VOGUE APPLIANCES 330240 Integrated Pull-out Rangehood 600mm Instruction Manual
- June 4, 2024
- VOGUE APPLIANCES
Table of Contents
APPLIANCES 330240 Integrated Pull-out Rangehood 600mm
**Instruction Manual ”
**
INSTALLATION INSTRUCTIONS
USER GUIDE
VOGUE Integrated Pull-out Rangehood 600mm
330240
Integrated Pull-out Rangehood 600m
To prevent the risk of accidents or damage to the appliance, it is essential
to read these instructions before it is installed and used for the first time
Information and advice
MODEL: 330240
VOLTAGE:220-240V~
FREQUENCY:50Hz
RATED POWER:126.5W
MOTOR INPUT POWER:125W
LIGHTING:1.5WX1
In certain circumstances, electrical appliances may be a dangerous hazard.
A) There shall be adequate ventilation of the room when the range hood is used
at the same time as appliances burning gas or other fuels.
B) Do not check the status of the filters while the cooker hood is operating.
C) Do not touch the light bulb within half an hour after appliance use.
D) Do not flambé under the cooker hood
E) Avoid opening the gasometer when there is no pan on the stove, as it is
damaging for the filters and a fire hazard.
F) Constantly check food frying to avoid that the overheated oil may become a
fire hazard
G) Disconnect the electrical plug prior to any maintenance.
H) If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
I) The socket outlet for the range hood must be located so it is easily
accessible for the user after installation. Ensure the main supply voltage
corresponds with that of the appliance.
J) There is a fire risk if cleaning is not carried out in accordance with the
instruction
K) This appliance can be used by children aged 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or instruction concerning
the use of the appliance in a safe way and understand the hazards involved.
L) Children shall not play with the appliance.
M) Cleaning and user maintenance shall not be made by children without
supervision.
N) When the hood is in repair, maintenance, replacement of parts, please pull
out the plug, and ensure the safety of the people.
To protect the main body from corrosive of the long time accumulation of dirt,
the cooker hood should be cleaned with hot water with non-corrosive detergent
every two months.
O) Don’t put things on the drawer, so as to avoid dropping in the operation of
the drawer.
P) The air must not be discharged into a flue that is used for exhausting
fumes from appliances burning gas or other fuels (not applicable to appliances
that only discharge the air back into the room).
Q) Regulations concerning the discharge of air have to be fulfilled.
R) When the range hood and appliances supplied with energy other than
electricity are simultaneously in operation, the negative pressure in the room
must not exceed 4 Pa (4×10-5 bar).
S) Regarding the instructions for the method and frequency of cleaning, thanks
to referring to the section “Installation”.
T) Regarding the instructions for the method of fixing and how the appliance
is to be fixed to its support, thanks to referring to the section “Cleaning
Instruction”.
U) Regarding the instructions for the blub replacement, thanks to referring to
the section “Replacing Bulb”.
V) Failure to install the screws or fix the device in accordance with these
instructions may result in electrical hazards.
W) The appliance uses 4 hob elements at most.
CAUTION: Accessible parts may become hot when used with cooking
appliances.
Please keep this instruction booklet in a safe place for future reference.
Please read this instruction manual carefully: it contains important
information concerning the safe operation, installation, and maintenance of
the appliance.
Know your cooker hood
Please read these instructions before using your cooker hood.
- Drawer assembly
- Air duct assembly
- Main body
- Filer assembly
Also include:
- Check valve
- Install screws package
- User instructions
Information
Congratulations on the purchase of our cooker hood which is designed to
include many superior features that permit you the fullest expression of your
living. Before installing and/or using the cooker hood carefully read all the
instructions.
Installation
Ensure the power has been turned off before beginning this installation. The plug must be assembled in places easy to drag and insert. To install this hood you will require two assistants. You will need the following tools and materials to complete this installation: DrillFlat head screwdriver Phillips head screwdriver or cordless drill and Phillips head bitTin snip measuring tapehand saw or jig saw electrical tap*duct tape .
- Remove the range hood from the carton.
- Lay the hood upside down on a table covered with cardboard or paper to prevent scratching of the table or hood.
- Hood installation should be within a 0.6m radius range.
- We recommend that after installation the bottom of the hood should be no less than 650mm and no more than 750mm above the stove’s heating elements and burners.
Information
Installation work and electrical wiring must be done by a qualified
person(s) in accordance with all applicable codes and standards, including
fire-rated construction.
Method 1
-
According to the figure, make sure the position of the hood in the cabinet. The wood strips should be lined up with the 4 keyhole slots on the top of the range hood. On the cabinet, install 4 screws(supplied)according to the relative position of 4 keyholes on the bottom of the hood. The extent of screwing should be convenient for the next installation.
-
Hang the hood and let its 4 keyholes aim at the screws, the 4 screws should be in the narrow parts of keyholes. Screws should be fastened firmly, make sure that the installation between the hood and cabinet is enough to fasten.
-
Install screws in the security holes, in case 43 of front and back moving of hood, so that the user is safer.
Information
When cutting or drilling into a wall or ceiling, do not damage electrical
wiring or other hidden utilities.
Method 2
In the installation surface in the cabinet doesn’t adapt to install the cooker
hood, then as per fig, fix the position of the cooker hood on the wall. On the
wall, install 2 screws(supplied) according to the relative position of 2
keyholes on the back of the hood.
The extent of screwing should be convenient for the next installation. Also install screws in the security holes, in case of front and back moving of hood, so that the user is safer.
Installation of hoods built-in combi cabinets is the same as the previous method.
Information
The cooker hood must not be installed and connected to flues where other
appliances are installed and which run off other energy supplied different to
electricity(water heater boiled cookers(range/agas)etc.).
Check valve Installation
Hold on the check valve with your hands, align the box gap, put in the check
valve , and then spin to a certain angle until three angles of the valve are
stuck. Installation is complete.
Carbon Filter
An activated carbon filter can be used to trap odors. Normally the activated
carbon filter should be changed within three or six months according to your
cooking habit. The installation procedure of the activated carbon filter is as
below.
– Slide the drawer assembly of the cooker hood.
– In order to install the activated carbon filter, the metallic anti-grease
filter should be detached first. Press the lock and pull it downward.
– Put the activated carbon filter into the unit it in the anti-clockwise
direction. Repeat the same on the other side. Put back the grease filter in
position.
Information
When the activated carbon filter is attached,the suction power will be
lowered.
Hood Using Method
Operation
– Check beforehand
– Check the safe condition of the appliance
– Check whether there are visible defects.
– Check that all parts of the appliance have been securely fitted.
Switching on/off
– Slide the front part of the cooker hood.
– There are 3 speeds for the motor and an off switch for the lamp.
– Slide the switch for operation.
Motor Operation
– [0]=Off – [1]=Low Power Setting
– [2]=Mid Power Setting – [3]=High Power Setting
Light Operation
– [OFF]=Off – [ON]=On
Replacing Bulb:
Changing the light
Lightning inside the appliance is provided by a 1.5W LED light.
To replace the LED light, proceed as follows:
- Disconnect the appliance from the mains or switch off the circuit breaker.
- Remove the metal filters (see Cleaning and Replacing Filters) .
- Remove the light by levering its fitting from the hood body(this may require pressure or force to be applied) and disconnecting the connector of the light.
- Replace the light with a new one of the same type, making sure that you connect the light with the light cable correctly.
- Install the metal filter back in place.
| Max power| Voltage| Picture| Lamp Cap| ILOCOS D code
---|---|---|---|---|---
Self-ballasted| 1.5W| 220-240V| | /| DBS-1.5-
LED modules| 1.5W| 220-240V| Square/Diameter:33.2mmx120mm| /| H-33.2/120
Information
Clean ventilation fans frequently. Grease should not be allowed to accumulate
on fan or filter.
Cleaning Instruction
Disconnect the range hood from the power supply before cleaning or servicing.
- Cleaning the surface of the hood frequently. Use mild soap or detergent to clean the hood.
- Do not use harsh alkalis or abrasives
- Avoid the use of scouring powers or dishwasher compounds.
- The grease filter may be washed using mild soap or detergent. In normal operation (1 to 2 hours daily), the Grease filter must be cleaned after 2 months. (heavy grease build-up may not be cleaned easily and the filter may require replacement)
- A charcoal filter cannot be cleaned Depending on the frequency of use and the type of cooking, the expected life of a Charcoal filter is from 1 to 6 months. Replacement is required.
Information
When cleaning water must not enter into the motor, control switch, etc.
electrical parts.
It is recommendable to clean the metallic filter every three months by
carrying out the following instruction:
–Remove the metallic filter from the cooker hood and wash it in a solution of
water and neutral liquid detergent, leaving to soak
–Rinse thoroughly with warm water and leave to dry.
–The metallic filter may alter in color after several washes. This is not
caused for customer complaints or the replacement of the metallic filters.
Information
There is a fire risk if cleaning is not carried out in accordance with the
instructions.
Disposal
Please dispose of it at your local community waste collection/recycling center and ensure it presents no danger to children while being stored for disposal. The plug must be rendered useless and the cable cut off to prevent misuse.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>