Hearangel COMTA III Tactical Headset User Guide
- June 14, 2024
- Hearangel
Table of Contents
Hearangel COMTA III Tactical Headset
Product Components
- Foldable Headband
- Earcup Adjustment Arm
- Gel Ear Cushion
- Environmental Microphone
- Attenuation cushion
- Battery Compartment
- Earcup Shell
- Communications Microphone
- Connection (Both Earcups)
- PowerNolume Control
- Talkback microphone
- NATO plug
DETAILS
- Hearing protection.
- Folding headband with leather covering.
- Function: Pickup noise,Noise Reduction.
- Adjustable volume control.
- New design ear cup provide clear voice and comfortable support.
- Adjustable volume control.
- Type of battery: AAA x 2
- (not included battery)
- Use with Radio: Headset will connect to a Push-To-Talk (PTT). Please contact Technical Service to identify proper PTT Assembly.
Important: Please read, understand, and follow all safety information in
these instructions prior to use.
Retain these instructions for future reference. For additional information or
any questions, you should contact Technical Service
WARNING: The noise amplification produced by the speakers on the outside of the ear cups mav exceed the audio output from an incoming radio transmission.
Operation
- Open the headband.
- Slide out the cups. Tilt the top of the cup out, as the wire must be placed on the outside of the headband.
- Adjust the height of the cups by pulling the cup up or down while pressing the headband down.
- Press the cups in before collapsing. Leave about 4 mm (1 /8 “) of the headband wire visible.
- When the headband is to be collapsed, make sure to unplug the audio input jack.
- On and off: Press the “+ ” and “-” button at the same time, and hold for at least l seconds.
- Increase volume: Press the + (forward) button.
- Decrease volume: Press the – (rear) button.
- Use with Radio: Headset will connect to a Push-To-Talk (PTT).
- Please contact Technical Service to identify proper PTT Assembly.
Cleaning
Salt Water Cleaning
- Should the headset be exposed to salt water; remove the ear cushions and immerse completely in cold, fresh water and leave out to dry.
Storage
- When the headband is to be collapsed, make sure to unplug the audio input jack.
- All guide wires must be pushed in before the headband is collapsed. The ear cushions should lie flat against each other.
- When damp, turn the cups outwards. Remove the ear cushions to allow the attenuation cushions and electronics to dry then reassemble.
Replacing the Batteries
- Insert your fingers under the edge of the battery cover, loosen each side a bit.
- Lift off the entire cover.
- Remove the batteries when storing the hearing protector for a extended period of time.
- Check the function of the unit after replacing the batteries.
Removing/Replacing the Ear Cushions
- Insert your fingers between the foam and under edge of the ear seal. Pull straight out and it will snap away from ear cup.
- Insert the new foam and ear cushion by pressing it in until it snaps in place.
Contacts
- Brand Name: Hearangel
- Product Name: Noise Reduction Headset
- Product Model: COMTA HEADSET
- Manufacturer: Hearangel
- Address: shinanerlu8haozhiyi201fang,panyuquda shijiehuijiangcun,guangzh oushi ,guangdongsheng,511430,CN
- Name: JunBright Ltd
- Add: 51 Chalton Street London , England , NW1 1 HY
- Phone: +4407561533299
- E-mail: yldyx112@outlook.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>