PUREMATE PM 60 Ionic Air Purifier and Ioniser for Car Instruction Manual
- June 14, 2024
- PureMate
Table of Contents
IONIC AIR PURIFIER
FOR CAR & VEHICLE
MODEL NO: PM 60
INSTRUCTION MANUAL
Thank you for purchasing the efficient PureMate PM 60 Car air purifier. We wish you many years of healthy indoor air with this innovative product.
SAFETY OPERATION
Ensure that all safety precautions are followed when using electrical
appliances for the proper operation of the device.
This instruction booklet describes the safety precautions to be observed
during operation to prevent injuries to yourself, other persons and damage to
the device.
The content not only is suitable for this product but also suitable for
electrical appliances in general.
SAFETY PRECAUTIONS
– This device should be used in 12V DC vehicles only. Do not use in 24V DC
vehicles.
– Unplug the unit from the 12-volt cigarette socket when the vehicle engine is
running at low speeds for an extended period. This will prevent damage
resulting from sudden voltage surges from the battery during low load
conditions.
– The effectiveness of this device will be reduced when the vehicle windows
are open.
– To prolong service life it is advisable to turn off the PM 60 when not
operating the vehicle.
– Keep this device dry. If moisture accidentally enters the unit, please dry
it thoroughly inside and out before using it.
– Clean the PM 60 exterior cover with mild detergent only. Do not use alcohol,
benzene or other strong solvents, as they will do damage to the cover.
PRODUCT FEATURES
– The PM 60 generates thousands of negative ions that bind with allergens,
microbes and other pollutants (including bacteria, cigarette smoke, vehicle
emissions, odours, etc.) removing them from the air, keeping it fresh and
clean.
– Fresh air continuously circulating when you drive keeps you alert and
comfortable to prevent fatigue during your trip.
– The compact and mini design allowed the device to be install on the
dashboard without blocking your view.
COMPONENTS
OPERATING INSTRUCTIONS
– Use the adhesive strip provided to secure the PM 60 mly on the dashboard
with the six air outlets facing the interior of the vehicle.
– Insert the unit’s DC plug into the cigarette lighter socket. Move the
switch, located on the side of the device, to the [ON] position. The green
light will appear when in operating mode.
– Turn the switch to the [OFF] position to stop operation.
Note: In some vehicles the power to the cigarette lighter socket will cut
o when the vehicle is not operating.
CLEANING & MAINTENANCE
When the effectiveness of the device is obviously reduced or after 2 to 3 months of use, please clean the device as follows:
- Unplug from the socket and remove carefully the upper cover. Be careful not to break the four positioning lock inside the cover.
- Use cotton bud soaked with alcohol to wipe clean the electrode needles and the dust collector plate through the holes. Be careful not to damage the internal electronic parts.
- Wipe dry any leftover moisture and close the cover. The device can start again when it is thoroughly dry.
PRODUCT SPECIFICATIONS
| Model | PM 60 |
|---|---|
| Rated voltage | DC 12V |
| Power consumption | 2W |
| Negative Ion output Max. | 100,000/cm³ |
| Active oxygen output | 0.01 ppm – 0.4ppm |
| Dimensions | 14cm(L) x 7.4cm(D) x 3.8cm(H) |
| Weight | 0.4 lbs (180g) |
DISPOSAL OF THIS DEVICE
At the end of the product life cycle, you should not throw this machine into the normal household garbage but ring the product to a collection point for the recycling of electrical and electronic equipment.