Shenzhen Zijiang Electronics A4 Portable Thermal Printer User Manual
- June 4, 2024
- Shenzhen Zijiang Electronics
Table of Contents
Zijiang Electronics A4 Portable Thermal Printer
User Manual
A4 Portable Thermal Printer
Please click the below link to download printer drivers and other tools:www.cnfujun.com/d/44
|
---|---
https://www.lingmoyun.com/nip/index.html| https://youtu.be/AVAHuYlCfiE
List of Accessories:
Caution:
The printer has a built-in large-capacity battery, which can print about
200pcs A4 sheets of paper when fully charged. When the printer is charging,
please use a 5V/2A charger and a high-quality charging cable (it is
recommended to use a mobile phone charger that supports fast charging). If it
comes out the main reason such as the charger is not powered enough, the
charger is seriously hot or the charging is very slow, it should be caused by
the poor quality of the charging cable.
Please note: The power supply is too low to charge if plug in the USB
port of the computer.
Warning : Do not use uncertainties (CCC) inexpensive chargers, which
may cause “heat, fire, printer damage” etc.
FCC Caution：
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to
provide reasonable protection against harmful interference in a residential
installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet the general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>