AKAI AKG-804 Aiwa Glass Kettle User Manual
- June 14, 2024
- AKAI
Table of Contents
AKAI AKG-804 Aiwa Glass Kettle
IMPORTANT SAFEGUARDS
- Read all instructions before using.
- Before connecting the kettle to the power supply, check that the voltage indicated on the appliance (underside the kettle & base) corresponds with the voltage in your home. If this is not the case, contact your dealer and do not use the kettle.
- The attached base cannot be used for other than intended use.
- Do not operate the appliance without load to avoid damaging the heat elements.
- Unplug from the outlet when not in use.
- Do not let the cord hang over edge of table counter or touch hot surface.
- Do not place on or near a hot gas or electric burner or in a heated oven.
- Should you accidentally allow the kettle to operate without water, the boil-dry protection will automatically switch it off. If this should occur, allow the kettle to cool before filling with cold water and re-boiling.
- Ensure that kettle is used on a firm and flat surface where the children can’t touch, this can prevent from overturning the kettle to damage the person or kettle.
- To protect against a fire, electric shock or personal injury, do not immerse cord, electric plugs or kettle in water or other liquids.
- Always take care to pour boiling water slowly and carefully without tipping the kettle too fast.
- Be careful when opening the lid for refilling when the kettle is hot.
- Close supervision is necessary when any appliance is used by or near children.
- Do not touch the hot surface. Use the handle or the button.
- Extreme caution must be used when moving an appliance containing hot water.
- The appliance is not a toy. Do not let the children play it.
- The use of attachments that are not recommended by the appliance manufacturer may result in fire, electric shock or personal injury.
- While boiling water, avoid to contacting steam from the spout when water is boiling or just after it has switched off. Do not be anxious to uncover the lid.
- Unplug from outlet when not in use and before cleaning; Allow it to cool before putting on or taking off parts and before cleaning the appliance.
- Always ensure the lid is closed and do not lift it while the water is boiling. Scalding may occur if the lid is removed during the brewing cycles.
- If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
- Do not use the appliance for other than intended use.
- Do not move the unit while the kettle is switched on.
- The kettle can only use with the stand provided.
- If the kettle is overfilled, boiling water may be ejected.
- Do not use the kettle outdoors.
- This appliance can be used by children aged from 8 years and above if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved. Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised. Keep the appliance and its cord out of reach of children aged less than 8 years.
- Children shall not play with the appliance.
- Appliances can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
- This appliance is intended to be used in household and similar applications such as:
- Staff kitchen areas in shops, offices and other working environments;
- Farm houses;
- By clients in hotels, motels and other residential type environments;
- Bed and breakfast type environments.
- Save these instructions.
- This appliance has been incorporated with a grounded plug. Please ensure the wall outlet in your house is well earthed.
- WARNING: During the boiling process and when pouring out hot water, the lid must be kept closed at all time.
- The kettle is only to be used with the stand provided.
- CAUTION: Ensure that the kettle is switched off before removing it from its stand.
- The appliance must not be immersed.
- If symbol IEC 60417-5041 is marked on the appliance, the instruction shall state that surfaces are liable to get hot during use.
KNOW YOUR KETTLE
BEFORE USING YOUR KETTLE
If you are using the kettle for the first time, it is recommended that you should clean your kettle before use by boiling a full kettle of water twice and then discarding the water. Wipe the surface with a damp cloth.
NOTE: the max capacity of kettle is 1.7L.
OPERATION OF YOUR KETTLE
- To fill the kettle, remove it from the power base and open lid by pressing open lid button, fill with the desired amount of water, and then close the lid. Alternatively, the kettle may be filled through the spout. The water level should not exceed max marks or sit below min level. Too little water will result in the kettle switching off before the water has boiled.
- NOTE: Do not fill the water over the maximum level, as water may spill out of the spout when boiling. Ensure that the lid is firmly in place before plugging the power outlet.
- Position the kettle on the power base.
- Connect the plug into a power outlet. Press up the switch, the indicator will light up. Then start to boil the water, the kettle will switch off automatically once the water has boiled. You can shut off the power by turning off the switch at any moment during boiling water. If you want to boil water again, only turn on the switch directly to restart the kettle.
- NOTE: Ensure that switch is free of obstructions and the lid is firmly closed, the kettle will not turn off if the switch is constrained or if the lid is opening.
- Lift the kettle from the power base and then pour the water.
- NOTE: operate carefully when pouring the water from your kettle as boiling water may result in scald, besides, don’t open the lid while the water in the kettle is hot.
- The kettle will not re-boil until the switch is pressed again. The kettle may be stored on the power base when not in use.
BOIL-DRY PROTECT
- Should you accidentally let the kettle operate without water, the boil-dry protection will automatically switch off the power.
- If this occurs, allow the kettle to cool before filling with cold water before re-boiling.
CLEANING AND MAINTENANCE
Always disconnect the appliance from the power outlet before cleaning.
- Never immerse the kettle, power cord or power base in water, or allow moisture to contact with these parts.
- Wipe the appearance of body with a damp cloth or cleaner, never use a poisonous cleaner.
- Remember to clean the filter at intervals. For easier cleaning, detach the filter by press it directly, and then replace it after cleaning.
CAUTION: Do not use chemical, steel, wooden or abrasive cleaners to clean the outside of the kettle to prevent the gloss loss.
REMOVAL OF MINERAL DEPOSITS
Your kettle should be periodically descaled as the mineral deposits in tap water may form scale on the bottom of kettle so as to cause the operation less efficiency. You can use the commercially available descaler and follow the instructions on the package of descaler. Alternatively, you may follow below instructions using the white vinegar.
- Fill the kettle with 3 cups of white vinegar, then adding water to the amount so as to cover the bottom of kettle completely. Leave the solution in the kettle overnight.
- Then discard the mixture in the kettle, then filling the kettle with clean water, boiling and then discard the water. Repeat several times until the odor of vinegar has been flushes away. Any stains remaining inside the spout can be removed by rubbing with a damp cloth.
Correct Disposal of this product
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste bins. Used appliance should be delivered to the dedicated collecting points due to hazardous components, which may affect the environment. Do not dispose this appliance in the common waste bin.
Technical Specifications
- 220-240V~, 50/60Hz or 50-60Hz, 1850 -2200W
- Device is compliant with EU directives:
- Low voltage directive (LVD)
- Electromagnetic compatibility (EMC)
- Device marked CE mark on rating label
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>