amazon basics 250 Mid Back Office Task Chair Instruction Manual
- June 14, 2024
- amazon basics
Table of Contents
Office Chair/Task Chair
Supports up to 250 Ibs
Assembly Instruction
Congratulation on your buying of this premium office chair/task chair, which
reflects the Seat Health Engineering technique our R&D team had worked for
years, to protect your spine & buttocks, and specially your seating health as
a whole. Enjoy & Thank You!
Date Manufactured : June, 2022
SKU # : C362A01EM1-WF1(Blue), C362A01EM2-WF1(Purple), C362A01EM3-WF1(Grey)
C362A01EM4-WF1(Orange), C362A01EMS5-WF1(Green)
PARTS LIST
| Name| Part| Qty.
---|---|---|---
A| Caster| | x5PCS
B| Star Base| | x1PC
C| Gas Lift| | x1PC
D| Star Base Cover| | x1PC
E| Back with Lumbar Cushion| | x1PC
F| Seat Cushion| | x1PC
G| Seat Plate| | x1PC
H| Bolts
M6x18mm| | x4PCS
J| Bolts
M8x25mm| | X5PCS
K| Washer
∅18∅8mm| | x5PCS
L| Washer
∅18∅6mm| | x4PCS
M| Allen Wrench| | x1PC
Please follow the following procedures step by step in building your Office Chair/Task Chair, take special note to the sequence of steps:
Step 1: Place the Star Base (Part B) upside down and insert the 5 Casters (Part A) into the holes at the end of each leg of the Star Base (Part B).
Step 2: Turn the Star Base (Part B) over and insert Gas Lift (Part C) with Star Base Cover (Part D) through the center hole on top of Star Base (Part B).
Step 3: Attach the Back(Part E) to Seat Cushion (Part F) by using bolts (Part Jx5pcs) and washers (Part K x5pcs).
Step 4: Attach the Seat Plate (Part G) to Seat Cushion (Part F) by using 4 Bolts (Part H) and washers (Part L x4pcs) in the front holes & back holes. Tighten by Allen Wrench (Part M). Take special note to the sticker which should point to the seat front.
Step 5: Position the assembled chair upright with the seat plate facing down. Insert the Gas Lift (Part C) into the center hole of the Seat Plate (Part G) and press down until fully engaged.
ATTENTION: Make sure all bolts and screws are fully tightened before using chair.
- This Chair is for sitting only. Do not stand on this chair. Do not use this chair as a step ladder.
- Use this chair only for seating one person at a time.
- Do not use this chair unless all bolts, screws and other parts are firmly tightened.
- Every month, check all bolts, screws and other parts and tighten any that may have loosened.
- If parts are missing, broken, damaged, or worn, stop use of the product until repairs are made, using factory supplied parts.
FUNCTION INSTRUCTION
SEAT HEIGHT ADJUSTMENT
While seated, reach to the right side of the chair to find the handle, and
turn handle to raise and lower seat height to adapt to your different body
heights.
LUMBAR PILLOW ADJUSTMENT
Lumbar pillow can be attached to the desired position of your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>