HCP OVU11A IR-2-USB Transceiver User Guide
- June 14, 2024
- HCP
Table of Contents
**HCP OVU11A IR-2-USB Transceiver User Guide
**
User guide for IR-2-USB Transceiver OVU110001/01
- Function introduction
- R-2-USB Transceiver receives and translates IR command into USB HID
- 1pcs Red LED indicator
- ME & Cosmetic:
- Dimension: 104mm34mm12mm
- Top part: ABS Black C
- Bottom part : IR-ABS Black C
- Foam: with double side adhesive
- USB cable: Black, 1m
Plug n Play Transceiver which receives and translates IR command into USB HID
Off-the-shelves (retail) universal remote that has Verizon STB IR code support
can be used to control the Stream TV through IR by using the IR-2-USB
transceiver as the “intermediary
FCC ID:2AGOFOVU11A
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
FCC Caution
Please take attention that changes or modification not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
Note: This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>