BODEGACOOLER 12 Car Fridge Dual Zone WIFI APP Control Instruction Manual
- June 14, 2024
- BODEGACOOLER
Table of Contents
12 Car Fridge Dual Zone WIFI APP Control
One side of the display does not show the temperature and shows the “- -” symbol?
This indicates that the area is turned off. Press and hold + and – at the same time for 3 seconds to turn the area on/off.
https://www.amazon.com/ask/questions/TxD2Z3TDZC2LSG/ref=ask_dp dpmw_al_hza
Why does the temperature fluctuate constantly and not stabilize at the set temperature?
This is normal. The refrigerator display temperature (temperature sensing head) measures the temperature at the back end of the evaporator. When the display temperature reaches the set temperature, the compressor will stop immediately, but the refrigerant in the evaporator will continue to flow under the action of inertia. So there will be a brief display temperature of 2-3 degrees below the standard. When the temperature is higher than the set temperature 2 degrees compressor immediately restart, refrigerator internal cooling immediately, but need to pass capillary, refrigerant evaporator, such as long distance and arrived in thermal head position is increased a lot of heat, so there will be a show temperature higher than the set temperature or temperature varies more distant than the actual phenomenon. But the actual temperature inside the box will remain within a relatively small range of fluctuations.
Why is there a difference between the temperature shown on the display screen and the temperature I measured with the thermometer?
The refrigerator display temperature (temperature sensing head) measures the temperature at the back end of the evaporator. There will be differences due to different test methods and different places of measurement.
Why the have “Gollum, Gollum” sound?
This is the sound made by the refrigerant flowing in the capillary tube. Also the noise will be louder than usual at the moment the compressor starts. When the temperature stabilizes, the sound will be reduced. These are normal phenomena.
Condensation on the outside of the refrigerator or around the door seal?
This is because the moisture in the air encounter lower temperature refrigerator Shell, will naturally liquefy, condensed into water beads, is a normal phenomenon. Use cloth to dry the water beads on it.
How do I use solar panels?
The solar panels charge the power station. The power Station powers the refrigerator.
How to connect to the APP (QZ smart)?
- Open the refrigerator.
- Download the APP in the manual, register and open the APP.
- After entering the APP interface, click “Add Device” and select your refrigerator model.
- Follow the instructions on the page and press and hold the power button to turn off the refrigerator. After the refrigerator is turned off, click Next.
- Follow the prompts on the page, press and hold “+” and “-” at the same time, and stop when you hear a beep. Then click Next (check the box to confirm subscription listening).
- This step is very important, you need to confirm if the WIFI you are connected to is 2.4Ghz. Generally, the router will have two frequencies of WIFI signal, one is 5.0GHz and the other is 2.4GHz. car fridge can only recognize 2.4GHz signal, so we must connect to 2.4GHz WIFI. if you don’t know, you can click “setup method” to see how to set up how to choose.
- After confirming your phone is connected to 2.4GHZ WIFI, look for the WIFI named “smartlife XXXX” in the WIFI page and connect.
- After the connection is finished, return to the APP interface and open the refrigerator. the APP is set up and ready (about two minutes).