PUREMATE PM405 Mini Dehumidifier Instruction Manual

: June 14, 2024
: PureMate

Table of Contents

PUREMATE PM405 Mini Dehumidifier
Specifications
Product Usage Instructions
SAFETY PRECAUTIONS
FEATURES
OPERATING INSTRUCTIONS
HOW TO (RE)INSTALL YOUR WATER TANK COVER
CLEANING 8 MAINTENANCE
WARRANTY 8 SERVICE
SPECIFICATION
Documents / Resources

PUREMATE PM405 Mini Dehumidifier

PUREMATE-PM405-Mini-Dehumidifier-PRODUCT

Specifications

Model No: PM 405
Power Supply: AC/DC power adapter
Technology: Peltier (no compressor)
Capacity: Approximately 500ml water tank
Warranty: 12 months

Product Usage Instructions

Safety Precautions

The appliance is only to be used with the power supply unit provided.
Do not open the appliance to avoid electric shock as there are no user-serviceable parts inside.
Avoid using the appliance around heated surfaces, open flames, or flammable substances.
Do not immerse the appliance in water or other liquids.
Use the appliance only for its intended purpose as described in the manual.
Keep the front inlet grill and top outlet grill clear at all times, do not cover them with clothing, plastic bags, etc.
Turn off the dehumidifier after use.
Avoid using the mains power adaptor in wet or damp places. Position the unit in areas where air ventilation is good.
Always keep the unit in an upright position to avoid water leakage.

Features

The PureMate Mini Dehumidifier PM405 uses Peltier technology, which makes it light and quiet, perfect for small rooms. It eliminates musty odors and mold by keeping small spaces free of unwanted moisture.

Operating Instructions

Plug the DC power jack of the AC/DC power adapter into the DC power socket at the back of the dehumidifier.
Connect the AC plug of the AC/DC power adapter to the appropriate wall mains socket.
Press the power switch to start the dehumidifier. The green LED will illuminate.
To switch off the unit, press the power switch again.
If the water tank is full, the unit will automatically shut off and the red LED will illuminate.

Removing the Water Tank

Switch off the mini dehumidifier.
Remove the water tank from the unit.
Pour the collected water into a sink or drain.
Put the water tank back into the unit.
To continue dehumidifying, press the On/Off button again.

How to (Re)Install Your Water Tank Cover:

After cleaning your water tank, turn the tank cover over and place it on a flat surface.
Insert the float into the cover’s aperture.
Place the water tank over the cover and press in smoothly.
Replace the water tank with the dehumidifier.

Cleaning & Maintenance:

Before cleaning the unit, turn off the mini dehumidifier and unplug the AC/DC socket first.

Use a soft cloth to clean the surface of the unit.
Use a soft-bristled brush to remove dust from the air inlet and outlet grills.
Dispose of the collected water and rinse and wipe the inside of the tank.
After cleaning, place the cover and floating ball back into the dehumidifier.

Warranty & Service:

This product is covered with a PureMate product and labor warranty for 12 months from the date of its original purchase. If any problems occur, please contact the PureMate Customer Care Centre in your country via the contact information listed in this User Guide. Aftersales service is only provided for products sold by PureMate or PureMate authorized retailers and distributors. For units purchased from a different place, please contact your seller for return and warranty issues.

FAQ:

Q: Can I use this dehumidifier in a large room?

A : This mini dehumidifier is designed for small rooms. For larger rooms, we recommend using a larger-capacity dehumidifier.

Q: How often should I clean the water tank?

A : It is recommended to clean the water tank regularly, especially when it is full. Cleaning every 1-2 weeks is a good practice to maintain optimal performance.

Q: What should I do if the unit does not turn on?

A : First, make sure the AC/DC power adapter is properly connected to both the dehumidifier and the wall mains socket. If it still does not turn on, check if there is a power supply issue or contact our Customer Care Centre for further assistance.
Thank you for purchasing the innovative PureMate MINI DEHUMIDIFIER PM405, kindly read the instruction manual carefully before using the machine. We wish you healthy indoor air with this efficient and effective product.

SAFETY PRECAUTIONS

Ensure that all safety precautions are followed when using electrical appliances for the proper operation of the device.
This instruction booklet describes the safety precautions to be observed during operation to prevent injuries to yourself, and other persons and damage to the device.
The content not only is suitable for this product but also suitable for electrical appliances in general.
The appliance is only to be used with the power supply unit provided with the appliance.
To avoid electric shock, do not open. There are no user-serviceable parts inside.
Do not use around heated surfaces, open flames, or flammable substances.
Do not immerse in water or other liquids.
Do not use the appliance for any other purpose than its intended use, as described in the manual.
Keep the front inlet grill and the top outlet grill clear at all times, do not cover them with clothing, plastic bags, etc.
After you have finished using the mini dehumidifier, turn off the dehumidifier.
Avoid using the mains power adaptor in wet or damp places. Position the unit in areas where air ventilation is good.
Always keep the unit in an upright position to avoid water leakage.

FEATURES

The mini dehumidifier uses Peltier technology (no compressor), which makes it light and quiet and perfect for small rooms.
Poor ventilation can cause musty odours and mould the mini dehumidifier eliminates this problem by keeping small spaces free of unwanted moisture.

OPERATING INSTRUCTIONS

Plug the DC power jack of the AC/DC power adaptor into the DC power socket (at the back of the dehumidifier), then connect the AC plug of the AC/DC power adaptor to the appropriate wall mains socket.
Press the power switch, the mini dehumidifier will begin to operate, the Green LED will illuminate. To switch off the unit, press the power switch again.
When the water tank is full, the unit will automatically shut off and the Red LED will illuminate.
THE AC/DC POWER ADAPTOR MAY BECOME HOT DURING USE, THIS IS NORMAL AND DOES NOT MEAN THERE IS A FAULT.

REMOVING THE WATER TANK

When the water tank is full, with approximately 500ml of water collected, the unit will automatically shut off and the Red LED will illuminate.
To remove the water tank, first switch off the mini dehumidifier. Then, remove the water tank from the unit and pour the water into a sink or drain. Put the water tank back into the unit. To continue dehumidifying, press the “On/Off” button again.

HOW TO (RE)INSTALL YOUR WATER TANK COVER

After cleaning your water tank,
Turn the tonk cover over and place it on a flat surface.
Insert the float into the cover’s aperture.
Place the water tank over the cover, and press in smoothly.
Replace water tank into Dehumidifier.

CLEANING 8 MAINTENANCE

Before cleaning the unit, turn off the mini dehumidifier and unplug the AC/DC socket first.
Use a soft cloth to clean the surface of the unit and a soft-bristled brush to remove dust from the air inlet and outlet grills,
Important: The Water Tank Cover is detachable for cleaning purposes only.
Dispose of the collected water and rinse and wipe the inside of the tank.
After cleaning, place the cover and floating ball back into the dehumidifier.

FIND US ONLINE

WARRANTY 8 SERVICE

This product is covered with a PureMate product and labor warranty for 12 months from the date of its original purchase. If any problems occur, please contact the PureMate Customer Care Centre in your country via the contact information listed in this User Guide. We can only provide after-sales service for products that are sold by PureMate or PureMate-authorized retailers and distributors. If you have purchased your unit from a different place, please contact your seller for return and warranty issues.

SPECIFICATION

Model: PM405
Power Supply: Input 100-240V,50/60Hz
Output: 9V DC/ 2.5A
Moisture Removal: 300ml/24hr (under test condition 30°C,85%
Cooling element: Thermoelectric Peltier module
Water Tank Volume: 600ml
Product Dimension : 15.4 x 21.8 x 13 cm
Certifications: UKCA, CE, Rohs
Item Weight : 1.1 kg
Auto Shutoff : Yes
Warranty: year

DISPOSAL OF THIS DEVICE

At the end of the product life cycle, you should not throw this machine Into the normal household garbage but bring the product to a collection Point for the recycling of electrical and electronic equipment.
MINI DEHUMIDIFIER I MODEL NO-PM 405
Super Tech Health Limited
129 Shady Lane
Great Barr
Birmingham
West Midlands
B449ER
United Kingdom
WWW.PUREMATE.CO.UK
© COpyright 2021