Waterdrop WD-FC-01 NSF Certified Faucet Water Filter Owner’s Manual
- June 14, 2024
- Waterdrop
Table of Contents
Waterdrop WD-FC-01 NSF Certified Faucet Water Filter
About the System
Thanks for choosing Activated Carbon Fiber Faucet Filtration System! This faucet filtration system ensures to give you clean and healthy water with Activated Carbon Fiber (ACF) filter. As to adsorption, ACF has been proven to be 10 to 12 times better than ordinary carbon. It will effectively filter chlorine, unpleasant taste and odor while retaining beneficial minerals in water. The system will meet your needs of clean water with a 320-gallon service life, three times longer than other brands.
| System tested and certified by NSF International against NSF/ ANSI Standard
42 for the reduction of the claims specified on the Performance Data Sheet,
and to NSF/ANSI 372 (:;;;0.25% lead).
---|---
Performance Data Sheet
Standards| Substances| lnf . Average| NSF Specified
Challenge Product Concentration| Ave.% Reduction| Average Product
water concentration| Max Permissible Product Water concentration|
NSF Reduction Requirement s| NSF Test Report
---|---|---|---|---|---|---|---|---
NSF42| Chlorine Taste and Odor| 2mg/L| 2 mg/L± 10%| 94.43%| 0.1 1 mg/L| N/A|
2:50%| J-0030’l829
System Specifications
To achieve optimal performance, it is recommended to use the system within the system specifications.
System Model No. ————————————————————————– WD-FC-01
Replacement Model No. —————————————————————- WD-FF-01 A
Rated Capacity———————————————————– 3 months or 320 gallons
Rated Flow —————————————————————————– 0.5 gpm/2 1pm
Operating Temperature ———————————————————– 44-100° F /5-38°c
Operating Working Pressure——————————————-1 5-100 psi/100-689 kPa
NOTE: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
Parts List
- (A) Activated Carbon Fiber (ACF) Filter
- (B) Filter Top Cover
- (C) Filter Base
- (D) Mounting Nut
- (E) Silicone Washer
- (F) Steel Mesh
- (G) Mounting Base
- (H) Lever
- (I) Accessories
- (I1) 6x Adapter M18.S(AS), 13/ 16″(A4), M21.S(A6), 15/ 16″(A3), M 18.S(B4), 55/64″(B3)
- (I2) 1 x Teflon Tape
Installation Instructions
-
Remove your original faucet aerator if there is an aerator in your faucet. Choose the right adapter to match your faucet threading.
How to Choose the Right Adapter| | For internal threaded faucets, choose from AS, A4, A6 or A3.
| | For external threaded faucets, choose B4 or B3. -
Unscrew the Mounting Nut (D) from the Mounting Base (G) by turning counter-clockwise. Then put the Mounting Nut (D) on faucet.
-
Wrap Teflon Tape (12) around the joint of mounting base and the faucet. You can hand-tighten the adapter and do not over-tighten it.
NOTE: The silicone washers have been installed into the adapters, and be careful not to omit the washer during the installation. Otherwise, this may cause water leakage. -
Screw the Mounting Base (G) onto the Mounting Nut (D) firmly by turning clockwise.
-
Unscrew the Filter Top Cover (C) from the Filter Base (D). Take out the filter from package and remove the protective film. Insert the filter into Filter Base (D). Twist the Filter Top Cover (C) back to Filter Base (D) securely.
NOTE: Please insert the filter firmly until it sits. -
Align the slot of Filter Base (C) with the slot of Mounting Base (G).
-
Insert the Filter Base (C) into the Mounting Base (G) and rotate 90° upward.
How to use
Open faucet after installation. Switch the Lever (H) to “tap” position, and unfiltered water will run through. Switch the Lever (H) to its “pure” position, and filtered water will run through.
**Tap Water
Pure Water
**
NOTE:
- Before first use, run cold water for 1 minute in “pure” position. Do not run hot water above 122°F/50°C through the filter. During flush, it is normal to see cloudy water and hear the sound of water pushing air out of the filter cartridge.
- Check for leaks. If there is any leak, please refer to FAQ.
- Please switch the lever slowly to avoid damage to mounting base
Filter Cartridge Replacement
For optimum performance, it is highly recommended you use genuine Waterdrop faucet replacement water filter. And it is also advisable to change your filter every 3 months or 320 gallons to keep water fresh, whichever comes first. This will vary based on water usage and water quality.
-
Twist the Filter Base (C) from the Mounting Base (G).
-
Twist the Filter Top Cover (B) off and take out the old filter.
-
Remove the protective film and insert the new filter into the Filter Base (C).
-
Twist the Filter Top Cover (C) on.
-
Align the slot of Filter Base (C) with the slot of Mounting Base (G).
-
Insert Filter Base (C) into Mounting Base (G) and rotate 90° upward.
Warnings
- Do not use with water above 122°F/50°C.
- Flush the system for 1 minute before use after a long time of non-use.
- Prior to each use, run water through the filter for 5 to 10 seconds to activate the filter.
- The filter system must be protected against freezing temperatures, frost, snow, sleet and ice. Exposure to these elements can produce cracks and product failures.
- Please do not touch the filtered water outlet to prevent bacterial growth.
- Do not use steel wire brush or corrosive liquids to clean the product.
- Change the filter every 3 months or 320 gallons for best filtration performance.
Frequently Asked Questions
Q: Why does water leak between the mounting base and the faucet?
A: Please check if the Teflon Tape is wrapped properly. If not, bind the tape again around the joint of mounting base and the faucet. If there is still water leakage, check whether the silicone washer is installed. Make sure that the silicone washer is installed in place.
Q: Why does the filtered water run quite slowly?
A: The filter cartridge may be clogged. Replace the filter cartridge.
Q: Why does the unfiltered water run quite slowly?
A: There may be dirt in filter steel mesh. Clean the filter steel mesh.
Q: Why does the water taste funny?
A: The filter cartridge is not installed appropriately, or it should be replaced. Please reinstall it in a correct way. If there is still bad taste, please replace it.
Limited Warranty
The Waterdrop Activated Carbon Fiber Faucet Filtration System ( Model No.: WD- FC-01) offers 1-year warranty, which covers defects in materials and work man shop from original date of purchase. If the product proves to be defective within 1 year from the date of purchase, please call our technical support hotline. During the warranty period, we will replace or repair any part which is deemed to be defective, if product has not been subjected to tampering, alteration or improper use after delivery, and has not been repaired by the manufacturer. The product is not warranted against misuse, use in abnormal operation temperature conditions, conditions outside listed operating parameter, sue in commercial operations or any other manner outside the “System Specifications” set forth in the owner’s manual. Our obligation does not include the cost of transportation. We are not responsible for damage in transit, and claims for such damage should be presented to the carrier by the customer.
NOTE: It does NOT apply to any filter cartridge, which has a life expectancy that varies based on incoming water quality.
Customer Support
Qingdao Ecopure Filter Co., Ltd.
Tel: 1 -888-352-3558 (U.S.)
E-mail: service@waterdropfilter.com
Add. : No. 13, Yishengbai Road Jimo, Qingdao, China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>