Shuttle BPCWL02 Dual Gigabit Lan Rugged Embedded Box PC User Guide
- June 4, 2024
- Shuttle
Table of Contents
Shuttle BPCWL02 Dual Gigabit Lan Rugged Embedded Box PC
Product Overview
Front Panel
Back Panel
- Headphones / Line-out jack
- Microphone
- LAN port (supports wake on LAN)(optional)
- LAN port (supports wake on LAN)
- USB 3.0 ports
- HDMI port
- COM port (RS232 only)
- Power jack (DC-IN)
- Power button
- Connector for WLAN Dipole antennas (optional)
Begin Installation
For safety reasons, please ensure that the power cord is disconnected before opening the case.
- Unscrew the ten screws of the chassis cover and remove it.
Memory Module Installation
This motherboard does only support 1.2 V DDR4 SO-DIMM memory modules.
- Locate the SO-DIMM slots on the motherboard.
- Align the notch of the memory module with the one of the relevant memory slot.
- Gently insert the module into the slot in a 45-degree angle.
- Carefully push down the memory module until it snaps into the locking mechanism.
- Repeat the above steps to install an additional memory module, if required.
M.2 Device Installation
- Locate the M.2 key slots on the motherboard, unfasten the screw first.
- Install the M.2 device into the M.2 slot and secure with the screw.
- Please replace and affix the chassis cover with ten screws.
Powering on the system
Follow the steps (1-3) below to connect the AC adapter to the power jack (DC- IN). .Press the power button (4) to turn on the system.
- Press and hold the power button for 5 seconds to force shutdown.
- Do not use inferior extension cords as this may result in damage to your Box-PC. The Box-PC comes with its own AC adapter.
- Do not use a different adapter to power the Box-PC and other electrical devices.
VESA mounting it to the wall (optional)
- The standard VESA openings show where an arm/wall mount kit which is available separately can be attached
The Box-PC can be wall-mounted using a VESA compatible 75 mm x 75 mm wall/arm bracket. The maximum load capacity is 10 kg and mounting suitable in heights of ≤ 2 m only. The metal thickness of the VESA mount must be between 1.6 and 2.0 mm.
Installation of WLAN antennas (optional)
- Take the two antennas out of the accessory box.
- Screw the antennas on to the appropriate connectors on the back panel.
Ear mounting to the wall (optional)
- Follow the steps 1-2 to install the ear mount.
Using the Din Rail (optional)
Follow the steps 1-5 to affix the Box-PC on a DIN rail.
Safety Information
Incorrectly replacing the battery may damage this computer. Replace only with the same or equivalent as recommended by Shuttle. Dispose of used batteries according to the manufacturer’s instructions. Should any accessories be required, please contact Shuttle or your relevant supplier.
More information on this product can be found at: https://bit.ly/BPCWL02
Documents / Resources
|
Shuttle BPCWL02 Dual Gigabit Lan Rugged Embedded Box
PC
[pdf] User Guide
BPCWL02 Dual Gigabit Lan Rugged Embedded Box PC, BPCWL02, Dual Gigabit Lan
Rugged Embedded Box PC, Gigabit Lan Rugged Embedded Box PC, Lan Rugged
Embedded Box PC, Rugged Embedded Box PC, Embedded Box PC, Box PC, PC
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>