STARTRC DJI Mini 4 Pro LED Flash Propellers Instruction Manual
- June 14, 2024
- STARTRC
Table of Contents
STARTRC DJI Mini 4 Pro LED Flash Propellers
Introduction
The LED flash propeller was designed for Mini 3 Pro specially. There is 3 light modes, freely switch by one key. 3 purple halos will appear on the led flash propeller when drone flight in night, use with long exposure photography skill can take great-looking visual photos, also bring more funny to night flight.
Key features
- Transparent PC material, durable and good light transmittance;
- Rechargeable and reusable;
- Use with long exposure photography skill can take exquisite photos;
- New aerodynamic design, excellent noise reduction effect.
Specifications
Model No.: ST-1111344 | Colour: Transparent |
---|---|
Net weight: 64.5g | Product size: 153X24.5X 16.5mm |
Gross weight: 158.6g | Package size: 231X130.8×37mm |
Main material: PC | Capacity of battery: 30mAh |
Operating temperature: -10 °C~ 60°C | Storage temperature: -10°C~45°C |
Charging time: Approx. 1 hour | Battery life: Approx. 1.5 hours |
Instructions
- Press switch and starting up;
- There is 3 light modes: fast flashing mode, slow flashing mode and light keep on mode. press once switch to change one mode until the last mode, press then power off.
- LED colors are orange and color, purple color is appear on propeller during of working.
- When the device is charging, the indicator will be on and red, and the indicator will be off when full charged.
In the box
- LED Flash Propeller with marks “R” * 2
- LED Flash Propeller with marks “L” * 2
- Screwdriver* 1
- Charging Cable * 1
- Manual *1
Installation
- Remove the original propellers
- Propellers mounting position as shown in the figure: attach the propeller with mark “L” to the front left motor and rear right motor, attach the propeller with mark “R” to the front right motor and rear left motor.
- Match the propellers and motors by step 1, use original screws to mount the propellers, make sure the screws is tightening.
- Finish the installation.
Cautions
- Please stopping the motors and re-starting the motors again if 1 or more led flash propellers is not rotate when starting the motors until all propellers is rotating normally.
- There is maybe a warning prompt (motor is stuck or abnormal) appears on the remote controller when the led flash propellers is not rotate, Please do not worry, the abnormal prompt will be disappear when the led flash propeller is rotating normally.
- Only use the led flash propeller, DO NOT mix propeller types (original propeller not mix)
- The product has built-in Lipo battery, after first used or long time storage, please charging enough before use again.
- The LED flash propeller can not be folded.
Disclaimer
Thanks for purchasing STARTRC Mini 3 Pro LED flash propellers. Please read this statement carefully before using the product. Once using the product, it will be regarded as the approval and acceptance of all contents of this statement. Please use the product in strict accordance with this manual and pay attention to the precautions. We will not assume any responsibility for any loss caused by improper use.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>