KUMIO ICM1550 Ice Maker Countertop Instruction Manual

IC E MAKER
INSTRUCTIO N MANUAL
Model: ICM1550

THANK YOU FOR CHOOSING OUR ICE MAKER
PLEASE READ THE MANUAL CAREFULLY BEFORE OPERATING

IMPORTANT NOTICES

When using an electrical appliance, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury, including the following:

1. Read all instructions before using.

2. Remove all packing material and carefully check your ice maker to ensure it is in good condition and that there is no damage to the ice maker or power cord and plug.

3. Before using the Ice maker for the first time, please wait 2 hours after positioning it, and keep the transparent lid open for at least 2hours

4. Pure water is not allowed to be used on this unit, spring water is recommended.

5. Ensure the voltage is compliant with the voltage range stated on the rating label, and ensure the earthing of the socket is in good condition.

6. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.

7. Do not upend this product or incline it over a 45 ℃ angle.

8. To protect against risk of electric shock, do not pour water on cord, plug and ventilation, immerse the appliance in water or any other liquid.

9. Unplug the appliance after using or before cleaning.

10. Keep the appliance 8cm from other objects to ensure the good heat releasing.

11. Do not use the accessories which are not recommended by Manufacturer.

12. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

13. Do not use the appliance close by flames, hot plates or stoves.

14. Do not switch on the power button frequently (ensure 5min. interval at least) to avoid the damage of compressor.

15. Metal sheet or other electric objects are not allowed to be inserted into the appliance to avoid fire and short circuit.

16. Do not use outdoors.

17. Never clean with scouring powders or hard implements.

18. Please keep the instruction manual.

19. Warning: Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.

20. This appliance is intended to be used in household and similar applications such as
    – staff kitchen areas in shops, offices and other working environments;
    – farm houses and by clients in hotels, motels and other residential type environments;
    – bed and breakfast type environments;
    – catering and similar non-retail applications

21. When positioning the appliance, ensure the supply cord is not trapped or damaged.

22. Do not locate multiple portable socket-outlets or portable power supplies at the rear of the appliance

This symbol indicates the refrigerant R600a and the non-metallic materials of the appliance are flammable. It’s a warning symbol. Warning: Risk of fire / flammable materials.
WARNING: When positioning the appliance, ensure the supply cord is not trapped or damaged.
WARNING: Do not locate multiple portable socket-outlets or portable power supplies at the rear of the appliance.
Children aged from 3 to 8 years are allowed to load and unload refrigerating appliances. To avoid contamination of food, please respect the following instructions:
– Opening the door for long periods can cause a significant increase of the temperature in the compartments of the appliance.
– Clean regularly surfaces that can come in contact with food and accessible drainage systems.
– Clean water tanks if they have not been used for 48 h; flush the water system connected to a water supply if water has not been drawn for 5 days.
– If the refrigerating appliance is left empty for long periods, switch off, defrost, clean, dry, and leave the door open to prevent mould developing within the appliance.)

SPECIFICATIONS

Model Number: ICM1550
Voltage: 120V/60Hz
Power Consumption: 150 W
Daily Ice Output: 15kg / 24 hours
Ice Storage Capacity: 1.8L/700 g
Water Reservoir Capacity: 2.3 L
N.W:
G.W :
Ice Making Mode: big and small
Compression-type Refrigeration: 120V/60Hz
Cooling Agent: R600a environmental friendly refrigerant
Max overall dimensions(W XD XH): 344 x 296 x 372 mm
Packing Dimensions(L XW XH): 350 x 340 x 425 mm

DESCRIPTION

FEATURE

• Quick ice making
• Two different sizes of ice can be made
• Prompt when the ice is full and water is insufficient
• Bullet ice
• 10 pcs ice can be made in 8-9 minutes.

WARNING

1. During transportation, do not tilt the machine more than 45 degrees, do not reverse the machine. This may damage the compressor and the sealing system.
2. Remove all packing materials, check the machine carefully and make sure that the machine, power cord and plug are normal.
3. The machine should be on a level surface. To ensure sufficient ventilation, the distance of the back of ice maker to the wall should be at least 150 mm, it should be away from the oven, radiator or other heat source.
4. Before using the machine for the first time, place the machine and keep the ice basket removed for at least two hours.
5. Make sure that the home voltage is consistent with the voltage indicated by the machine.
6. Distilled water is not allowed. Mineral water is recommended. The transparency of ice making with pure water is higher than that with tap water.
7. Under different temperature conditions, the transparency of ice made with different water is different. The transparency of ice is higher in higher temperature environment, and the transparency of ice will decrease with the increase of ice making time.

CONTROL PANEL OPERATION

POWER: Power Supply
S: small ice selection
ICE FULL: water full alarm
SELECT: Mode selection
L: big ice selection
ADD   WATER: water shortage alarm

1. Plug in the power supply and the “L” indicator flashes. Press the “POWER” button, the “L” indicator light is always on, the machine will start the deicing function first, then automatically make the ice according to the selected mode, deicing after the completion of ice making, and then enter the deicing function, such a cycle.
2. SELECT: select the ice size mode, and the default mode is large ice making mode for each startup. Select the mode: “S” for small ice selection, “L” for large ice selection and the corresponding indicator light is on. The production time of small ice is more than 8 minutes and that of large ice is more than 9 minutes.
3. ADD WATER: water shortage alarm: when the light is red, it means water shortage in the water tank. You need to add water and press the “POWER” button to restart the machine.
4. ICE   FULL: ice full alarm. When the ice reaches the maximum amount of ice storage container, the “ICE FULL” light flashes and the machine stops. At this time, the ice needs to be poured out. When the ice position is lower than the full sensor position, the machine will restart automatically.
5. CLEAN: Press the “POWER” button for 3 seconds, and the machine will enter the self-cleaning mode. The water pump will pump water and the water box will pour water. After 5 cycles, the machine will stop and enter the standby mode.

OPERATION INSTRUCTIONS

Step 1
Take out the ice basket and add water to the water tank.
Note: There is a maximum scale MAX in the reservoir. The water should not exceed the MAX position. If the water exceeds the maximum scale MAX, you need to open the bottom drain plug, release the excess water, and reinstall the water tank.
Step 2
Plug in the power and press the “POWER” button to start the machine.
Step 3
Select the size of the ice you want to make, the default mode is large ice.
**CAUTION**

1. When the indoor temperature is lower than 20 degrees, please choose small ice. When the indoor temperature is higher than 30 degrees, it is recommended to choose large ice.
2. The three cycles used for the first time, the ice produced is small and irregular.
3. When the ice basket is full, please take out the ice immediately. The ice will melt if the time is too long.

CLEANING & USE GUIDANCE

1. Clean the ice basket and water tank frequently. When cleaning, unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside and the outside surface of the Ice maker. Do not spray Ice maker with chemicals or diluted agents such as acids, gasoline or oil. Rinse thoroughly before starting.
2. Keep ventilation openings in the appliance enclosure, or in the built-in structure, clear of obstruction. Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
3. Reuse the machine after being idled for a period of time, it may not have enough water to pump for air retard, in this case, the water shortage indicator “ADD WATER” will be on. Repress “POWER” button to restart the ice maker is okay.
4. To ensure the cleanness of ice, please change water for water reservoir at least once one day. If do not use for a long time, please drain the water out and clean it up.
5. If the compressor takes a strike action for shortage water, fully water or interruption of power supply, it will delay for 3mins to start up after restarted.
6. When the machine is used again after a long time, please start the cleaning function first. Purified water is recommended.

TROUBLE SHOOTING

normal.
Water shortage indicator light is on| 1. There is no water 2.The pump is full of air| 1. Add to some water until it reaches MAX position
2. Press POWER button to restart
Indicator lights on
display are not on| Blown fuse/ No power| Replace fuse / Turn power on
The Ice made is too large and with pieces sticking together.| 1. Wrong ice size selected 2.Ice of previous cycles left in the water tray| 1. Select small size
2. Unplug the power and plug it in again.
The ice making process was correct, but no ice came out?| 1. The compressor has no refrigerant
2. Compressor damaged
3. Fan motor damaged| Call the service hotline
All indicators flash at the same time.| 1. The water box is blocked by ice.
2. The motor is stuck, or the motor falls off, or the motor is damaged
3. Micro switch damaged| 1. Unplug the power and plug in the power again, and press the POWER button. After 3 minutes, the machine will restart automatically.
2. Call the service hotline
The machine has been working, but the water
has been warming| Solenoid valve failure| Replace the solenoid valve
When the ice is full, the machine does not display the ice full Icon| Ice full sensor damaged Solar light interference| 1. Replace the ice full sensor
2. Call the service hotline
The ice is not clear at all| 1. Water supply pump does not work
2. Tap water was used| 1. Call the service hotline to replace the water pump
2. Use purified water

WARNING

1. If the power cord is damaged; it must be replaced by the manufacturer, its service agent or a similarly qualified person in order to avoid a hazard.
2. Fill with potable water only.
3. It is normal for the compressor and condenser surface to reach temperatures between 70°C and 90°C during operation and surrounding areas may be very hot.
4. Due to fast freezing, ice cubes may opaque. This is air trapped in the water and will not affect quality or taste of ice.
5. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
6. Children should be supervised to ensure that they do not play with the appliance.
7. Do not immerse in water.

Correct Disposal of this product
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.

WARRANTY

Limited two-year warranty
This warranty is available to consumers only. You are a consumer if you own a kumio ice maker that was purchased at retail for personal, family or household use. Except as otherwise required under applicable law, this warranty is not available to retailers or other commercial purchasers or owners.
We warrant that your kumio ice maker will be free of defects in materials and workmanship under normal home use for 2 years  from the date of original purchase. If your kumio ice maker isprove to be defective (Non Man- damaged)within the warranty period, we will offer free replacement or reimburse.
Thank you for using our products. Please contact support@kumio.net or Customer Service Online if you have any questions.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>