Anlapus 4 Pack 1080P Security Cameras Instruction Manual
- June 14, 2024
- Anlapus
Table of Contents
Anlapus 4 Pack 1080P Security Cameras
Product Information
Specifications
- Model: V2.C.06.A
- Type: Security Camera
- Day/Night functionality
- Infra-red LEDs
- Camera Lens
- Light Sensor
- Video Connector
- Power Connector
Product Overview
- Mounting Plate
- Dome Base
- Dome Cover
- Dome
Statement
Thank you for purchasing this product. Anlapus is committed to providing
our customers with a high quality, reliable security solution. Anlapus cannot
assume responsibility for any consequences resulting from the use thereof.
Before Installation
This product require cabling. It is strongly suggested to test all products
and parts before installation and cabling.
Tech Support
- Website : www.anlapus.com
- Email : anlapus@ansjer.com
Product Overview
Mounting your camera
-
Step 1
Separate the 1 Mounting Plate from 2 Dome Base by twisting the Mounting Plate in a counterclockwise motion.
-
Step 2
Remove the 2 Dome Base. -
Step 3:
Remove the 3 Dome Cover and 4 Dome . -
Step 4
Install the 1 Mounting Plate to the ceiling or wall in the position with the supplied screws. -
Step 5
Attach the 4 Dome and 3 Dome Cover to the 1 Mounting Plate.
-
Step 6
Attach the 2 Dome Base to the 1 Mounting Plate,then twisting Dome Base in a counterclockwise motion until hear the “ lock” sound.
Note
: The cable should be fixed on the slot hole.
Positioning the cables
- Connect camera to DVR via BNC cable.
- Connect monitor to DVR via HDMI cable or VGA cable.
- Connect DVR to router via Ethernet cable.
- Connect mouse to USB port on DVR, then power on DVR and cameras. NOTE: The picture shown is for your reference only. Please adhere to the actual product instead.
FAQs
-
Q: Video Loss appears where the image from my camera should be displaying on my DVR?
A: 1. Check the extension cable (power and video) is securely connected to the camera.
Check the video output from the camera is securely connected to a video input channel on the DVR.
Check the power from the camera is securely connected to a power supply. -
Q: When I view an image from the camera at night I only see a bright spot and no image?
Areflection can be caused in night vision mode if the camera is looking through a window. At night, the infrared light the camera uses to see in the dark can ‘bounce back’ off a reflective surface (such as glass, water, spider webs, some ceramics and so on) and effectively blind the camera. If you want to see outside, mount the camera outside – we made it weatherproof for a reason! -
Q: The BNC extension cable will not connect to my TV?
A: Many TV’s and monitors do not have a BNC connector but do have an RCA connector. Connect a BNC to RCA adapter to the end of the extension cable and then plug into the RCA video input on your TV or monitor.
Website: www.anlapus.com
E-Mai l: anlapus@ansjer.com
- All rights reserved. No part of this publication may be reproduced by any means without written permission from Anlapus.
- The information in this publication is believed to be accurate in all respects.
- Anlapus cannot assume responsibility for any consequences resulting from the use thereof.
- The information contained herein is subject to change without notice. Revisions or new editions to this publication may be issued to incorporate such changes.