cecotec 56 Time Drip Coffee Machine Instruction Manual

COFFEE 56 TIME
Drip coffee machine
Instruction manual

SAFETY INSTRUCTIONS

Read these instructions thoroughly before using the device.
Keep this instruction manual for future reference or new users.

• All safety instructions must be closely followed when using the appliance. Do not use the appliance for any use not specified in the manual.
• This appliance can be used by children aged 8 years old and above if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Cleaning and user maintenance should not be carried out by children unless they are over 8 years old and are under supervision. Keep this appliance and its power cord out of reach of children under the age of 8.
• Children must not play with the device.
• This device is designed for domestic use only and is not intended for bars, restaurants, farmhouses, hotels, motels, and offices.
• Avoid spillage on the conductor cable.
• The surface of the heating element is subject to residual heat after use.
• In case of misuse, personal injury and/or material damage may occur.
• The device must not be submerged.
• The coffee machine must not be placed in a cupboard when in use.
• WARNING: do not use the appliance if the surface is cracked.
• Cleaning and maintenance tasks should not be carried out by unsupervised children.
• Ensure that the mains voltage matches the voltage specified on the device rating label and that the plug is earthed.
• Place the appliance on a dry, stable, flat, heat resistant surface.
• Do not immerse the cable, plug, or any other non-removable part of the device in water or any other liquid or expose electrical connections to water. Make sure your hands are dry before handling the plug or switching on the device.
• Do not use the appliance if its cable, plug, or housing are damaged, nor after it malfunctions or has been dropped or damaged in any way.
• Check the power cable regularly for visible damage. If the cable is damaged, it must be repaired by the official Cerotic Technical Support Service to avoid any type of danger.
• Do not try to repair the device by yourself. Contact the official Cerotic Technical Support Service for advice.
• Do not cover the appliance during operation and do not place heavy objects on it.
• Do not use any accessory that has not been recommended or provided by Cerotic, as they might cause injuries or damage.
• CAUTION: hot surface. The temperature of accessible surfaces may be high while the appliance is in use and could cause burns. Do not touch hot surfaces during operation or immediately after.
• Use bottled water for best results. Do not use warm water or other liquids, these may cause product damage.
• Warning: the filling opening must not be opened during operation.
• Do not insert coffee while the machine is in operation.
• Do not operate the appliance without water.
• Do not move the device while it is in operation or containing hot beverages.
• Do not let the cable hang over the edge of the working surface or worktop and prevent it from touching hot surfaces.
• Switch off the appliance and unplug it from the mains when not in use or when cleaning, before changing accessories, disassembling, or assembling the product. Allow it to cool down completely before attaching or removing parts and before cleaning the appliance.
• Never leave the device unattended during use. Unplug the device after use and when you leave the room where it is installed.
• Warning: this product has undergone a quality control previous to its commercialization with the aim of ensuring its correct operation. After the quality control testing, the appliance is cleaned thoroughly, therefore, although it is unlikely to occur, there could be rests of water drops.

Glass jar’s safety instructions

• The glass jar is designed to be used only with this product. Do not use it in any other drip-type coffee maker or in a microwave oven.
• Do not stir inside the jar with a spoon or other utensils.
• Do not use a cracked glass jar or a jar having a loose or weakened handle.
• Never use ice cubes inside the jar or place it inside the refrigerator.
• Never drink directly from the jar.
• Do not tilt or overturn the jar to avoid liquids from flowing out.
• When carrying the jar, always use the handle.
• Do not leave the glass jar empty on the warming plate to avoid it from cracking.

PARTS AND COMPONENTS

Fig. 1

1. LED display
2. Water tank cover
3. Filter
4. Funnel
5. Funnel bracket
6. Glass jar
7. Water tank
8. Water level indicator
9. Main body
10. Heating plate
11. Base
12. Pressing spoon

Control panel. Fig. 2

1. Power button
2. Programming button
3. Aroma button
4. Setting button

NOTE: the graphics in this manual are schematic representations and may not exactly match the device.

BEFORE USE

• This appliance is packaged in a way as to protect it during transport. Take the device out of its box and remove all packaging materials. You can keep the original box and other packaging elements in a safe place. This will help you prevent damage to the device when transporting it in the future. In case the original packaging is disposed of, make sure all packaging materials are recycled accordingly.
• Make sure all parts and components are included and in good conditions. If there is any piece missing or in bad conditions, contact the Official Cerotic Technical Support Service immediately.

OPERATION

Before the first coffee

1. Fill the water tank to the maximum amount of water.
2. Boil water once or twice and then dispose it.
3. The glass jar, funnel, filter, and all parts that come into contact with water and coffee should be thoroughly cleaned with warm water and soap.

Coffee brewing

1. Lift the water tank cover and fill it with potable water.

2. Place the funnel in its bracket, make sure it is positioned correctly, and then fit the filter.

3. Add the right amount of coffee powder in the filter. You can increase or decrease the amount of coffee powder to your liking.

4. Gently shake the funnel and filter to distribute the coffee evenly; then, close the water tank cover and make sure it is positioned correctly.

5. Insert the glass jar into the heating plate.

6. Connect the machine to the mains and the display will show 12:00.

7. Press the power button on the control panel twice and the red-light indicator will light up. Then, the coffee machine will start operating.

8. During the brewing process, you can press the power button at any time to stop operation.
   Note: the coffee will stop dripping automatically, but the extraction time from the glass jar should not exceed 30 seconds to prevent the coffee from overflowing over the rim of the funnel.

9. Do not open the water tank cover during the brewing process to avoid getting burnt by steam or damaging the coffee machine due to the backflow of hot water.

10. Wait until the coffee has finished dripping so that you can remove the glass jar, pour the coffee in, and enjoy it.
    Note: since coffee powder absorbs a certain amount of water, the amount of coffee poured may be lower. The heating plate will be very hot during operation – do not touch it!

11. The keep-warm function will be activated, and the machine will switch off automatically after 40 minutes if no further operation is performed. If you are not going to use the coffee machine for a long time, unplug it.

Note:

• The water level should not exceed the maximum mark or fall below the minimum mark on the tank.
• Do not immerse the machine or power cord in water or other liquids to avoid any danger. The temperature of freshly brewed coffee is very high, so be careful when pouring it to avoid getting burnt.

Pre-set brewing time
This coffee machine has a pre-set brewing time function. After preparing coffee according to the previously mentioned steps (1 to 6), and assuming it is 8:10, follow the steps below if you want the machine to automatically prepare coffee at 13:00.
Note: the time of the coffee machine is displayed in 24 hours.

1. Press the programming button once, the indicator light will light up. Press the setting button to select the hour. Press the programming button and the setting button again to select the minutes until the current time is set (i.e., 8:10).

2. Press the programming button once, the indicator light will light up.

3. Press the setting button to select the time and press the programming button again to confirm the selected time.

4. Press the setting button to select the minutes and then, select the brewing time at 13:00.
   Note: if no action is taken within 15 seconds after setting the brewing time, the display will automatically return to the current time and the corresponding indicator will go out.

5. Press the power button and the indicator light will turn on. When the  indicator is lit, the coffee machine will have entered the pre-set state. You can press the programming button to check the current time or the pre-set time, respectively.

6. When the time reaches 13:00, the indicator light will go out, and the  indicator light will light up, then the machine will start brewing coffee. If you do not switch off the machine after brewing coffee, it will enter the keep-warm function.
   Note: the product will automatically switch off after 40 minutes if no further operation is performed.

Select coffee aroma
This machine has a coffee aroma selection function for three different levels as shown below:

• Low level: press the aroma button once and the symbol will appear at the bottom of the display. Then, press the power button once to brew the coffee.
• Middle level: press the aroma button twice until the symbol appears at the bottom of the display. Next, press the power button twice to prepare coffee.
• High level: press the aroma button three times until the symbol appears at the bottom of the display. Next, press the power button twice to prepare coffee.

If you need to preset the brewing for the selected aroma, adjust the corresponding level and follow the steps above. (Note: press the aroma button to adjust the coffee aroma.)

CLEANING AND MAINTENANCE

Warning:
Unplug the appliance before cleaning and allow the heating plate to cool down sufficiently to avoid burns. Do not immerse the machine or power cord in water or other liquids to avoid any danger.

• After each use, open the tank cover and remove the filter to empty the coffee grounds. Next, clean the filter and the glass jar with warm water and add a cleaning solution if necessary.
• Wipe the outer surface of the product with a soft, slightly damp cloth to remove dirt.
• When brewing coffee, water droplets may form on the top of the funnel and fall on the heating plate. Therefore, the corresponding parts must be cleaned after each use.

Descaling

• To ensure efficient operation, depending on the quality of the water in your area and the frequency of use of the coffee machine, you should regularly remove the limescale contained in the product as indicated below:
• Pour the appropriate amount of white vinegar solution into the tank, (3 parts water to 1 part vinegar) but do not add coffee powder. Boil the water with vinegar and repeat the process several times if necessary. Then, remove the vinegar water and let the  machine boil with distilled water until it no longer smells of vinegar.

TECHNICAL SPECIFICATIONS

Product reference: 01722
Product: Coffee 56 Time
Voltage: 220-240 V
Frequency: 50/60 Hz
Rated power: 800 W
Technical specifications may change without prior notification to improve product quality.
Made in China
Designed in Spain

DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC APPLIANCES

**** This symbol indicates that, according to the applicable regulations, the product and/or batteries must be disposed of separately from household waste. When this product reaches the end of its shelf life, you should dispose of the cells/batteries/accumulators and take them to a collection point designated by the local authorities.
Consumers must contact their local authorities or retailer for information concerning the correct disposal of old appliances and/or their batteries.
Compliance with the above guidelines will help protecting the environment.

TECHNICAL SUPPORT AND WARRANTY

Cerotic shall be liable to the end user or consumer for any lack of conformity that exists at the time of delivery of the product under the terms, conditions, and deadlines established by the applicable regulations.
It is recommended that repairs be carried out by qualified personnel.
If at any moment you detect any problem with your product or have any doubt, do not hesitate to contact the official Cerotic Technical Support Service at +34 963 210 728.

COPYRIGHT

The intellectual property rights over the texts in this manual belong to CECOTEC INNOVACIONES, S.L. All rights reserved. The contents of this publication may not, in whole or in part, be reproduced, stored in a retrieval system, transmitted, or distributed by any means (electronic, mechanical, photocopying, recording or similar) without the prior authorization of CECOTEC INNOVACIONES, S.L.

|
---|---

www.cecotec.es
Cerotic Innovations S.L.
Av. Reyes Calicos, 60
46910, Alf afar (Valencia), Spain
SF01230724

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>