OLIGHT RN120 Bicycle Tail Light User Manual
- June 14, 2024
- OLIGHT
Table of Contents
OLIGHT RN120 Bicycle Tail Light
IN THE BOX
SPECIFICATIONS
The tests are performed indoors under a room temperature of 25 degrees Celsius with 25KM/H wind conditions.
HOW TO INSTALL
HOW TO RECHARGE
DANGER
- DO NOT expose the device or batteries to fire, explosion, or other hazards.
- DO NOT disassemble or modify the light or any of the included items.
WARNING
- Keep out of reach of children.
- The light contains a polymer battery. Certain restrictions may apply to this product when traveling, especially when traveling by air. Always check with your carrier for specific restrictions prior to traveling with this product.
NOTICE
- Store the light at room temperature in a dry place. Avoid moisture, or extreme hot or cold.
- Store the light in the charged condition. Avoid “deep discharge”. Battery life will decrease if the light is stored in a fully discharged condition.
- Over time, the run time of the battery will diminish. Expect about 500 full charges, depending on care. After a full life, the battery will continue to charge but with a lower run time.
OPERATION INSTRUCTIONS
- ON/OFF: Press and hold the switch to turn the light on/off. The default output is the last mode when turned off.
- TURN THE BRAKE FUNCTION ON: When the light is off, press and hold the switch for 3s until the light lights up constantly at highest output.
- TURN THE BRAKE FUNCTION OFF: When the light is off, press and hold the switch for 3s until the light keeps flashing quickly at highest output.
- ADJUST BRIGHTNESS: When the light is on, single click the switch to cycle through Low-High-Flash-ECO-Smart-Low…
- MEMORY FUNCTION: When the light is turned on again, it will turn to the last selected lighting mode automatically.
- LOW POWER MODE: When the remaining battery power is low, the switch starts flashing and the lighting mode changes to ECO mode. The brake function is disabled during this period.
*When the brake sensor is on, the taillight will enter sleep mode after 5 minutes of inaction and automatically activated on any vibrations.
When the brake sensor detects braking, the taillight will light up with maximum output.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>