WTT70GBT 7 Kg Semi Automatic Top Load Washing Machine User Manual

User Manual

WTT70GBT 7 Kg Semi Automatic Top Load Washing Machine

SEMI AUTOMACTIC WASHING MACHINE
MODEL NO. : WTT70GBT
WTT90GBO

THANK YOU FOR CHOOSING OUR PRODUCT
Our washing machines are developed with high-technical and quality standards, with features to offer you even more comfort.
Read all instructions before using this appliance as this book contains valuable information about operation, care and service. Keep it in a safe place.
Graphics Used Above may Differ from the Actual Product.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Don’t put hands into the tub when it’s working.
The power cord of the washer is connected by Y shape. If must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

INTRODUCTION OF PARTS

Control Panel

NAME OF PARTS

1. Wash water inlet
2. Wash timer
3. Wash Selector
4. Spin Timer
5. Spin water inlet
6. Wash cover
7. Wash tub lid
8. Pulsator| 9. Twin tub
10. Water inlet hose
11. Spindry Safety Lid
12. Power cord
13. Spinner Lid
14. Spin inner Lid
15. Drain hose
16. Lint filter
---|---

Note: Graphics may be different with the actual machine.

Safety Precautions

1. Make sure that the washing machine is plugged to a 3 pin/SA electrical outlet and earth terminal is provided on the outlet.
2. Unplug the power supply cord when you do not use it.
3. To disconnect the washing machine from electrical mains completely, pull out the plug and do not pull it from the mains cord.
4. Don’t allow your kids to look inside the washing machine while running.
5. This washing machine is meant for washing clothes with water as a medium. Do not use petrol or other chemicals. This can result in fire and damage.
6. Do not use water with temperature exceeding 40 degree C, as this deforms the plastic parts in the machine. (Do not pour hot water in an empty tub)
7. Keep the machine away from flames and inflammable material. Do not expose the washing machine to direct sunlight or rain. Also avoid placing it in humid locations.
8. Take Precautions not to pierce the control panel membrane sheet.
9. Do not connect the earth wire to a phone wire, lightening rod.
10. Do not press the button with an awl or a pin.
11. Avoid overloading of wash and spin tub.
12. Do not use wash & spin tub for water storage.

Care & Maintenance

Be sure to remove the power plug from main power supply before cleaning the machine and filter

Net Filter Cleaning

1. Pull out the lint filter from the lock use fingers pull out at the part of the Lint Filters side.
2. Turn the net inside out and clean with water.
3. Set back to the original position. Insert the bottom first as shown press down and lock as the arrow.

Cleaning the Wash Tub

1. After washing is complete, fill fresh water above the level of pulsator without adding clothes.
2. Run the machine for 1-2,minutes turn the knob to “DRAIN” position when pulsator is still rotating.
3. When water is completely drained out, turn the knob to “WASH” position.
4. Finally turn off the machine.

Recommended washing procedure

1. Open the water tap and fill the wash tub about half way.
2. Put in the laundry detergent and allow it to disperse well.
3. Put in the clothes to be washed and add water in accordance with the amount of cloth load.
4. Set the WASH TIMER as desired depending on the fabric type and the degree of soiliage.
5. When washing is finished, set the Drain Selector to Drain

NOTE:

1. Ensure that the clothes rotate freely during wash, if not, reduce the cloth load, (By removing some clothes from the machine)
2. Water Droplets may be seen inside the tub or the outer body when unpacked at customer end; This is neither a Machine Malfunction nor Product has been used earlier; If found, It may refer to quality verification for any leakage inside product.

Rinsing and Drying Rinsing
There are 2 ways to rinse:

1. Rinse : Fill the wash tub appropriately for the number of clothing being washed. Set wash timer for 15 Minutes. (Rinse will begin) and clothes will Rinse for a period of 15 Minutes.
2. Intermediate Spin Rinse: Put clothes inside the Spin Tub. Put Water Supply selected to SPIN TUB. Open the water tap and keep it open for one to two minutes and then close tap. Spin for one minute. When rinsing is over, set the Drain Selector to DRAIN. Do not keep the water tap open when the Spin tub is rotating, else machine will malfunction.

How to Spin
Put the laundry into the spinner tub by putting the small-sized laundry in the bottom area to keep the balance of the tub. (figure 1)
Place the SPINNER CAP in the tub as shown in the figure 2.
Close firmly the inner and outer lids of the spinner tub.
Select the spin time to 2 – 5 min.

SPINNING TIME FOR LAUNDRY

1. Cotton clothes: 5 min.
2. Delicate clothes (Thin synthetic fiber, sarees etc.): 2 min.
3. Sweater (Synthetic fiber): 2 ~3 min.
4. Underwear (Knitting clothes): 3 ~ 5 min.
5. Heavy Clothes (Bed Sheet, Towel etc.): 5 min.

HINTS FOR SPINNING

If there is a sound from the spinner, open the spinner lid then try to distribute the laundry evenly.
If the lid is open while the spinning function is working, the machine will stop within 5 ~ 10 seconds. If it is still running, contact Brand service desk.

REFERENCE
TABLE 1. DETERGENT GUIDE

WASH LOAD| 1.2∼2.5 kg| 2.5∼3.8 kg| 3.8∼5.0 kg| 5.0 kg or ABOVE
---|---|---|---|---
Water Level| Low| Medium| High| Over Flow
Amount of Detergent| 40 gm| 50 gm| 60 gm| 64 gm
Amount of concentrate Detergent| 25 gm| 30 gm| 38 gm| 40 gm
Amount of Softener| 22 ml| 26 ml| 29 ml| 35 ml

Table 2- LAUNDRY GUIDE

Amount of Laundry| Clothes| Synthetic Fiber| Cotton| Heavy Stained Clothes
---|---|---|---|---
System
1.2 ∼ 2.5 kg| Washing Time| 2 ∼ 5 minutes| 7 ∼ 10 minutes| 10-15 Minutes
Wash Selector| GENTLE| NORMAL| NORMAL
2.5 ∼ 3.8 kg| Washing Time| 7 ∼ 10 minutes| 10 ∼ 15 minutes| Wash 15 minutes
Wash Selector| GENTLE| NORMAL| NORMAL
3.8 kg and above| Washing Time| Wash 10-15 minutes| Wash 15 minutes| Wash 15 minutes
Wash Selector|  GENTLE| NORMAL| NORMAL

Notes:

• If the wash load and water volume do not match, clothes may damage/water splash may occur.
• The quantity of wash load varies depending on fabric type, thickness and size of the clothes.
• Adjust the water level/wash load as required by carefully watching the movement of the clothes in the tub.

Trouble shooting guide

• Is the power cord firmly plugged in?
• Is the timer turned to a suitable point except “OFF”?
• Motor has been provided with “TOP” (Thermal overload protector). This will protect the motor from burning due to
overheating caused by various variable factors such as overload voltage, frequency variation, etc. In such case motor supply will get off, thus stopping the motor. Wait for approximate 1/2 hour till motor cools to normal temperature.
Restart the machine to see if motor functions normally.
Spin dryer basket does not operate| • Is the spin dryer cover closed?
• Is there any cloth dropped between the basket and tub?
• Is the laundry gathered to one side of the spin dryer basket?
•Distribute clothes evenly.
Drain not happening| • Is the end of the drain hose guide located at an excessive height?
•Is the lint stuck to the plunger valve?

Trouble Shoot Table

b. Transmission belt burst
c. Pulsator is blocked by something| a. Switch on plug
b. Assemble the transmission belt
c. Remove the blockage
The pulsator rotates too slowly| a. Belt becomes loose
b. The flexible screw of motor is loose| a. Tighten the belt or replace it
b. Tighten the belt and the screw
Abnormal noise and vibration| a. The clothes in the spin-dry tub are unbalanced
b. Something was stuck between pulsator and wash tub| a. Place the clothes neatly
b. Remove it.
Water leaks from wash tub| a. The hose is not tightened with the wash tub| a. Tighten it

Usage instructions
Step 1

• Turn the knob to desired wash program (Normal/Gentle)
• Wash: Put clothes in the wash tub with water and detergent. Start the Wash function.
• Pulsator will rotate and wash the clothes for 15 minutes

Step 2

• Place the clothes in the spin tub.
• Select spin timer for the time period required.
• This is required to remove excess soap
• Will result in the first drying process for the clothes.

Step 3

• Transfer clothes to the wash tub.
• Rinsing: Fill in water only and select wash time for 3-4 minutes.
• After this is complete, select the drain mode to drain out water

Step 4

• Drying: Transfer clothes to spin tub and select spin time to complete final drying process.

SPECIFICATION

WIRING DIAGRAM

DISPOSAL OF OLD ELECTRIC APPLIANCES
According to Waste Electrical & Electronics Equipments’ (WEEE) directive, WEEE should be separately collected and treated. If at any time in future you need to dispose of this product, please DO NOT dispose of this product with other household waste. Please send this product to WEEE collecting points where available.
The following marking/symbol on the product or carton indicates that the product and its accessories/parts should not be disposed of with other household waste at the end of working life. Please separate these items from other types of waste and recycle them responsibly for the conservation of the environment and collective well-being.
For more information on this subject, please log on to
http://www.sansuiworld.com/e-waste or call us on Toll Free number – 1800 419 3777.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>