Zhiguangwei G5 Selfie Stick User Manual
- June 14, 2024
- Zhiguangwei
Table of Contents
Zhiguangwei G5 Selfie Stick
How to use
- Turn on: Long press the camera button for 3 seconds to turn on.
- Bluetooth pairing: the indicator light flashes for 4 seconds to enter the pairing state, the blue indicator light of the pairing state flashes, use the mobile phone to search for AB Shutters to match, and the blue indicator light will go out after the pairing is successful.
- Take a photo: When the Selfie is connected to the mobile phone, short press the camera button and the blue light flashes.
- No pairing: After booting, in the state of no pairing connection, it will automatically shut down after 5 minutes of no operation.
- Pairing: After turning on the phone, when the Selfie is connected to the phone, it will enter the dormant state if there is no operation for 10 minutes, and it will automatically shut down after another 10 minutes.
- Power off: In power on and sleep mode, press and hold the camera button for 3 seconds to power off, the indicator light flashes and goes out.
Take out the SELFIE
Change the battery
360° Rotation
Open the tripod
Tripod mode
When the selfie stick changes to tripod mode, pay attention Pull out the last
section of the pole and adjust it to The tripod is stable.
Specifications
- Main Material: Stainless steel
- Retracted Length: 20cm
- Extended Length: 110cm
- Gift carton size: 16x 11x 200mm
- Battery: CR1632 (replaceable)
(The battery must not be expesed to such as sunlight, fire or similar
overheating environment)
Remind
The selfie stick is compatible with Android 4.2.2 andiphone ios5.0 ard above
(Android device: if you are on the camera Change your “volume key Function” be
sure tc change it to the default, Or “take a picture” and let the selfie stick
normal work)
thank you for your support!
RF exposure statement
This equipment complies with the FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.