ORBITA W21500 Insafe Watch Winder Installation Guide

June 14, 2024
Orbita

ORBITA W21500 Insafe Watch Winder Installation Guide
Insafe Watch Winder

INSAFE WATCHWINDERS

Orbita Lithium Batteries

Extended Battery Life
All battery operated INSAFE winders are fitted with high-energy, factory installed, LITHIUM batteries that provide several years of battery life. In addition, each INSAFE winder carries an iron-clad 2-year product guarantee.

Replacement
When the time comes to replace the Lithium batteries in your INSAFE winder, you may purchase replacements directly from us. You may also purchase them locally. Should you purchase locally,be sure to change all batteries at the same time with new batteries of the same brand.

Insafe 3, 4 and 6 Watch winders

Congratulations!
The INSAFE user guide will help take you though the initial set up and program Ming of your new watch winder. Your winder is factory-fitted with ORBITA Lithium “D” cell batteries which provide several years of operating life at the normal 8-minute winding cycle. Even longer life may be accomplished by using the 12-minute mode pending upon the watch’s winding characteristics.

Included In This Box

  1. Insafe 3.4 or 6 Watch winder
  2. Cup Assembly (3, 4 or 6)
  3. Standard Cushion (3,4 or 6)
  4. Lithium Batteries (4)
  5. Warranty Registration
  6. Instruction Book

EXPLODED VIEW
Installation Instruction

Getting Started

Turning Power On

  1. Carefully unwrap the protective packaging.
  2. Remove all cups from their respective drive shafts.
  3. Make sure that each individual power switch is set to ‘On’ (-)
  4. Select 8 or 12 minute setting (Details on Next Page)
  5. Mount watch on cushion and slide cushion into cup.
  6.  Slide the cup back firmly to engage the drive shaft key.
  7. Turn the power on using master power switch(es) (a/-).

Mounting Watch on Cushion

With the bracelet or strap of the watch closed, squeeze and slide the cushion through the watch. The back of the watch should rest against the Orbita logo and the strap should lie on the flat portion of the cushion.
Battery Removal

8/12 Minute Switch

A program switch located behind the cups allows you to select one of two winding cycles: 8 minute (factory preset) or 12 minute (extended program). The winding cycle begins every 8 or 12 minutes based on the program selected. Many watches that wind in both directions stay fully wound on the factory preset 8 min setting. To select the extended program, remove the mounting cup to reveal the program switch opening. Insert a small object (screwdriver, pencil, etc) into the opening and slide the switch to the 12 minute setting. The factory preset position is the 8 minute setting.

Battery Removal

To access the Lithium batteries on the rear of the watch winder, remove the small Phillips head screws on the battery compart- ment tabs. Push the tabs down and pull compartment doors open.
Mounting Watch on Cushion

Logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals