Danfoss DMB Eliminator Hermetic Bi Flow Filter Drier Installation Guide
- June 4, 2024
- Danfoss
Table of Contents
Danfoss DMB Eliminator Hermetic Bi Flow Filter Drier
Refrigerants:
A1: R134a, R404A, R407C, R507, R22, R410A. A2L: R32, R444B, R452B, R454B,
R1234yf. A3: R290, R600a For other refrigerants, please contact Danfoss
representative.
Only solder versions (cu-plated / pure copper) and connection sizes below 25mm
are approved for A3 refrigerants. Only connection sizes below 25 mm are
approved for A2L.
Temperature range:
- 40 70 °C
- 40 160 °F
Max. working pressure:
PS / MWP = 46 bar / 667 psig
Installation
Soldering
After charging, mark the system with the refrigerant and the oil used.
Customer best practice will still be needed:
- Use wet wrap when installing
- Braze the joints.
- Let them cool down.
- Clean the brazing /welding area after the installation (remove remaining flux with a brush).
- This is an important operation and needs to be done with great care to remove all remaining flux.
- Paint / Anti-corrosive needs to cover all open steel parts, areas where the black original paint has been burnt due to brazing and at least 3 cm approx. of the copper.
- Paint the joints twice.
Mounting
Documents / Resources
|
Danfoss DMB Eliminator Hermetic Bi Flow Filter
Drier
[pdf] Installation Guide
DMB, Eliminator Hermetic Bi Flow Filter Drier, DMB Eliminator Hermetic Bi Flow
Filter Drier, DCB
---|---
|
Danfoss DMB Eliminator Hermetic Bi Flow Filter
Drier
[pdf] Installation Guide
DMB, DCB, DMB Eliminator Hermetic Bi Flow Filter Drier, Eliminator Hermetic Bi
Flow Filter Drier, Hermetic Bi Flow Filter Drier, Bi Flow Filter Drier, Flow
Filter Drier, Filter Drier, Drier
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>