proxicast ANT-520-421 4G/5G Wi-Fi GPS 7 In 1 MIMO Antenna Owner’s Manual
- June 14, 2024
- proxicast
Table of Contents
ANT-520-421 4G/5G Wi-Fi GPS 7 In 1 MIMO Antenna
Owner’s Manual
Applications
- Buses, Vans, Trucks
- Police / Fire / Ambulance Vehicles
- Boats
- Kiosks
Product Features
- Combines 4x Ultra-Wideband Flex elements + 2x Wi-Fi + 1x GPS antennas into a single streamlined enclosure
- Low Profile: 2.7 inches tall
- Up to 4×4 MIMO on 5G and 6×6 MIMO on WiFi
- Weatherproof & Impact Resistant
- Compatible with most Cellular/Wi-Fi/GPS Devices
- Omni-Directional 7 dBi Peak Gain
- 15 ft Low-Loss Coax Leads
Ordering Information
| Part No. | Description |
|---|---|
| ANT-520-421 | Top Hat Low-Profile 4G/5G + Wi-Fi + GPS 7-in-1 Combination Screw |
Mount MIMO Vehicle Antenna
General Description
This 7-in-1 low-profile, heavy-duty, multi-element combo antenna cost-
effectively combines high efficiency and peak gain in a compact easy to
install form factor. Suitable for fleet management, mobile video, remote
monitoring and recreational vehicle applications.
Featuring 1 GPS element, 2 dedicated 2 Tri-Band WiFi elements & 4 ultra-
wideband flex elements for WiFi or Cellular, this antenna is ideally suited
for 2×2, 4×4 and 6×6 MIMO vehicular modems and routers.
The 4 ultra-wideband elements can be used for any radio system between 600 and
6000 MHz including all 4G/5G bands used by commercial and public safety
operators worldwide (600 – 6000 MHz). Four SMA-toRPSMA adapters are included
to allow the flex elements to also be used for 3×3 to 6×6 WiFi configurations.
All WiFi generations through WiFi-7 and 4.9 GHz public safety bands are
supported. FirstNet, LTE Unlicensed (LTE/U), Licensed-Assisted Access (LAA),
Multifare and Ong (CBRS) Radio Systems are also supported.
The active L1 band GPS element has a 28 dB low noise amplifier (LNA).
The antenna has its own ground-plane and can radiate on any mounting surface
such as metal, plastic or fiberglass without affecting performance. Each
antenna element includes a 15 ft (4.5m) low-loss pre-terminated coax cable.
Installation requires only a 1.5 in diameter hole. The included rubber gasket
and mounting nut seal the opening from water and dust making in IP67
compliant.
Electrical Specifications
Ultra-Wideband Flex Elements
| Parameter | Rating |
|---|---|
| Frequency Range | 600 – 6000 MHz |
| Peak Gain | 7 dBi x 4 |
| VSWR | ≤ 2.0:1 |
| Input Impedance | 50 Ohm |
| Polarization | Vertical |
| Max Input Power | 50 W |
| DC Grounded | No |
Wi-Fi Elements
| Parameter | Rating |
|---|---|
| Frequency Range | 2400-2500 MHz, 4900-7125 MHz |
| Peak Gain | 4~6 dBi x 2 |
| VSWR | ≤ 2.0:1 |
| Input Impedance | 50 Ohm |
| Polarization | Linear |
| Max Input Power | 50 W |
| DC Grounded | No |
GPS Element
| Parameter | Rating |
|---|---|
| Frequency Range | 1575.42 MHz (L1 band) |
| Gain | Antenna: 5 dBi LNA: 28 ± 2dB Typical |
| VSWR | ≤ 2.0:1 |
| Ex-band Attenuation | 2dB@CF+50MHz/16dB@CF-50MHz |
| Input Impedance | 50 Ohm |
| Polarization | RHCP |
| Max Input Power | 50 W |
| Noise Figure | 1.5 dB |
| DC Voltage | 2.7/3.0/3.3/5.0/3.0 to 5.0 etc. |
| DC Current | 5 – 15mA |
| Current Consumption | 11 mA (max) |
| DC Grounded | No |
Mechanical Specifications
| Parameter | Rating |
|---|---|
| **** Connector Type | 4x Flex Elements: SMA Male (plug) + SMA-to-RPSMA adapter |
2x Wi-Fi: RP-SMA Male (plug) 1x GPS: SMA Male (plug)
Cable Length (all)
| Flex & Wi-Fi: 15 ft LMR200 (4.5 m) low-loss coax GPS: 15 ft RG174 (4.5 m)
low-loss coax
External Ground Plane| Not Required
Dimensions| Radome: 9.7 in x 2.7 in (247 x 69.5 mm) Mounting post: 1.5
in (38 mm) diameter; 1.4 in (36 mm) length
Weight| 6 lb (2.7 kg)
Materials| Radome: ABS plastic Connector: Brass with Nickel plating
Gasket: Rubber
Antenna Color| Black
Operating Temperature| -40°C to +85°C
Environmental Rating| IP67 (waterproof)
Wind Rating| 134 MPH (60 m/s)
Operation of this device outside the parameter ranges given above may cause permanent damage.
M echanical Dimensions
Dimensions in mm 
Radiation Patterns
700 MHz
900
MHz
1700 MHz
2400 MHz
3700 MHz
5800 MHz
Product Images
Installation Instructions
- Drill a 1.5” (38mm) hole in flat horizontal surface
- Remove mounting nut and feed coax cables through hole
- Press antenna into hole and tighten nut from underneath
- Optionally apply a thin bead of silicone caulk around the antenna rim
Contact Information
For the latest specifications, additional product information, worldwide sales
and information about Piroxicams:
Web: www.proxicast.com
Tel: 1-877-777-7694
Email: sales@proxicast.com
Tel: 1-412-213-2477
For technical questions and application information:
Email: support@proxicast.com
Important Notice
The information contained herein is believed to be reliable. Priciest makes
no warranties regarding the information contained herein. Priciest assumes no
responsibility or liability whatsoever for any of the information contained
herein.
Priciest assumes no responsibility or liability whatsoever for the use of the
information contained herein. The information contained herein is provided “AS
IS, WHERE IS” and with all faults, and the entire risk associated with such
information is entirely with the user. All information contained herein is
subject to change without notice.
The information contained herein or any use of such information does not
grant, explicitly or implicitly, to any party any patent rights, licenses, or
any other intellectual property rights, whether with regard to such
information itself or anything described by such information. Priciest
products are not warranted or authorized for use as critical components in
medical, life-saving, or life-sustaining applications, or other applications
where a failure would reasonably be expected to cause severe personal injury
or death.
Data Sheet: Rev B 09/06/23
© Copyright Proxicast, LLC. All rights reserved.
Disclaimer: Subject to change without notice
www.proxicast.com
1-877-777-7694
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>