OMISOON QN12 Electric Heater Instruction Manual

OMISOON QN12 Electric Heater

INTRODUCTION

• Children of less than 3 years should be kept away unless continuously supervised.
• Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.
• Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
• This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.
• Children shall not play with the appliance. Cleaning and user maintenance shall not be done by children without supervision.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
• The appliance shall be installed in accordance with national wiring regulations.
• Please use in an environment at 15-40°C and less than or equal to 90% humidity
• Correct Disposal of this product
• This marking indicates that this product should not be disposed of with other household wastes throughout the EU.
• To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources.
• To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmentally safe recycling.

Specifications

Structure

Remote Control

1. Please push the locking latch in the direction of Arrow A, and pull out the pull notch in the direction of Arrow B at the same time.
2. Use 1 ‘CR2025’ Lithium battery (included).
3. Insert the batteries, and make sure that the positive terminals are in the correct position.
4. Install back the cover.

Instruction

Before use, please check all the parts are completed and undamaged. Also, check the applied voltage matches with the label （220-240V~， 50/60Hz）.

1. Plug in the power socket, purple light flickers, and the LED screen displays ‘–‘ with a ‘Beep’. It’s in the ‘stand-by’ status.

2. ON & OFF
   Press at the control panel, the heater runs at default mode (High-Heat Mode, the LED Screen displays 26°C), bright red indicator light on; Press again to stop;

3. Modes
   Press to choose between high heat mode (bright red light on), low heat mode (red light on) and Natural Wind (blue light mode)

4. Temperature Setting (17°C-37°C)
   When the heater is in Heating Modes (High or Low), press ‘+’ or ‘-’ to set the temperature value from 17°C-37°C. One press for 1°C, change with a ‘Beep’. Long press for 2 seconds to change the temperature value continuously. The numbers on the LED Screen will flashes 2 time to confirm.

5. Oscillating Function
   Press it will oscillate automatically, press again to stop;

6. Timer Setting
   When the heater is running, press for timer setting. Press ‘+’ or ‘-’ to set the timer from 0-24h.One press for 1h, change with a ‘Beep’. The heater will stop automatically at the set time.

7. Memory Function
   The heater will record the temperature and mode set in the last time. It will run as the last record when it turns on. (not including timer setting and oscillation setting) The memory function works only in ‘stand-by’ or ‘working’ status. When the heater is power-off, the record will lose and the setting is back to defaut.

Note:

• When the heater is covered or blocked by foreign objects while it’s heating, it might stop automatically due to overheating.
• With built-in tip-over protection, the heater will stop automatically when it is tilted.
• When it turns off, the PTC will stop heating immediately, please allow 15 seconds for the PTC to cool down while the fan still blows air before completely stopping.
• If the heater is turned off because of overheating, after it cools down, unplug the heater and then re-plug it to restart.

Warning

Please read and comply with all of the instructions and warnings provided in this manual before using the product, failure to comply with the instructions and warnings provided herein may result in inaccurate results or damage to the product itself. Ensure the plug fits properly into a polarized power outlet Although your heater is easy to operate, for your safety, the below warnings must be followed:

1. Please ask customer service for help when the electric wire is damaged.
2. Please make sure the heater is unplugged when the power fails and moves.
3. Please keep the heater out of reach of people: with disability, sensory handicaps, intellectual deficiency or lack of experience and general knowledge(including children ) unless the usage is fully under the watch and guard by their guardians.
4. Please switch off the heater and clean it with a soft cloth and neutral detergent when you find dirt on its surface to avoid discolouration or breakage.
5. Please pack it back into the original box and keep it in a cool and dry place when not in use for long.
6. DO NOT cover the heater to prevent overheat.
7. DO NOT touch the air outlet when the machine working to prevent burns.
8. DO NOT block the air inlet and keep more than 4 inches away from the wall.
9. DO NOT use the heater in an inflammable and explosive environment. At least 1 meter away from combustible materials to prevent fire.
10. DO NOT put it on obstacles and any unstable surface.
11. DO NOT twist or pull the cable.
12. DO NOT place the heater near the curtain or something else which is easy to be sucked in.
13. DO NOT pull the cable with wet hands to prevent electric shock.
14. DO NOT use the heater in or around the place, like the bathtub, sprayer swimming pool etc.
15. DO NOT put it under the power outlet.
16. DO NOT put any object or hands into the heater while it’s working.
17. DO NOT rinse directly with water.
18. DO NOT clean the heater with gasoline, alcohol or an organic detergent to avoid discolouration or damage.
19. DO NOT use the heater in conditions of high temperature, humid, dusty or volatile place of acid, alkali and oil.
20. This is not a toy. Children should be supervised to ensure they don’t play with the machine.
21. Do not use this heater if it has been dropped;
22. Do not use it if there are visible signs of damage to the heater;
23. Use this heater on a horizontal and stable surface, or fix it to the wall, as applicable.
    • WARNING: Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own unless constant supervision is provided.
    • WARNING: To reduce the risk of fire, keep textiles, curtains, or any other flammable material at a minimum distance of 1 m from the air outlet.
    • WARNING: In order to avoid overheating, do not cover the heater.
    • CAUTION — Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.

Maintenance

1. Always remove the plug from the power socket and wait for the heater to cool down.
2. Use a dry and soft cloth to clean only the external surfaces of the heater.
3. Never immerse the heater in water.
4. How to clean the rear dust gauze: take the net off the heater, and clean it with water and detergent. Install it back when it gets dry.
5. Pack it back in the original box and store it in a cool, dry place when not in use for a long time.
6. How to collect the electric power cord
   • A. Turn the heater upside down, winding the wire along the circle plate
   • B. Fix it by embedding the power cord into the notch

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>