Sika 515318 Concrete Fix Instruction Manual
- June 15, 2024
- Sika
Table of Contents
Sika 515318 Concrete Fix
Product Information
Specifications
- Brand: Sika
- Product Type: Sealant
- Application: Joint sealing
- Surface Preparation: Clean, structurally sound, dry, and grease-free surfaces
- Crack Width: At least 1/4 inch
- Crack Depth: Up to 1/2 inch (use Sika Backer Rod for deeper cracks)
Product Usage Instructions
Site Prep & Procedure
- Ensure that all surfaces are clean, structurally sound, dry, and free from grease.
- Remove any dirt, oil, moisture, or old sealant from the surfaces.
- Use a chisel and hammer to widen the crack to at least 1/4 inch.
- Clean out debris from the crack using a wire brush.
- If the crack depth exceeds 1/2 inch, use Sika Backer Rod to control the depth.
- Gun the sealant into the joint.
- Dry tool the sealant as necessary.
- Clean up all tools, spills, and excess material with clean rags after use.
- If needed, use a paint thinner or other approved solvent (such as acetone) following the solvent manufacturer’s precautions.
For more detailed information, please refer to the Product Data Sheet available at usa.sika.com/retail.
FAQ (Frequently Asked Questions)
Q: What surfaces can I use this sealant on?
A: This sealant is suitable for use on clean, structurally sound, dry,
and grease-free surfaces.
Q: Can I apply the sealant directly to the crack without any preparation?
A: No, it is important to prepare the crack by widening it using a chisel
and hammer, and then cleaning out any debris with a wire brush.
Q: What should I do if the crack depth exceeds 1/2 inch?
A: If the crack depth exceeds 1/2 inch, you should use Sika Backer Rod to
control the depth before applying the sealant.
Q: How should I clean up after using the sealant?
A: After use, clean up all tools, spills, and excess material with clean
rags. If necessary, you can use a paint thinner or other approved solvent
(such as acetone) following the solvent manufacturer’s precautions.
MATERIALS
- Safety glasses and gloves
- Utility knife
- Cartridge of Sikaflex®+ Concrete Fix
- Chisel
- Standard caulk gun
- Hammer
- Wire brush
- 1/2 inch wide tuck pointing trowel
SITE PREP & PROCEDURE
-
Make sure that all surfaces are clean, structurally sound, dry and free from grease. Remove all dirt, oil, moisture,and/or old sealant.
-
Widen crack using a chisel and hammer to at least 1/4” and use wire brush to clean out debris.
If crack depth exceeds 1/2” use Sika Backer Rod to control depth. -
With a utility knife, cut the tip of the nozzle at a 45° angle to the desired bead size, then puncture the seal inside of the nozzle and place the cartridge into a caulking gun.
-
Wearing protective gloves and safety goggles, hold the gun at a 45° angle and squeeze the gun handle to start the flow of sealant. Apply sealant in one continuous application to prevent any air entrapment. One 10.1 oz. cartridge will yield 24 linear feet of sealant in a 1/4” bead.
-
Gun sealant into joint and dry tool as necessary.
-
Clean up all tools, spills, and excess material with clean rags after use. If necessary, use a paint thinner or other approved solvent, such as acetone, following the solvent manufacturer’s precautions.
usa.sika.com/retail y Refer to Product Data Sheet for more information.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>