1
Push off with your back foot so you’re moving on the scooter.
Step 2
Bend your knees and then push up with your legs.
Step 3
Pull up with your arms whilst pushing up with your legs.
Step 4
Let the back wheel lift off the ground as you’re pushing and pulling up.
Step 5
Let the scooter drop back to the ground.
Visit3style.co.uk
Need spare parts?
3Style Scooters, Unit 30 Broomfield House, Lanswood Park, Elmstead Market,
Colchester, Essex, UK.Company Registration No: 14219459
Connect with us!
Documents / Resources
|
3StyleScooters TS360 Stunt Trick
Scooter
[pdf] User Guide
TS360 Stunt Trick Scooter, TS360, Stunt Trick Scooter, Trick Scooter, Scooter
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>